Special repair to Bus Stand at Paonta Sahib Distt. Sirmour HP

Dismantling doors, windows and clerestory windows (steel or wood) shutter including chowkhats, architrave, holdfasts etc. complete and stacking within all lead : Of area beyond 3 sq. metres , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within all leads, , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to IS: 4454 - part 1 and M.S. top cover of required thickness for rolling shutters, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Providing and fixing ball bearing for rolling shutters, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

12 mm (Twelve milimeter) cement plaster of mix : 1:6 (One cement isto Six fine sand), including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

6 mm (Six milimeter)cement plaster of mix : 1:3 (One cement isto Three fine sand), including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Grading roof for water proofing treatment with Cement concrete 1:2:4 (One cement isto Two coarse sand isto Four graded stone aggregate) 20mm (Twenty milimeter) , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Supplying and applying bituminous solution primer on roof and / or wall surface at 0.24 litre per sqm. , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:1½:3 (One Cement isto One and half coarse sand isto Three graded stone aggregate) 20 mm (Twenty milimeter) nominal size) , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. : In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineerin-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Providing and applying white cement based putty of average thickness 1 mm (One milimeter), of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete , including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade : New work (two or more coats) over and including water thinnable priming coat with cement primer, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Painting Steel work with Deluxe Multi Surface Paint to give an even shade. Two or more coat applied @ 0.90 ltr/ 10 sqm over an under coat of primer applied @ 0.80 ltr/ 10 sqm of approved brand and manufacture, including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.

Providing and fixing carbon steel galvanised ( minimum coating 5 (Five) micron) dash fastener of 10 mm (Ten milimeter) dia double threaded 6.8 grade (yield strength 480 N/mm2), counter sunk head, comprising of 10 mm (Ten milimeter) dia polyamide PA 6 grade sleeve, including drilling of hole in frame , concrete/ masonry, etc. as per direction of Engineer-incharge.:- 10 x 60 mm (Ten into Sixty milimeter), including all leads, lifts and carriage of materials, complete in all respect of as per entire satisfaction of the Engineer in charge.