Village Khudai Chak

Amount

Chlorination Plant

Providing, Installing, testing & commissioning one No. Electronically actuated and Chemical Dosing Chlorinator, suitable for delivering 0.5 to 6 Liters of Bleaching Powder solution / Sodium Hypo solution per hour under maximum delivery pressure upto 7 kg.cm2 and suction lift not less than 1.5 m, as per DWSS standard specifications.

Automated Water Controler

Providing, Installing, testing & commissioning one No. Automated water controller switch to start or stop the pump based on water reservoir level. Complete in all respect.

Pipe line

Providing, Stringing out PVC pipes ISI Marked as per ISI-4985 (ISI marked with the prior approval of engineer-in-charges) along the Trenches and laying the same in Trenches To correct alignment and gradients, cutting. Jointing and testing complete as per specifications for more than 3 mtr street width including excavation & specials complete on all respect.

Sluice Valves

Providing & fixing C.I/D.I Flanged end, stem of SS (AIS 1410) and Bronze (gunmetal) working parts Sluice Valves ISI marked 14846-2000, including jointing, testing & cost of Nut, Bolt & insertion sheet, all carriage complete (with the approval of Engineer - in – charge)

Haudi

Construction of masonary Sluice Valve Chamber excluding Sluice Valve cover as per standred design and drawing of public health department.

Size 0.60 X 0.60 Mtr

Provision for Dismantling and restoration of Road cut (Per Meter)

Dismantling Brick or Flanged stone flooring without concrete base as per CSR item No. 8.19 & Dry brick on edge on paving with the dismantled bricks including sand grouting and analysis A-13 complete in all respect.

Provision of New Water Connections on New Proposed Pipeline

Providing proposed water connection to house hold up to wall with providing , laying jointing, testing, MDPE pipe lines 15mm i/d = 4.50 mtr, including cost of specials such as tees, bends, sockets, elbow etc. cutting , threading , and testing in trenches in the ground and ISI marked 15mm i/d GM ferrule as per IS: 2692 and 3" i/d clamp with C.I bib cock 15mm i/d as per IS.210 with stainless steel spindle of approved make as per CSR 30.65 (b) complete.