RESURFACING OF ROAD FROM INDUSTRIAL CANTEEN TO BASTION NO 7 VIA L3, F8 AND DGBG AND FROM BLDG NO 200 TO BLDG NO 504 INSIDE FACTORY AT AFK

Amount

Repairs to pot holes not exc. 1 Sqm each including sweeping free from dust and mud or water, scoring sunken surfaces in roads, paths etc. cutting around edges to at least 25 mm in depth and making good by applying tack coat at 5 kg per 10 Sqm, putting in premixed bituminous macadam, well rammed and sealed with binder 9.8 Kg per 10 Sqm blinded with 0.09 Cum of stone chippings, 6.3mm size and again well rammed (including supplying of premixed macadam, binder and chippings), depth of pot holes exc. 30 mm.

M&L for WBM, 10cm thick (compacted thickness) with granite,trap or basalt of grading 1 (90 to 40mm size), spread, rolled with 8 to 12 tonne power roller and consolidated to gradient and camber required

M &L, Premix bituminous, macadam laid/ rolled and compacted to required gradient and camber with 8 to 12 tonne power roller using paving bitumen binder at 4% by weight of total mix (consolidated thickness 75 mm or more).

Preparing surfaces by brushing with wire brushes for removing caked mud etc. sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc. from black top surfaces and M&L for applying evenly a priming/ tack coat with bituminous primer at 10 kg per 10 Sqm using paving bitumen.

M&L for Bituminous premixed asphaltic concrete 30mm consolidated thickness with 6.00% binder content by weight of Total mix, rolled using 8 to 12 tonne power roller and compacted to required chamber and gradient complete using paving bitumen any penetration.

M&L for preparing bituminous surfaces of road and marking 2.5mm thick centre lines, stop lines, dashes, arrows etc. and the like not exc. 10cm wide on roads pavements with hot applied thermo plastic road marking paint of approved colour confirming to BS 3262-1989 with special applicator machine all as per manufacturers instruction complete all as specified and directed.

Excavation in trenches n. exe 1.5m wide and n. exe 1.5 in depth; for foundation etc . n. exc 10 sqm on plan and n. exe 1.5m depth and getting out in :- Hard/ Dense soil.

M&L for cement concrete, type C2, 1:3:6 (with 40 graded asggregate) in surface channel or drain.

M&L for providing cement concrete 100mm thick type B1,1:2:4 mix (20mm graded aggregete) in floors.

M&L for pre-cast cement concrete block masonry , type C1, 1:3:6 (20mm graded aggregate) with solid blocks, exc. 10 cm in width and setting in cement mortar 1:4, complete.

M&L for providing cement concrete type B1, 1:2:4 mix (20mm graded aggregate) in coping, parapets and railings upto 60cm height and the like including weathering slightly rounded or chamfered angles and throating as directed.

M&L for rendering 15mm thick plaster on fair faces of brick work or concrete surfaces in CM 1:4 including finishing even and smooth without using extra cement.

Removing excavated material exc. 250 m but n exc. 500 m and depositing where directed, soils

Veena Enterprises

V C SHETH