E.T.No.-EDC(USN)48/2025-26

Amount

Annexure-A (LABOUR CHARGES)

Earthing of support with M.S. Earth rod of 2.5 meter long by hammaring of M.S. Rod to proper depth and connecting the earth electrode with the help of G.I. wire as per construction manual..

Fabrication of MS Channel angle iron etc in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESPO schedule and local approved drawing.

Excavation of earth for stay pit of size 0.6x0.6x1.2 mtr in all types of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work.

Fixing, tightening and nozzling of stay with pole and stay rod on required tension as per drawing/manual in LT line

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement, sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO Manual.

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all types of soil including proper dressing of sides and ramming of bottom including etting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of SP-23 single support pole in proper level and alignment along with fixing of all accessories like top channel & clamps as per RESPO manual

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement:4 graded stone20 mm niminal size: 8 coarse sand) block including cost of cement, sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, levelling as per RESPO cnstruction manual

Muffing of poles size 0.45x0.60 cm radius with 1:3:6 (1 cement:3 coarse sand :graded stone 10 mm nominal size) block size 45 cm height from ground level including cost of cement,stone and sand etc

Painting of SP-23 pole with angle and channel and all steel part by one coat of Red Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level.

Laying and erection of L.T. PVC Cable including crimping of lugs of size 1x70,120, 150 Sq.mm. (Including all cost of material)

Fixing of D type bracket on LT line.

Cartage of ST pole SP-23 Poles from store centre to construction site with loading, unloading at both points and proper stacking.(Distance 51-70 Km)

Cartage of other material (other than poles) by vehicle from Store Center to nearest construction site Store including loading and unloading at both ends(distance 51-70 Km)

Headload cartage of ST Pole SP-23 from road to site (distance 0-1 Km)

Head load cartage of small material (distance 0-1 Km)

Laying, Sagging & binding of AB cable of size 120 sqmm. (Only for cable, additional provisions to be made for matching accessories installation, case of any network modification i.e additional pole etc. and for actual connection, disonnection as per site condition.

Road Cutting with the help of JCB/Pokland and repairing of road after work as per specification of PWD.

Disconnection & Reconnection of consumer.

Fixing of Dead End Clamp

Fixing of Suspension Clamp with I Hook.

Fixing of IPC with Al. Bail for Earthing.

Erection of Stay Clamp.

Annexure-B (SUPPLY ITEMS) (As per UPCL Specifications)

Supply of stay clamp SP-23 with Nut & Bolt.

Supply of suspension clamp with eye hook LT AB Cable

Supply of MS Clamp with N&B for Distribution Box.

Supply of MS Clamp for Dead End Clamp with N&B.

Supply of Dead End Clamp with I Hook

Supply of Stay Insulator

Supply of Share head type Insulated piercing connector body molded from high quality mechanical climate and UV resistant glass reinforced polyamide, hot dipped galvanized bolts & contact teeth ABC size 125 sqmm to 25 Sqmm

Supply of LT Bare N. connector PG Clamp 95-25 Sq.MM

Supply of IPC ofr 120 Sq.MM to 120 Sq.MM

Supply of MS Clamp with N&B for Suspension Clamp.

Supply of LT Bare N. connector PG Clamp for Line to Line 95-95 Sq.MM.

Supply of connecting Cable AB Cable to DB 1x25 Sq.MM

Supply of SMC Three Phase L.T. Distribution Box with inbuilt panal lock, Al bus bar RYB 25x6mm., Al Busbar N. 40x6mm. for connection of L.T. consumer (Sintex make or other ISI mark reputed company ) with Panel Lock with key)

Supply of Aluminium Lug 25 Sq.mm

M/S J K ELECTRICALS (BID ID -412919)

MANRAJ ELECTRICAL & INFRASTRUCTURE (BID ID -412990)