E-Tender No.69/EDC(S)/2024-25

Amount

Material

Cross arm clamp for SP-23 Pole

IPC with Al bail for earthing

33 kv suspension cable ties for insulator

11 kv IPC for covered to covered conductor

11 kv IPC for covered to Bare conductor

11 kv mid span jointing kit

Supply af 11 KV AAAC, AL 59 (99 sqmm Covered Conductor)

11 kv tension with bail & IPC

Labour

Cartage of material from store centre to nearest road site with loading, unloading at both points. (Loading, unloading plus carriage per pole) (0 to 200 km).

ST Pole SP-23

Cartage of other material by vehicle from store centre to nearest road site including loading and unloading at both ends. (0 to 200 km).

Head load of material Poles from store centre to nearest road site with loading, unloading at both points. (Loading, unloading plus carriage per pole) (0 to 2 km).

ST Pole SP-23

Head load cartage of small material by vehicle from store centre to nearest road site including loading and unloading at both ends. (0 to 2 km).

Excavation of earth for pole pit of size 0.9X0.9X1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work.

Grouting of pole in size 0.45X0.45X1/9 of the support in CC ratio 1:4:8 (1 cement:4graded stone 20mm nominal size:8coarse sand) block including cost of cement, sand and stone ballast back filling of soil and boulders back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO construction manual.

Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories (STP SP-23).

Proper Alignment of Tilted Poles

Jumpering and connection of Section Pole

painting of Poles with angle and channel and all steel part by one coat red oxide primer and two coats of aluminium paint and two strip of flourescent alternate red and white paint 30 Cm wide and 1.5 Mtrs from ground level

Fabrication of MS Chanel and angle

Removing of old conductor with opening of binding,jumpering,and making of bundle with carriage from pit site to JE store including loading/unloading Complete work.

Laying,Spreading, Stringing and sagging of 11 KV Line in 3-phase of the following wire as phase wire including proper sagging l with binding and jumpering as per user manual and sagging chart. As per EN 50397 Part3.

11 KV ACS AL-59 Covered Conductor (99sqmm)

Fixing of MVCC Accessories

11KV 90 KN Tension clamp with Bail and IPC.

11KV Suspension cable ties.

11Kv IPC for CC to CC Connection.

11Kv IPC for CC to Bare Connection.

11KV Mid Span Jointing Kit.

Fixing of IPC with Aluminium bail for earthing .

fixing of cross arm clamp for SP-23 Pole

Muffing of Poles

Fixing of Disc insulator with fitting

Fixing of 11 KV Pin Insulator

Fixing of stay set

Chemical earthing of Pole

Providing and fixing Danger Board

Providing and fixing of anti climbing device

Reconnection of consumers

Head load cartage of dismantled old ACSR weasel conductor from work site to road site

Back cartage of dismantled of old weasel conductor from JE Store to central store 0-275

Excavation of earth for stay

Grouting of stay

M/s S S ENTERPRISES (BID ID -362815)

DHRUV ENTERPRISES (BID ID -362473)