169/22Construction of shed for non bio degradable waste

Amount

Fabricating and fixing non bio degradable waste material collection unit at different junctions. (24 nos)

2.8.1 : Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.5 : Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size)

50.10.1 : Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

od1298792/2021_2022 : Providing and fixing hard drawn steel wire fabric 75x25 mm mesh of weight not less than 7.75 Kg per sqm to iron frames etc. and priming coat with approved steel primer all complete.(Modified item no.9.50 of DSR excluding wood item and labour for wood work)

51.20 : Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.35 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5- 7 microns epoxy primer on both side. of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

13.61.1 : Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work

10.19 : Providing and fixing mild steel round holding down bolts with nuts and washer plates complete.

13.71 : Lettering with black Japan pint of approved brand and manufacture

od1301933/2021_2022 : Supplying and fixing 40mm brass pad lock of approved quality etc. complete.

od1301938/2021_2022 : Supplying and fixing M.S. pressed butt hinges bright finished of required size for iron door<br>

KODIMOOTTIL INDUSTREIS

SHANAVAS.H

K R RAJEEV

MANIKUTTAN V

SUDARSANAN V

Bidder Name

K R RAJEEV

SUDARSANAN V

SHANAVAS.H

KODIMOOTTIL INDUSTREIS

MANIKUTTAN V

SHAIJU S