Annual Plan-Iritty Block Panchayat Project no. 74/2025- 26-Drinking Water Project near Palathukadavu Tomikada Ayyankunnu Grama Panchayat

bore well

OD343769/2025-2026:Drilling bore of suitable size to accommodate well casing pipe of internal dia not less than 150mm for various strata up to 150 M below the ground level having an avarage 40 M overburden in all classes of soil and rock. inclusive of hire charges for machinery and all other accessories and storage putting up on temporary shed and storin equipment's, cost of fuel, oil and other incidental items to complete the work but excluding the cost of casing pipe etc . complete.

OD343765/2025-2026: Supply and erection of 180mm (6Kg/cm2) or above dia PVC casing pipe (ISI marked) and labour charges of conveyance to site etc.

OD343762/2025-2026:Supply and erection of GI Saddle clamp (ISI marked) and labour charges of conveyance to site etc.

OD343763/2025-2026:Supply and fixing 180mm dia PVC end cap including cost, overhead charges etc. complete

OD343759/2025-2026:supplying and erecting centrifugal pump pump set for 1Hp=0.75kwh including cost of pump,motor,panel board,starter,capacitor, suction pipe for a length of 10m, foot valve, and testing etc complete

OD343760/2025-2026:Supply and erection of 4 mm electric cable for bore well pump set

OD343761/2025-2026:Providing and fixing HDPE pipes including jointing of pipes with as per slandered and testing of joints complete as per direction of Engineer in Charge. 40 mm dia 12.5 Kgf/ cm2

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-in-charge.All kinds of soil

4.1.2:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:1½:3 (1 Cement: 1½ coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources)

10.1:Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

9.133.2.1:Providing and fixing, in position concealed G.I. section for wall paneling using board of required thickness fixed on the 'W' profile (0.55 mm thick) having a knurled web of 51.55 mm and two flanges of 26 mm each with lips of 10.55 mm, placed @ 610 mm C/C in perimeter channel having one flange of 20 mm and another flange of 30 mm with thickness of 0.55 mm and web of length 27 mm. Perimeter channel is fixed on the floor and the ceiling with the nylon sleeves @ 610 mm C/C with fully threaded self-tapping dry wall screws. Board is fixed to the 'W' profile with 25 mm countersunk ribbed head screws @ 200 mm C/C., all complete as per the drawing & directions of engineer-in-charge, the joints of the boards are finished with specially formulated jointing compound and 48 mm wide jointing tape to provide seamless finish.8 mm thick cement fibre board as per IS : 14862

12.50:Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

18.48:Providing and placing on terrace (at all floor levels) polyethylene water storage tank :ISI 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank.

50.18.9.13.2:Providing and fixing PVC pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step PVC solvent cement and testing of joints complete as per direction of Engineer-in-Charge 25 mm dia 10 Kgf/cm2- External work - Exposed on wall

50.18.9.15.1:Providing and fixing PVC pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step PVC solvent cement and testing of joints complete as per direction of Engineer-in-Charge 40 mm dia 10Kgf/cm2- External work- Exposed on wall

OD343764/2025-2026:Providing and fixing PVC gate valve with long handle of approved quality (screwed end) :50 mm nominal bore (derived from Spec 18.17.4)

OD343766/2025-2026:Supply and erection of PVC rope for submersible motor including labour charges of conveyance to site etc.

OD343767/2025-2026:Providing and fixing granite name board in LM masonry

Please Enable Macros to View BoQ information