Providing Aluminium Doors and Partitions for Computer Lab, Library, 3D Lab, CNC Lab at Dr. YSR Architecture and Fine Arts University, Kadapa

Supply & fixing of Rolling shutter made of 80 x 1.25 mm machine rolled CRCA laths, interlocked together through their entire length and jointed together at the ends by end-locks, mounted on specially designed pipe shaft of 50mm dia nominal bore MS B class pipe with brackets, plates, guide channels, stoppers, bottom locking plates and arrangements for inside & outside locking with push-pull operations including cost of hood cover and springs complete, painted with one coat of approved steel primer, locks, ball bearings, all accessories etc., complete for finished item of work as per special spn: 1108

Supply and fixing of Aluminum Partition using standard powder coated/ anodised aluminum section of double grove of size 63.50mm x 38.10mm x 1.21 mm thick / single grove of size 63.50mm x 38.10mm x 1.31 mm thick and door sections verticle and Top sections 47.62X44.45X1.35mm, door middle section 83.50X44.45X1.28mm and door bottom section 104.00x44.50x1.80mm thick and Prelaminated partical board 12mm thick and 5mm thick plain float glass fitted with suitable Aluminum glazing clips including godrej lock and handles, door handles, tower bolts and door stopers and approved brand silicon sealant including cost and conveyance of all materials labour charges for manufacturing fixing in position using wooden blocks and sheet metal screw etc. to complete for finished item of work as approved by Engineer-in-charge complete as per drawing

Providing and fixing Aluminium Extruded Section Body Tubular Type Hydraulic Door Closer (IS: 3564) with double speed adjustment with necessary accessories and screws etc. complete(Type-3: for width of doors 851 to 1000 mm) etc., Complete for finished item of work.

Providing and Fixing Structural Glazing fabricated from Roll formed sections made of Pre-painted Steel / Powder coated (Base steel as per IS 513 of ‘D’ quality, galvanized as per IS 277 with Zinc of 120 Gm/sqm) with total coated thickness of 0.72mm. The glass holding section made of 304 grade stainless steel of 0.6mm thick as per the design requirement & calculations as given in IS: 875. Primer coat with epoxy primer of 5 – 7 microns thick, finish painted with a polyester paint of 12-16 microns thick and back coated with Alkyd backer of 5-7 microns or powder coated with pure polyester powder up to 50-60 microns thick. The vertical section should be of 50mm x100mm x 0.72mm, 33mm x 58mm x 0.72mm for frame horizontal section, stiffener section should be 48mm x 98mm x 1mm, cover profiles sections should be of 20mm x 58mm x 0.58mm, Glass holding section should be of 37mm x 37mm & 37mm x 18mm. Including 5mm thick Ocean Blue reflective glass. Brackets made of CRCA powder coated/Electroplated should be used to connect vertical to horizontal, vertical to slab, to fix verticals at top & bottom as per site requirement Gasket made of Ethyl Propylene Diamine Monomer. Natural cure, with Good U.V. Resistance Silicon to be used. Wall fixing of sections to concrete/masonry wall should be with self-expanding cap & screws. The rate is inclusive of cost and conveyance of all materials to site, all labour charges, incidental charges, cost of all consumables etc. and scaffolding charges, form work , etc., complete for finished item of work in all floors.

Supply and fixing of 12mm thick plain flaoted glass to Partations, windows, ventilators and doors including cost and convayance of all necessary material labor charges fabrication and fixing charges complete for finished item of work