Repairing of P.W.D Store at Dharasana Ta. Dist. Valsad (Civil Work, Compound Wall and Misc. Work)

Name of Work :-

Repairing of P.W.D Store at Dharasana Ta. Dist. Valsad (Civil Work, Compound Wall and Misc. Work)

Bill of Quantities

(A) Percentage Rate Tender (Up to INR 50 Cr. )

Memorandum showing items of work to be carried out

Ite Quantity Unit Estimated Total Amount

Ite Quantity Unit Estimated Total Amount

No. Item of work In figure estimated

Rs. Ps. quantities

1 Excavation for foundation upto 1.50 mt depth including sorting out and 183.0 Cumt 117.08

stacking of useful materials and disposing the excavated stuff all lead

& lift(A) Loose or soft soil.

2 Excavation for foundation 1.50 mt to 3.00 mt depth including sorting out 41.00 Cumt 162.38

and stacking of useful materials and disposing the excavated stuff upto

50 mt lead (B) Dense or hard soil

3 Providing and laying controlled cement concrete M.150 and curing 9.00 Cumt 3894.07

complete including the cost of formwork but excluding the cost of

reinforcement for reinforced concrete work in (A) Foundations and plinth

4 Providing and laying controlled cement concrete M.250 and curing 14.00 Cumt 4819.72

complete excluding the cost of formwork and reinforcement for

reinforced concrete work in (A) Foundations, footings, Base of columns

and Mass concrete.

5 Providing and laying controlled cement concrete M-250 and curing 5.00 Cumt 8009.30

complete including the cost of form work but excluding the cost of

reinforcement for reinforced concrete work in (d) columns Up to Plinth

6 Providing and laying controlled cement concrete M-200 and curing 11.00 Cumt 7898.20

complete including the cost of form work but excluding the cost of

reinforcement for reinforced concrete work in Columns, pillars posts and

struts Ground FLOOR

7 Filling available excavated Earth (Excluding Rock) in trench plinth side of 189.00 Cumt 130.39

foundation . in layer not excluding 20 cm in depth consolidation each

deposited layer by ramming and watering etc. complete

8 Providing and laying controlled cement concrete M-250 and curing 8.00 Cumt 5900.42

complete including the cost of form work but excluding the cost of

reinforcement for reinforced concrete work in Ground & Plinth BEAMS

9 Brick work using common burnt clay building bricks crushing strength not 71.00 Cumt 4295.99

less than 35 Kg/Sq.cm. in super structure above plinth level upto floor

two level in cement mortar 1:6 (1cement : 6 fine sand) (B) Conventional

For Ground Floor

10 Providing and laying controlled cement concrete M-200 for RCC work 6.00 Cumt 6523.59

and curing complete including the cost of form work but excluding the

cost of reinforcement for reinforced concrete work in coping on Ground

11 Providing TMT Bar FE 500D reinforcement for R.C.C. work including 5600.00 KG 76.27

bending, binding and placing in position complete up to All floor Level

12 20 mm Thick sand faced cement plaster on walls upto height 10 meters 672.00 Sqmt 300.66

above ground level consisting of 12 mm Thick backing coat of c.m. 1:3 (1

cement : 3 sand) and 8 mm Thick finishing coat of c.m. 1:1 (1 cement :

sand) with 18mm wide x10mm deep Groves at juction of structure

member etc. complete.

13 Wall Painting (Two coats) with weather proof acraylic emulsion (Apex or 672.00 Sqmt 114.53

equivalent type) paint of approved brand and manufacture and of

required shade on exterior wall surface to give an even shade over and

including primery coat with Alkaly resistance primer of approved brand

after thoroughly brushing surface to remove all dust and remains of

loose powdered material etc. copm. for all height

14 Constructing,Providing and Fabricating cattle trap using channel section 10.50 Sqmt 5244.93

frame of size ISMC series 100m x 50 mm (Weight 9.20 kg/Rmt) and ISMC

I Section 100 mm x 75mm (Weight 11.50 kg/Rmt) 1mt C/C Intermediate

Support for welding G.I. Pipe at 12 cm of size 50mm dia Heavy duty in a

frame made of channel section of 100mm x 50mm all round including

fixing the urit on prepared chamber of masonary wall using MS hold fast

embeded in masnary wall top as directed by Engineer in charge as per

drawing by necessary arrangement etc.complete.

15 Providing and fixing decorative entrance gate made out of cast iron and 945.00 KG 172.71

various mild steel tabular section combination , the Ornamental entrance

gate should be fixed at compound wall including pattern and die making

cutting , welding , grinding, fabrication , fixing in position at compound

wall with necessary pedestal, bearing block and other locking

arrangement. The entrance gate should be painted with two coats of

priming coat of paint, and two coat of oil paint etc complete. As per detail

design and instruction of architect.

16 Providing and fixing concertina coil fencing with punched tape concertina 160.00 Rmt 359.56

coil 600 mm dia 10 mt openable length having 50 no rounds per 6 mt

length, upto 3mt height of wall with existing angle iron (50mm x50mm

x5mm )requird shaped As per Directed Engeenier in charge. placed 2.4mt

or 3.00mt apart and with 4 horizontal R.B.T. reinforced barbed wire(3

mm) , stud tied with G.I. staples and G.I. clips to retain horizontal,

including necessary bolts or G.I.barbed wire tied to angle iron, all

complete as per direction of Engineer-in-charge, with reinforced barbed

tape (R.B.T.)/Spring core (2.5 mm thick) and weight 43.478 gm/meter at

compound wall for ESR M4/ intakewell.

In Words Sixteen Lakh Fifty Five Thousand Four Hundred Forty One Rupees And Eighty Five Paisa Only.

I/We am /are willing to carry out the work at…………% above/below percent (should be written in figures and words) at the

estimated rates mentioned above amount of my/your tender works out as under.

*Estimated Amount *Estimated Amount

put to Tender Rs. 1655441.85 put to Tender Rs.

Deduction …………….. % below………………… Add ………… % above Rs. …………….

1 The Contractor shall be exhibit board as per government circular No.BDG/3277/1657 N dated 26/01/1997 S (M.GUJ) with

detailed specification and details of work and amount Involved at site without any payment as directed by Engineer-In-

2 All work shall be carried out as per public work department hand book and other specifications of Division or as directed.

3 All columns in the Schedule should be filled in ink & the total of the entries in the last column should be struck by Contractor

under his sign.

4 Rates quoted include clearance of site (Prior commencement of work and its close) in all respects and hold good for work

under all condition, site, moisture/ weather etc.

5 The Boards stating the detailed specification & detailes of Work shal be provided by the contractor as per Government

Resolution T.No.1890-240- Dtd.18/11/1990 and directed by contractor at his own cost immediately on recommanding the

6 Testing of Material Shall be done as per the statement attached with specification,The material IS Tested in GERI by

Executive Engineer Surat and Bill for the testing charges shall be paid by Executive Engineer,1% of the Amount put to

7 1% of the Construction Cost Shall be deducted from the bill Amount of the contract as per the Buildig and other

Construction works walfare cess at 1996(Labour and Employment Department Letter No CWA-2004-1831-M(3)Dated

9/12/2005 notification Of Labour & Employment department dt.03/01/2005 & Labou & Employment Department Letter no

8 In Case of RCC items Where there is a change in Grade of Mix or Change as per Actual Mix design the cost of difference of

Cement Difference shall be deducted from the rate of original item at the rate of star rate mentioned in the tender.

9 Contractor are advised to visit site before loading tender rate.

10 Necessary wiring point and drainage point are installed at Site however any modification in electrical installation and

drainage & water supply connection and minor correction to perform experienced in Lab shall be done by contractor at his

11 The Rates are inclusive of all the taxes (Excluding GST),Transport Charges,Octroi duty and storage Charges up to date.

12 The materials Covered for wiring should be got approved from the Engineer Incharge of the work.

13 GST and Income tax TDS will be deducted at a source while making payments of bills.

14 GST will be paid extra as per Govt. amendment.

15 The Materials on the work shall have to be used and carried out as specified in technical note.

I/We hereby Declare that I/we have Visited the site and fully Exquisite myself/ourselves with the local situation regarding

(A) materials,Labour and other factors pertaininfg to work before submitting tender.

I/We hereby Declare that I/we have carefully Studied the condition of Contracts,Detailed Specification and other tender

Document of this work and agree to execute the same accordingly.

Deputy Executive Engineer

Valsad (R&B) Sub-Division

Signature of Bidder

Executive Engineer

Valsad (R&B) Division