Construction of composite office building G 3 for consumer affairs Department at Berhampore in the district of Murshidabad SITC of Fire Detection system.

Amount

Supply, Installation, testing & commissioning ofmicroprocesser base intelligentaddressable 2ioopfire alarm pannel(VD/UL/FM/PEC approved)fully networkabloe with eacc loop capable of taking 120 ndevice extended upto double capacity , 1/4 VGAdisply character alphanumeric liquid crystal display.The panel should be soft addressable type.The panel should be capable to give pin point location of all fire /fault condition..Further the panel should beabe to automatic switch offrespective control switch when everyalarm istriggered.The panel should be able to store sufficient no of log eventin its memory as per recommended standarad.The panel shall have inbuilt rectifier provision for external &internal printer(if required) loop cards , LCD unit to indicate fire /fault signal with address and analog output, complete in all respect , in built surge protection facitities, integral SMF lead acid battery with sealed shell of 24 V capable of running for 24 hours normal working and then be capable of perating system for 30 minutes during emergency condition, with integral battery charger complete as required..The TACP shall be capable of being network ( future expansion0with other similarrFACP located at the different pat of the primisses through single RS 465 Bus The FACP shall have provision of interfacing with PAS and BMS(RS485). The panel should have modbus output &ready to communicate withremote computer .Thesystem must be preloaded with ecenec software.

Supply, Installation, Testing & Commissioningof analog addressable intelligent multisensor detector (VDS/UL/FM/ULC approved)with inbuilt optical smoke sensor with heat detector sensorwith decentralised intelligent soft addressable photosensor typ with inbuilt fault isolator as per NFPA style 7 wiring complete with base IP protectionas per recommended standard.( note: Detector with out in built isolator is also capable but suchcase cotactorshall proviveone independent fault isolatormodulefor every group of addressable devicefroupwill be as per latest recommended standardwith out any additional costCe. ( Approved Make: Honeywell/ESSER/Siemens/Secutron/ Notifer / Edward / Bosch / Apollo / Morley / System Sensor /Johnson Controls/Cerberus Pro/Esser ).

Supply ,installation, testing and commissioning of MANUAL CALL POINT (VD/UL/FM/ULC approved) soft addressable type with inbuilt fault isolator as per NfPA stylewiring complete as required. ( Approved Make: Honeywell/ESSER/Siemens/Secutron/ Notifer / Edward / Bosch / Apollo / Morley / System Sensor /Johnson Controls/Cerberus Pro/Esser ).

Supply, installation, testing and commissioning of Hooter Cum Strobe(sound output of minimum 90db )complete with all accessories complete of approved band and make as per specification and direction of Engineer-in-charge. ( Approved Make: Honeywell/ESSER/Siemens/Secutron/ Notifer / Edward / Bosch / Apollo / Morley / System Sensor /Johnson Controls/Cerberus Pro/Esser ).

Supply, installation, testing and commissioning of Monitor modules (VDS/UL/FM/ULC approved)for monitoring flow switches /fire exit doors/AHU/Lift etc complete as required. ( Approved Make: Honeywell/ESSER/Siemens/Secutron/ Notifer / Edward / Bosch / Apollo / Morley / System Sensor /Johnson Controls/Cerberus Pro/Esser ).

Supply and laying of 2core 1.5 sq.mm. FRLS shielded copper cable. (Make-Finolex/Polycab/Havells/KEI) with 20mm NB PVC rigid conduit pipe on the surface of the wall.

Athe fire detection system consist of latest requirement of 1 National fFire protection Association Standard 2.IS 2189 3.NFPA72 fire alarm code4.Local statutory code .5 Manufacture recommendetion. .QUICKBROWNFOXJUMPSRIGHTOVERTHELEASYDOG

Test - the fire alarm system should be theted and commissined by qualified , trainned engineer or technician authorised by the manufacturer of fire alarm equipment supervised and partiticipate duringadjusment and test.2 before energing and testing wire and cable should be properlt check for any kind of short circuit, ground fault, continuty and other test as required.

Trams & condition

The agency must procure the material from the Manufacturer/OEMor r their authorise sales channel so that the standard warranty or support of the Manufacturer/OEM become applicable to the product to the delivered and installed by them

ADocuments that authenticatesuch procurement from the Manufacturer/OEMor from their authorised sales channel and standard warranty /supportshould be send from the email of the Manufacturer/ OEMor authorised sales channelto the email of the Engineer -In -Chargeand hard copy to be submittedduring executionof work/submission of bill. If any refurbished materialis supplied and installed penal action will be taken as per existing rule.

MAM ENTERPRISE

ASSOCIATED ELECTRICAL CONST CO. 1963 PVT.LTD