Construction of Steel Foot Bridge across Badagara Mahe Canal at Thillerithazhe near Ch.456.480 Km

Amount

CONSTRUCTION OF FOOT BRIDGE

od12040/2018_2019/IA : Forming island of 10 m x 5m size at ana average height of 3.5 m etc. for fixing ,staging platform and other apllainces necessary for pile drving using 150mm to 200 mm dia casuarina poles driven into the ground below bed level vertically at 1 m c/c with wailing pieces, struts and bamboo bracing at 60 cm c/c ,screening with cocunut cadjan madals and earthfilling inside etc. including all cost conveyance labour and all other incidental charges and dismantling the same as per standard specifications etc complete as per the direction of the Departmental Engineer in charge.

60.2.2 : Bailing out water Using 5HP Pump- Bailing out water with 5HP engine and pump set including conveyance to site and erection,cost of fuel, lubrication oil and other stores, pay of staff etc complete as per the direction of Departmental Engineer in Charge.

2.6.1 : Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil etc complete as per the direction of Departmental Engineer in Charge.

od18481/2018_2019/IA : Providing Steel Liner 6 mm thick for Steining of Wells including Fabricating and Setting out as per Detailed Drawing for piles (As per Morth Data 12.22) etc complete as per the direction of Departmental Engineer in Charge.

od18483/2018_2019/IA : Bored cast-in-situ M25 grade R.C.C. Pile Using Batching Plant, Transit Mixer and Concrete Pump excluding Reinforcement complete as per Drawing and Technical Specifications and removal of excavated earth with all lifts and lead upto 1000 m.r|nPile diameter-700 mm r|n(Length of pile for payment shall be measured upto bottom of pile cap) etc complete as per the direction of Departmental Engineer in Charge.

od18484/2018_2019/IA : Bored cast-in-situ M25 grade R.C.C. Pile Using Batching Plant, Transit Mixer and Concrete Pump excluding Reinforcement complete as per Drawing and Technical Specifications and removal of excavated earth with all lifts and lead upto 1000 m.r|nPile diameter-500 mm r|n (Length of pile for payment shall be measured upto bottom of pile cap) etc complete as per the direction of Departmental Engineer in Charge.

5.22.6 : Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more etc complete as per the direction of Departmental Engineer in Charge.

od9896/2019_2020/IA : Chipping and removing extra length of RCC piles-Demolishing R.C.C. work manually / by mechanical means including stacking of steel bars and disposal of unserviceable material with in 50 metres lead etc complete as per the direction of Departmental Engineer in Charge.

20.6.2.2 : Vertical load testing of piles in accordance with IS 2911( Part IV) including installation of loading platform and preparation of pile head or construction of test cap and dismantling of test cap after test etc. complete as per specification & the direction of engineer -in-Charge.Single pile above 50 tonne and upto 100 tonne capacity Routine test etc complete as per the direction of Departmental Engineer in Charge.

4.1.8 : Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size) etc complete as per the direction of Departmental Engineer in Charge.

od12043/2018_2019/IA : Providing and laying in position machine batched and machine mixed design mix M-25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability etc complete as per the direction of the Departmental Engineer in charge..( Note:- Cement content considered in this item is @ 330 kg/ cum. Less cement used as per design mix is recoverable separately).All work upto plinth level

od12044/2018_2019/IA : Providing and laying in position machine batched and machine mixed design mix M-25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of laying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability etc complete as per the direction of the Departmental Engineer in charge.( Note:- Cement content considered in this item is @ 330 kg/ cum. Less cement used as per design mix is recoverable separately).All work above plinth level upto floor V level

5.1.2 : Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size etc complete as per the direction of the Departmental Engineer in charge.

4.3.1 : Centering and shuttering including strutting, propping etc. and removal of form work for:Foundations, footings, bases for columns etc complete as per the direction of the Departmental Engineer in charge.

4.3.3 : Centering and shuttering including strutting, propping etc. and removal of form work for:Columns, piers, abutments, pillars, posts and struts etc complete as per the direction of the Departmental Engineer in charge.

4.3.2 : Centering and shuttering including strutting, propping etc. and removal of form work for:Retaining walls, return walls, (any thickness) including attached pilasters, buttresses, plinth and string courses fillets, kerbs and steps etc complete as per the direction of the Departmental Engineer in charge.

13.23.1 : Extra for plastering on circular work not exceeding 6 m in radius.In one coat etc complete as per the direction of the Departmental Engineer in charge.

13.7.1 : 12 mm cement plaster finished with a floating coat of neat cement of mix:1:3 ( 1 cement : 3 fine sand) etc complete as per the direction of the Departmental Engineer in charge.

13.43.1 : Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface:Water thinnable cement primer etc complete as per the direction of the Departmental Engineer in charge.

13.51.2 : Painting with silicon & acrylic emulsion based water thinnable sealer of approved brand and manufacture on wet or patchy portion of plastered surfaces:Two coats etc complete as per the direction of the Departmental Engineer in charge.

od12045/2018_2019/IA : Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position all etc complete as per the direction of the Departmental Engineer in charge.

10.22 : Welding by gas or electric plant including transportation of plant at site etc complete as per the direction of the Departmental Engineer in charge.

10.20 : Providing and fixing bolts including nuts and washers etc complete as per the direction of the Departmental Engineer in charge.

od12046/2018_2019/IA : Erection of newly fabricated steel bridge by lifting and leading to the riverbank,leading the one end of the steel bridge through the river by using pontoon,lifting the steel bridge to the pier in proper alignment including cost of labours,hire charges of heavy duty mobile crane etc complete as per the direction of the Departmental Engineer in charge.

11.20.3 : Chequerred precast cement concrete tiles 22 mm thick in footpath & courtyard, jointed with neat cement slurry mixed with pigment to match the shade of tiles, including rubbing and cleaning etc. complete on 20 mm thick bed of cement mortar 1:4 ( 1 cement : 4 coarse sand).Dark shade pigment using ordinary cement etc complete as per the direction of the Departmental Engineer in charge.

85.115 : Cost of painting with 2 coats of enamel paint over 1 coat of zinchromate primer as per IS1477:1994 after hand and power tool cleaning including cost of all materials, labour charges, cost of testing all painting materials, all incidental charges, hire of T&P etc complete as per the direction of the Departmental Engineer in charge.

60.7.4 : DR PACKING FOR APRONS - Rough stone dry packing for apron with good quality blasted rubble including packing to compactness to lines levels, cost and conveyance of all materials labour charges etc complete as per the direction of the Departmental Engineer in charge.

KERALA ELECTRICAL AND ALLIED ENGG CO LTD

Muhayuddeen koya M

T.ASOKAN

Bidder Name

T.ASOKAN

KERALA ELECTRICAL AND ALLIED ENGG CO LTD

Muhayuddeen koya M

ABDUL SHUKOOR.V