CA NO GE SOUTH AMB 51 2024 2025 CERTAIN MISC REPAIR TO FOOTPATH AND AREA DRAINAGE AT C 2 SECTOR OF AGE BRI SOUTH UNDER GE SOUTH AMBALA CANTT

Amount

Excavation in trenches in soft/loose soil not exceeding 1.50 metre wide and not exceeding 1.50 metre deep for foundation ,cesspit ,drain etc and getting out complete, all as specified.

Demolition of Brickwork or stone/ boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed by Engr-in-Charge.

Material and Labour for Plain cement concrete (1:4:8) type D-2 using 40 mm graded stone agg as in foundation filling and mass concrete all as specified.

Material and Labour Brick work with sub class 'B' old size bricks of class designation 100, straight or curved on plan exceeding 6.00 mtr mean radius built in cement mortar (1:4), complete all as specified.

Material and labour for brick work built in CM (1:6) straight or curved on plan exceeding 6 metre mean radius using sub class ‘B’ bricks but except bricks, complete all as specified and as directed.

Material and Labour for providing PCC 1:2:4 type B-1 (20mm graded stone aggregate )as in coping/ benching etc including necessary form work complete all as specified and directed.

Material and Labour for Flush pointing to brick wall in CM 1:3, complete all as specified.

Material and Labour for cement concrete 1:2:4 type B-1 using 20 mm graded stone aggregate as in surface channel complete all as specified.

Removing excavated soil to a distance not exceeding 50 mtr and depositing where directed at a level n.exc 1.5 mtr above the starting point complete all as specified.

Returning filling in, including spreading, leveling, watering and well ramming in layers not exceeding 25cm thick each, excavated soil in trenches complete, all as specified.

Demolition of Cement Concrete (reinforced) and (reinforcement cut as required to facilitate demolition) as in roofs, floors (other than ground floors) beams, slabs, staircases, landing, chajjas and similar suspended work complete all as specified and directed by Engineer-in-Charge.

Material and Labour for Re-inforced Cement Concrete (Design Mix) Type B0 1:2:4 (12.5mm graded aggregate) as in slabs supported on walls, beams and columns etc complete all as specified and directed.

Material and Labour for rough finished form work to soffits of suspended slab such as roof slabs,floor slabs,landings and similar work not exceeding 200mm thick (Horizontal or Sloping) complete all as specified and directed.

Material and Labour for rough finished form work to edges of concrete flats,treads,break in floors window cills,concrete railings,openings in concrete walls , floor and roofs n exc 20 wide and sides of RCC/PCC bands in walls ,horizontals or sloping and similar work exc 10cm but n exc 20 cm wide complete all as specified and direced.

Mild steel TMT bar 10 mm dia and over cut to length bent to shape required including cranking bending spirally for hoping for columns, hooking ends and binding with and including MS wire (annealed) not less that 0.9mm dia complete all as specified.

Demolition of lime concrete or cement concrete of any description in ground floor and pavings n exc 15 cm thickness (below or above ground level) complete all as specified and directed.

Material and Labour for Hard core of broken stone or boulders gauge n exc 63mm deposited, spread and levelled in layers n exc 15cm thick, watered and rammed to a true surface, complete all as specified and directed

Material and Labour for 75mm thick cement concrete type D-2, 1:4:8 (40 mm graded aggregate) as in sub base complete all as specified.

Material and labour for providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness and size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified as directed.

Material and labour for providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-40 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand; complete all as specified as directed

Material and Labour for providing cement concrete 1:2:4 type B-1 using 20 mm graded stone aggregate as in copings, slightly, rounded or chamfered angles complete all as specified as directed.

Material and Labour for providing pre cast cement concrete 1:2:4 type B-1 using 20 mm graded crushed stone aggregate as in coping,knees, apex stone, Kerb stone ,column, fencing post ,door cills,deck slab, pre cast slab etc and like this set in cm(1:4) complete all as specified.

Supply and fixing PVC (SWR) 110 mm pipe type A single socket in any length with rubber ring joints laid in trenches including dismantling of existing pipes of any description any length complete all as specified and as directed.

Supply and fixing 100mm dia stack clamps made out of 50mm by 5mm flat iron and 16mm dia around iron stays,including bolts and nuts and securing ends of stays to wall or roof complete all as specified and directed.

Taking down cement plaster on brick or stone walls or concrete surfaces, etc. including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed by Engineer-in-charge.

Material and labour for 15mm thick rendering in cement mortar (1:4) on surface of any description of brick or concrete and finished the surface even and smooth without using extra cement with and including two coats of cement base paint over a coat of primer complete all as specified and as directed.

Removing buildings materials (Demolished /excavated around MD/OTM Accn) including loading , Unloading and Stacking at the destination before loading in trolly and dumped outside of MOD land distance not exc 5 KM complete all as specified and directed. NOTE :- Qty of demolished materials in each load should not be less than 2.50 Cum.

Materila and labour for Cement concrete 25 mm thick 1 :2 4 type B 2 using 40 mm graded stone aggregate as in flooring, finished cement concrete surface even and fair with out using extra cement as in lavelling course as directed complete all as specified

Supply and Fixing for heavy duty tiles (Coloured),good grip series,size 400 mm x 400 mm x 10 mm thick ,pattern as approved by Engr - in - Charge ,set , jointed and pointed in neat cement slurry @ 3 kg/square metre ,laid over and including 20mm thick (average thickness) cement mortar (1:4) bed complete all as specified and directed by Engineer- in - Charge . NOTE : Design/pattern shall be as approved by GE/Engr -in-Charge at the time of execution)

NOTE:- Amount of credit of Rs. 12,880.00 for retrieved materials is mentioned in Schedule of Credit Page No 21 of tender documents in pdf form which will be deducted offline while acceptance of tender.

M/S JAISANT CONSTRUCTION CO. (BID ID -3240885)

KULWANT SINGH (BID ID -3241957)

M/s Gautam Electro Engineers (BID ID -3234141)

Swastik Builders (BID ID -3236219)

G8 CONSTRUCTIONS (BID ID -3235885)

Ashwani Kumar (BID ID -3235740)