S/D and installation of induction type motor with existing pump,making connection from cwr by supplying MS pipe,valve, pressure gauge with different accessories and other allied works at Dakhinpara Zone-1(IARP) w/s scheme Block-Hanskhali,Dist.-Nadia.

Amount

Dismantling and decoupling of the existing 15KW motor from existing pump set by disconnecting all the electrical and pipe lines as per direction of EIC.

Supply and delivery at site of horizontal foot mounted squirell cage induction motor of suitable rating for driving the pump mentioned above. Power supply: 415V+ 10%, 50Hz + 5%, 3ph, Duty-S1, TEFC, IP55, Class-‘F’ temp rise limited to class ‘B’, connection:SDS, Efficiency class-IE3 Motor power should be 15% - 20% over than pump input power at duty point i.e. Motor should be 18.5 KW approximately.) Ambient temp. 50°C Speed: 1500 rpm as sync (Make:- Kirloskar/CG/ABB/MARATHON/Siemens) (Materials should be supplied after taking approval from department.) (All routine test to be performed in presence of EIC before delivery.)

Supply delivery of following items:

100mm dia Rising Spindle sluice valves with PN 1.0 suction side side as per IS 14846 spindle of IS 6603, gr12 cr13 (Make: IVI/IVC/Kirloskar/Jupitar)

100mm dia M.S pipe of 5mm thick

Burden type pressure gauge, wall mounted 100mm cast Al. dial along with DN15 GI impulse line with brass stop cock (0-7Kg) Make-Febig/Hguru)(This cost includes 15mm dia GI pipe for required length & specials.

Supply delivery and storage 100mm dia burdon type compound gauge of cast aluminium dial, ss internal, DN15 GI impulse line with three wsay cock. (make-approved)

100mm dia MS dismantling joints PN 1.0 ratings with Rubber Compression Ring and adjustable follower flanged complete assembled unit with galvanized stud and nuts.

Supply and delivery of belmouth for CWR connection, different type flange, CI short piece, bend, enlarger, reducer etc. for fixing of above item

Installation of above supplied motor with existing pump, making pipe line connection upto cwr with belmouth connection by fitting fixing of above valve, pressure gauge, compund gauge etc.with above supplied shorty piece, bend etc. by hiring welding machine making 03nos valve supplort with U clamp and painting all system with enamel paint and making all complete connection by proper electrician, welder and helper and testing the system upto the satisfaction and as per direction of EIC.(any item or accessories not considered in schedule to be supplied at the time of work.)

Add GST @ 18%

Add LWC @ 1%

SINHA ELECTRICALS (BID ID -6325852)

GLACIER ENGINEERING CO (BID ID -6332098)