Construction of Forest Guard Hut at Sarahan in SarahanBeat,Jari Block ,Jari Forest Rangae of Parvati Forest Division Shamshi (SH- Construction of building portion ,WS and SI and Septic Tank).

Excavation in drains and channels etc. in earth work in all kinds of soil such as pick jumper work, blasting work and hard blasting work saturated soil including chiselling where blasting is not possible or any other mixed variety of soil dewatering and removal of slush and other incidentials lift upto any height stacking the excavated soil upto any lead from the edge of excavation and then returning the stacked soil in 15cm (Fifteen centimetre) thick layer when required into plinths si des of foundations etc. consolidating each deposited layer by ramming and watering and then disposing of al surplus excavated earth with in all leads and lift, of materials and as per direction of Engineer-in-charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 5 coarse sand): 10 graded stone aggregate 40 mm (Forty millimetre) nominal size) within all leads and lift of materials and as per direction directions of Engineer in charge.

Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm (Twenty millimetre) nominal size) upto plinth level : Cement mortar 1:6 (1 cement : 6 coarse sand) Random rubble masonry with hard stone in superstructure above plinth level and upto floor five level, including leveling up with cement conrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm (Twenty millimetre) nominal size) at window sills, ceiling level and the like with with in all leads and lift of materials and as per direction of Engineer-in-charge.

Providing form work with steel plates 3.15mm(Three point fifteen milimetre) thick welded with angle iron in frame 30x30x5mm(Thirty x thirty x five milimetre). so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in:Flat surfaces such as soffits of suspended floors, roofs, landings and the like.Floors etc.upto 200mm. in thickness with in all leads and lift of materials and as per direction of Engineer-in-charge.

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5mm (Five millimetre)), including making drainage opening wherever required complete etc. as per direction of Engineer-in-charge (length of finished kerb edging shall be measured for payment). (Precast C.C. kerb stone shall be approved by Engineer-in-charge)within all leads and lift of materials and as per direction directions of Engineer in charge.

Providing mild steel/Tor steel reinforcement for R.C.C. work including bending, binding and placing in position complete upto floor two level Mild steel with in all leads and lift of materials and as per direction of Engineer-in-charge.

Brick work using common burnt clay building bricks in superstructure above plinth level up to floor any level in second class bricks all shapes and sizes in Cement mortar 1:6 (One cement : Six coarse sand) including carriage of materials with in all leads and lift, of materials and as per direction of Engineer-in-charge.

Half brick masonry with common burnt clay building bricks in cement mortar 1:3 (1 cement : 3 coarse sand) second class bricks in superstructure above plinth level up to floor V level. with in all leads and lift of materials and as per direction of Engineer-in-charge.

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia & length ( hold fast lugs or dash fastener shall be paid for separately).In second class Deodaar wood with in all lifts and lead of materials and as per direction of Engineer -In-Charge.

Providing 40x5 mm (Forty x Five millimetre) flat iron hold fast 40 cm (Forty centimetre) long including fixing to frame with 10 mm (Ten millimetre) diameter bolts, nuts and wooden plugs and embedding in cement concrete block 30x10x15cm (Thirty x Ten x Fifteen centimetre) 1:3:6 mix (1 cement : 3 coarse sand :6 graded stone aggregate 20mm (Twenty millimetre) nominal size). within all leads and lift of materials and as per direction of Engineer-in-charge.