Pdg. High Mast Pole in Civil Hospital, Sec.-6, Panchkula.

Amount

1 :- MCCB ,DISTRIBUTION BOARDS, MCB's, RCCB's, CHANGE OVER etc. Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work. 4 pole MCCB 6 amp to 100 amp 23.22.1.9

2 :- MCCB Enclosure made of Sheet Steel suitable for mounting MCCB of following ratings MCCB up to 125 A FP 23.22.2.1

3 :- EARTHING AND LIGHTENING ARRESTOR Earthing with G.I earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoal or coke and salt) as required. 24.1.1

:- Extra for using salt and char coal/coke for pipe earth electrode as required. 24.1.2

:- Supplying and laying 25mm x 3 mm G.I. strip in 40 mm dia,GI pipe as/from earth electrode including soldering etc. as required. 24.1.7

:- Supply and erection of 20mm x 3 mm thick GI, tape fixed with suitable G.I. staples of same size. 24.1.14

4 :- Laying and fixing of cable on surface/ cable tray etc as required:- 16 Sq mm to 35 sqmm 2 to 4 Core 24.2.5.2

5 :- Supply and erection of suitable compression type brass cable glands for underground Cable :- 10 sqmm to 16 sqmm Cable 2 to 4 Core 24.2.7.2

6 :- Supply and erection of Godrej Almirah type M.S. pedestal made of 50 mm x 50 mm x 6 mm angle iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and locking arrangement with Godrej type handle including round bars. The top covering should have downward overhang of 75 mm on all sides of pedestal, having two sets of water proof ventilation holes of suitable size on the sides , at top and bottom , each set containing four Nos. holes to discharge the heat produced by the current.The shutters fixed with rubber gasket of superior quality and of suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embedded upto the entire depth in 1 :2:4 cement concrete block , projected 75 mm all around the pedestal and and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in-charge of the work M.S. pedestal of size 750 mm wide , 1200 mm high ,300 mm deep and each 8699 bottom totally open , duly embeded in cement concrete block of size 900 mm x 450 mm x 200 mm above ground level , having a base of size 1050 mm x 600 mm x 250 mm below ground level . 23.27.3

7 :- S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Meter below ground level including digging and refilling of earth including cost of suitable size socket/coupler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 63/50 mm outer dia/inner dia 24.5.2.3

8 :- Supply, installation, testing and Commissioning of 20 Mtr. Long High Mast manufactured from B.S.E.N. 10025 or equivalent grade material in, 2 (two) section hot dip, galvanized inside and outside in single dip, suitable for wind velocity as per IS 875 part-3 suitable for 9/12No.s. Lumnaire loading fully motorized (power tool) with starter & cable complete along with standard accessories supplied by the manufactured with 3 No.s. steel wire rope double drum system and twin dome aviation light with LED without foundation but including cost of set of foundation nut and bollts , installation at site complete in all respect upto entire satisfaction of engineer-in-charge. Thickness of Top & Bottom Section =3mm & 4mm (minimum) Top Dia = 150mm & Bottom Dia = 410mm Thickness of Galvanization - Top = 65 micron (minimum) and Bottom = 85 micron (Minimum) 24.4.15.3

9 :- RCC FOUNDATIONS FOR HIGH MAST OCTAGONAL POLES Providing RCC foundation of M25 grade (1 Cement:1 Stone aggregate: 2 Coarse sand) i/c excavation, steel reinforcement (Fe 500) @ 75 kg/cum of concrete contents, concrete cover 50mm, anchor bolts etc. over a bed of PCC 1:5:10 of required dimensions for high mast octagonal poles of various heights as per following specifications complete in all respects and as per directions of Engineer-in-charge. 20m high mast pole 24.9.3

10 :- S/E of 250 Watt Flood light luminaire comprises of die cast aluminium housing with frame, toughened glass with PC lens, cradle mounting including all labour and petty material required to complete the job in all respect upto the entire satisfaction of Engineer-in-Charge of work. Make:- Panasonic/ Havells/ Bajaj/ Surya NS-1

11 :- S/E of Street Light Panel Astronomical Time Switch 40 Amp. 3 Pole including cost of contactor, timer, MCB, wiring etc. with all labour and petty material required to complete the job in all respect upto the entire satisfaction of Engineer-in-Charge of work. Make Indo Asian, Havell's, Legrand, Schneider NS-2

12 :- Supply of aluminium armoured cable of size 16 Sq. mm 4 Core Cable, Make as per approved list. NS-3

13 :- Supply & Erection of 2.5 Sqmm 4 Core Copper wire, Make as per approved list. NS-4

Radhey Krishan Enterprises

G.B. Traders

S R Enterprises

M/S GARG ELECTRICAL