Works Advertised Tender for Under ground work For Godhra West Sdn OR Any Other SDn Under Godhra O&M Division.

NO No. Quantity Rs. Rs.

Proving & Fixing of HEAT SHRINKABLE TYPE JOINTING KIT-OUT DOOR CABLE

1 0411000071 30 Number 1949.15

JOINT FOR A.B. CABLE(95 mm sq)

Proving & Fixing of HEAT SHRINKABLE TYPE JOINTING KIT-OUT DOOR CABLE

2 0411000072 30 Number 1949.15

JOINT FOR A.B. CABLE(70 mm sq)

Supply of HDPE pipe for laying 11KV XLPE cable 110mm nominal diameter & 5.3 to

3 9913000015 mm thickness as per IS:4984 3250 meter 250.85

4 9913000014 Supply of medium grade GI pipe of size 4" dia(Including clamping the cable with pole) 3250 meter 388.98

Excavation of trench 0.5Mtr. Wide and 1 Mtr. Deep for laying of HT/LT underground

cable of size upto 300Sq.mm PILC or XLPE.(The cable should be laid on bed of sand

5 9913000036 and to cover cable with half round RCC pipe 6" internal dia and length of one meter 3250 meter 125.42

along with each bottom and top.) The entire trench there after should be refilled with

earth dully rammed up to ground level As perDrg.No MGVCL/Tech/UG Cable/01/12-

Laying of U/G 11KV XLPE cable by Push & Pull method (MANUAL / BY Horizontal

Directional MACHINE)thru with HDPE pipe 110mm Diameter,5.3 to 6 mm thickness

6 9913000042 or 4" diameter GI Pipe without damaging surface of the road by horizontal boring / 2230 meter 386.44

drilling method (Excluding cost of HDPE pipe 4"GI Pipe) as per Drawing and

specification

Laying/Relaying of cable in Cable trench & from ground level to pole structure for

7 9913000038 providing outdoor cable joints. 1000 meter 50.85

Laying / Relaying XLPE/PILC cable by digging of pits, removal of old cable and laying

8 9913000013 of new cable on sand bad as per item No.1 above. 1000 meter 153.39

Supply of half round RCC hume pipe 6" internal dia & length of 1 Mtr.

9 0302000078 1000 Number 84.75

Supply of sand 0.300x0.500X1.00mtr (Layer at bottom of cable trench approximately

10 9913000049 0.15cmt) As perDrg.No MGVCL/Tech/UG Cable/01/12-13 1000 RMTR 96.61

Add : Charges for digging of tar road for laying of cables over and above digging of pit

11 9913000041 in normal soil as per Sr.No. 1 1000 meter 42.37

providing & supplying, fixing route marker of C.C.1:2:4, 150mm x 150mmx750mm

concrete stone (MGVCL marked with approved yellow colour) embedded in Earth

12 9913000009 at least 300mm below the G.L. & 450mm above G.L. at distance approx. 100 Mtr. 1000 Number 121.19

or as directed by engineer incharge.(This Includes material & Labour charges for

excavation &refilling

Supply & fixing labour charge for providing Bricks (size 9"X 4"X3")layer (4" side layer

10 Nos of Bricks per meter length of cable Top side + 9" side layer 4.5 nos X

13 9501060079 side=10+9=19 Nos /Running Meter) for 11KV XLPE Cable Mechanical protection 1000 Number 4.24

(only top sied layer) at cable ring (loop) location, as per instruction of Engineer in

Charge @ Rs. 4/- per Bricks current market rate F.O.R Site delivery

Moulding of cable joint (St.joint,indoor and outdoor) for XLPE cable- labour

14 9902050002 charges,for Urban area. 30 Number 3258

Moulding of cable joint (St.joint,indoor and outdoor) for XLPE cable- labour

15 9902050002 charges,forRural area. 30 Number 3957

Grand Total

Grand Total

IN SCHDULE ''B'' MENSIONED QUANTIES ARE ESTIMATED. QUANTIIES MAY BE INCREASED OR DECREASED IN EVERY WORKS. BUT

ORDER VALUE WILL NOT BE CHANGED & PAYMENT WILL DONE AS PER ACTUL EXCUSION OF WORKS

In case any joint fails within one year due to poor workmanship,it should be replaced free of cost by you else, the charges for the same will be

deducted from your bill.

If the work of cable would not be started within six hours from verbal instruction of Engineer-in-charge from sub-division, the penalty will be

charged @ Rs.200/- per occasion.

EXECUTIVE ENGINEER(O&M)

SIGNATURE OF CONTRACTOR Godhra

(With Rubber Stamp & Date)