Loading
Loading…
Loading…
Tender Value
₹2.4 Cr
EMD Value
₹4.8 L
Closing Date
3 Jul 2026, 3:30 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Revenue
NORTH
14 conditions · 2 needing a document upload
Financial Eligibility Criteria as per Clause 10.2 of Part-I of IRSGCC-2022 and ACS No.1 dt 14.07.22: The tenderer must have minimum average annual contractual turnover of 'V/N' Or 'V' whichever is less; where V=Advertised value of the tender in crores of Rupees; N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-F (Annexure-VIB of GCC), along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Technical Eligibility Criteria: as per Clause 10.1 of Part-I of IRSGCC-2022 (a) The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii) One similar work costing not less than the amount equal to 60% of advertised value of the tender. (b)(1) In case of tenders for composite works (e.g. works involving more than one distinct component, such as Civil Engineering works, S&T works, Electrical works, OHE works etc. and in the case of major bridges - substructure, superstructure etc.), tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of each component of tender, or (ii) Two similar works each costing not less than the amount equal to 40% of advertised value of each component of tender, or (iii) One similar work each costing not less than the amount equal to 60% of advertised value of each component of tender. Note for b(1): Separate completed works of minimum required values shall also be considered for fulfillment of technical eligibility criteria for different components. Note for Item 10.1 of IRSGCC-2022: Work experience certificate from private individual shall not be considered. However, in addition to work experience certificates issued by any Govt. Organisation, work experience certificate issued by Public listed company having average annual turnover of Rs 500 crore and above in last 3 financial years excluding the current financial year, listed on National Stock Exchange or Bombay Stock Exchange, incorporated/ registered at least 5 years prior to the date of closing of tender, shall also be considered provided the work experience certificate has been issued by a person authorized by the Public listed company to issue such certificates. In case tenderer submits work experience certificate issued by public listed company, the tenderer shall also submit along with work experience certificate, the relevant copy of work order, bill of quantities, bill wise details of payment received duly certified by Chartered Accountant, TDS certificates for all payments received and copy of final/last bill paid by company in support of above work experience certificate.
Defination of Similar Work :- B-6 (a)(b)(c)(d)(e)(f)(g)(h)(i): Any Civil Engineering Work excluding zonal works.
20 conditions · 9 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
The original BG (in lieu of Bid Security) should be delivered in person to the official nominated (i.e.OS/Tenders/Engg/GNT Division) before closing date for submission of bids.(i.e., excluding the last date of submission of Bids).
All the instructions furnished in the Technical Compliance / Commercial Compliance / Custom / Undertakings / General lnstructions are only indicative and not exhaustive. The tenderer shall read the GCC / Tender documents for complete details.
The tenderer shall thoroughly go through the entire tender documents and strictly adhere to the instructions and directions given therein.
Tender value is including escalation of (-)15% (Minus Fifteen percent) on CPWD DSR rates. Tenderer should note this before quoting the rates.
SW1 : Improvements to RUBs in DEN/North section. SW2 Repairs to Drainage system, pumping and de silting at RUBs in DEN/North/ section
496-DRM-W-GNT-Tid-2865~SCR
496-DRM-W-GNT-Tid-2865
Open
Works - General
12 Months
Guntur, Andhra Pradesh
₹0
₹4.8 L
3 Jul 2026
10 Jun 2026
19 Jun 2026
28 items across 2 schedules · ₹2,31,21,218.7 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| in excavation by mechanical means excavator)/manual means over (exceeding 30 cm in depth, 1.5 m in well as 10 sqm on plan) including and disposal of excavated earth 50 m and for all lift, as directed by | — | — | — | — | |
| 1 | soil | cum | 640 | 177.5 | 1,13,600 |
| WORK | — | — | — | — | |
| CONCRETE (CAST IN SITU) | — | — | — | — | |
| and laying in position cement specified grade excluding the cost and shuttering - All work up to : | — | — | — | — | |
| 2 | Cement : 2 coarse sand (zone-III) natural sources: 4 graded stone 40 mm nominal size derived from sources) | cum | 640 | 7,780.3 | 49,79,392 |
| 3 | steel work riveted, bolted or welded sections, trusses and framed work, cutting, hoisting, fixing in position a priming coat of approved steel complete. | Kg | 20740 | 133.7 | 27,72,938 |
| FINISHING | — | — | — | — | |
| with Deluxe Multi surface paint interiors and exteriors using Primer manufacturers specifications : | — | — | — | — | |
| 4 | work with Deluxe Multi Surface an even shade. Two or more coat 0.90 ltr/10 sqm over an under coat applied @ 0.80 ltr/10 sqm of brand and manufacture | Sqm | 600 | 170.7 | 1,02,420 |
| with lime to give an even shade | — | — | — | — | |
| 5 | (two or more coats) | Sqm | 28800 | 22.85 | 6,58,080 |
| 6 | white or colour wash by scrapping papering and preparing the surface including necessary repairs to etc. complete | Sqm | 38400 | 19.75 | 7,58,400 |
| with synthetic enamel paint of brand and manufacture of required an even shade : | — | — | — | — | |
| 7 | coats on old work | Sqm | 9600 | 102.8 | 9,86,880 |
| AND DEMOLISHING | — | — | — | — | |
| cement concrete manually/ by means including disposal of within 50 metres lead as per direction - in - charge. | — | — | — | — | |
| 8 | concrete 1:3:6 or richer mix (including design mix) | cum | 288 | 2,434.25 | 7,01,064 |
| PAVEMENTS | — | — | — | — | |
| 9 | concrete 1:2:4 (1 cement : 2 coarse graded stone aggregate 40 mm size) in pavements, laid to required camber in panels as required consolidation finishing and tamping | cum | 540 | 7,993.8 | 43,16,652 |
| and laying design mix cement M-30 grade, in roads/taxi tracks/ using cement content as per design coarse sand and graded stone of 40 mm nominal size in proportions as per approved and design criteria, providing dowel bars tie bars wherever required, laying spreading and compacting mechanically needle and surface vibrators, levelling slope/ camber, finishing with texture, including steel form work with channel sections, curing, making for contraction/ expansion, and longitudinal joints (10 mm mm deep) by groove cutting providing and filling joints with joint filler and sealants, complete all direction of Engineer-in-charge (Item of sealants, dowel bars with sleeve/ tie paid separately). | — | — | — | — | |
| 10 | concrete prepared with batch mixing | cum | 288 | 10,529.35 | 30,32,452.8 |
| Schedule total | ₹1,84,21,878.8 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
26.02.2026_RevisedApprovedlistofBrandsandMakes2026withallenclosures.pdf
ATTACHMENT
ConcreteMixdesign.pdf
ATTACHMENT
earthworkconditions.pdf
ATTACHMENT
labtesting.pdf
ATTACHMENT
specialconditions.pdf
ATTACHMENT
SpclConditionsfordewatering.pdf
ATTACHMENT
listofRUBs.pdf
ATTACHMENT
sitelaboratoryestablishmentbycontractor.pdf
ATTACHMENT
TestingofMaterialsbyNABLandISOcertifiedLaboratories..pdf
ATTACHMENT
2865MasterDocument01WorksGCC2022withACS11.pdf
ATTACHMENT
2865MasterDocument02worksGCC2022withACS11.pdf
ATTACHMENT
GCC_April-2022_2022ACS1to11-Merged-compressed1.pdf
ATTACHMENT
Systemimprovementguidelinesforbringingeconomyinconcretedesignmix-Reg.4.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .