REPAIR TO BOUNDARY WALL FENCING, GATES IN DOMESTIC AREA AT AF STN PHALODI

Amount

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion from Concrete, brick work,masonry, etc. and making good disturbed ground complete all as specified and directed.

Demolition of cement concrete ( unreinforced ) in ground floors and pavings not exceeding 15 cm thick above or below ground level complete all as specified and directed.

Demolition of Brickwork or stone/boulder masonry, built in lime mortar including all quoins, arches, pillars,etc, but excluding ashlar facings, dressed stonework and precast concrete articles etc complete all as specified and as directed.

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) af any description and in any position not otherwise specifically proveded for complete all as specified and directed.

Dismantling structural steel work including doors, gates but excluding framed truss etc complete all as specified and directed.

Taking down cement plaster on brick or stone walls ,ceiling etc including racking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits,manholes, pier holes, etc. nexc 10 sq m on plan and n exc1.5 m in depth and getting out etc complete in hard/dense soil complete all as specified and directed.

Dismantling fencing wire mesh any type complete all as specified and directed.

M&L for PCC (1:4:8) type D2 using 40 mm graded aggregate as in foundations, filling and mass concrete complete all as specified and directed.

M&L for RCC (nominal mix) Type B-1 (1:2:4) using 20 mm graded stone aggregate as in Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and directed.

M&L for RCC (nominal mix) Type B-1 (1:2:4) using 20 mm graded stone aggregate as in Columns, pillars, piers, posts and struts complete all as specified and directed.

M&L for RCC (nominal mix) Type B-1 (1:2:4) using 20 mm graded stone aggregate as in beams, cantilevers, bressumm?ers, lintels over 1.5m span complete all as specified and directed.

M&L for form work to sides of concrete foundations, footings, bases of columns, raft and raft beams,sides and soffits (if any) of foundation and plinth beams;and similar work; vertical or to batter complete all as specified and directed.

M&L for formwork to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams etc. for rough finished surface of concrete complete all as specified and directed.

M&L for formwork to sides of pillers, posts, struts, piers, columns and stanchions of square , rectangular or polygonal for rough finished surface of concrete complete all as specified and directed.

M&L for TMT MS bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

M&L for TMT MS bars of 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders cut to lengh bent to shape reqd incl cranking bending spirally for hooking for column and binding with MS annealed wire not less than 0.9mm dia complete all as specified and directed

M&L Pre-cast cement concrete (1:3:6) type C-1 (using 20mm graded stone aggregate) block masonry with solid blocks, exc. 10 cm in width and setting in Cement mortar (1:6), complete all as specified and directed.

S&F mild steel framed work as grills, gratings etc with end of bars shouldred and / or rivited or forged into spikes, framed guard bar barred iron door ladders, framed balusters, walk ways, railings, frame work of water tanks and similar work conforming to Fe-290, Gde-E-165, complete all as specified and directed.

M&L for Mild steel work of angle iron as in fencing post including cutting tops to shape as directed, drilling holes, notching for wire, etc, and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

M&L for Mild steel flat iron for securing bolts posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc., flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 complete all as specified and directed.

Supply only Chain link MS galvanisd fencing of any size or type complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

S&F mild steel screw bolts (Machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt exc 5cm but nexc 10cm long and diameter of neck in mm 11 to 15 complete all as specified and directed.

M&L for 10 mm dia mild steel round bars as in strengthening bar for fixing and securing chain link fencing including hooking ends etc complete all as specified and directed.

S&F in repair galvanized 2 strands steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixed to any shape/type of standard posts, straining bolts, including screwing or tightning at crossing with and provision of galvanized mild steel wire staple or steel pins etc as directed (Note : Each line of wire to be measured separately) complete all as specified and directed.

M&L in repair erecting of 610 mm dia punched tape concertina coil fencing, stretches along with two lines for RBT (supporting wire of the same material as concertina coil) having stranded specifications, average weight not less than 1.06 Kg/RM including coating of px2 compound (Anti Rust) and fixed in angle iron brackets on compound wall with and including using necessary scaffolding along the length of wall complete all as specified and directed.

All as per ser Item No 27.00(here-in-before) but refixing, resecuring of existing punched tape concertina coil including making good staples complete all as specified and directed.

M&L for PCC (1:2:4) type B-1 using 20mm graded stone aggregate as in foundation filling, sub base and mass concrete complete all as specified and directed. complete all as specified and directed.

M&L for 75 mm thick PCC (1:3:6) type C-1 using 20 mm graded stone aggregate as in plinth protection, paving, surface finished even and smooth without using extra cement, laid in panels n exc 3 mtr long and joints shall be filled with the mixture of bitumen and sand in (1:3) by weight, complete all as specified and directed.

S&F PVC (SWR) pipes 110mm bore single socketed, in any length with rubber ring joints laid in trenches or in floors/wall complete all as specified and directed.

Providing precast cement concrete (1:2:4) type B-0 using 12.50 mm graded aggregate louvres and jallies, 25mm thick (measured solid), including all mouldings complete all as specified and directed.

M&L for rendering 10 mm thick on fair faces of brick work or concrete surfaces in CM in (1:4) finished fair and even external surface complete all as specified and directed.

M&L for preparation of new plastered surfaces and applying two coats of cement base paint of approved shade on walls including a coat of primer complete all as specified and directed.

M&L for Complete removal of exisisting treatment on walls and applying two coat of cement base paint over a coat of of alkali resistant priming paint on external surfaces of walls complete all as specified & directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc. 25 cms thick in soils complete all as specified & as directed.

Removing excavated surplus material to a distance not exceeding 50 mtr and depositing where directed at a level not exceeding 1.5m above the starting point complete all as specified and directed.

M&L for applying two coats of synthetic enameled paint over a coat of red oxide primer on new steel surfaces exc. 10 cm girth and width including preparation of new steel surfaces complete all as specified and directed.

M&L for applying two coats of synthetic enameled paint over a coat of red oxide primer on new steel surfaces n. exc. 10 cm girth and width including preparation of new steel surfaces complete all as specified and directed.

M&L for preparation of old painted steel surfaces of any description, not otherwise described, over 10 cm width or girth and applying one coat of synthetic enamel paint all as specified.

M/S BHERA RAM & SONS (BID ID -3293246)

R B INFRABUILDERS (BID ID -3294525)

Surya Buildcon & Engineers (BID ID -3293383)

KRISHNA CONSTRUCTION COMPANY (BID ID -3293492)

M/S SOLANKI GENERAL SUPPLIERS (BID ID -3298952)

R D CONSTRUCTION (BID ID -3299154)

MANTRI BUILDERS (BID ID -3294025)