Loading
Loading…
Loading…
Tender Value
₹1.3 Cr
EMD Value
₹2.1 L
Closing Date
9 Jan 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
Above/Below/Par
WORKS 2
14 conditions · 3 needing a document upload
Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or "V" whichever is less; Where V=Advertised value of the tender in crores of Rupees, N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Electrical contractor license: - The contractor should have valid electrical contractor license issued by government and submit along with tender document. If valid electrical contractor license is not submitted along with tender document, then offer will be summarily rejected.
Technical Eligibility Criteria: (a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender. The Definition of similar nature in this tender means "Any Electrical work related to HT/LT installations". (Authority: PCEE / NWR /JP's letter No EL/50/0/SNW/Vol.I Dtd. 08.01.2016).
3 conditions · 1 needing a document upload
Bidder / Tenderer should submit GST registration certificate along with PAN card & Bank mandate while bidding / uploading tender documents.
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
I / We have visited the works site and I / We am / are aware of the site conditions.
Electrical work i/c with provision of (a) Construction of ballast less track on Main Line (PF Line) at Jodhpur station (PF 1 &3 ). (b) Construction of ballast less track on Main Line (PF Line) at Jodhpur station (PF 5 & 6).
GSUELECTG-08R1of2025-26~NWR
GSUELECTG-08R1of2025-26
Open
Works - General
12 Months
Jodhpur, Rajasthan
₹0
₹2.1 L
9 Jan 2026
18 Dec 2025
26 Dec 2025
63 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 1,26,15,003.33 | ||
| — | 3500.00 | — | — | ||
| Supply of XLPE insulated, PVC sheathed armored Aluminum multistrand conductor cable 1100V grade, as per specification attached. 4 Core 16 sq mm | — | — | — | 3,64,000 | |
| — | 2200.00 | — | — | ||
| Supply of XLPE insulated, PVC sheathed armored Aluminum multistrand conductor cable 1100V grade, as per specification attached. 4 Core 35 sq mm | — | — | — | 3,74,000 | |
| — | 2500.00 | — | — | ||
| Supply of XLPE insulated, PVC sheathed armored Aluminum multistrand conductor cable 1100V grade, as per specification attached. 4 Core 70 sq mm | — | — | — | 8,50,000 | |
| — | 2500.00 | — | — | ||
| Supply of XLPE insulated, PVC sheathed armored Aluminum multistrand conductor cable 1100V grade, as per specification attached. 4 Core120 sq mm | — | — | — | 13,25,000 | |
| — | 100.00 | — | — | ||
| Supplying., laying of GI pipe size 50 mm dia. B class as per IS1239 for cable use as per specification enclosed | — | — | — | 32,317 | |
| — | 40.00 | — | — | ||
| Supplying., laying of GI pipe size 100 mm dia. B class as per IS1239 for cable use as per specification enclosed | — | — | — | 25,348 | |
| — | 6000.00 | — | — | ||
| laying cable in Air/Wall/Pole with fixture(02 nos. per mtrs) as per specification | — | — | — | 1,36,980 | |
| — | 1000.00 | — | — | ||
| Laying, connecting & commissioning of cable in pipe/trench etc. with complete lug, glands & transportation of cable etc. as per specification | — | — | — | 2,34,150 | |
| — | 5500.00 | — | — | ||
| Supply and laying of HDPE pipe confirming to IS 4984:1995, 50 mm dia, wall thickness 3 mm, PN 6 under the road. The work involves laying of HDPE pipe | — | — | — | 5,09,190 | |
| — | 6000.00 | — | — | ||
| Digging and filling of trench size 0.4 x 0.8 mtr as per spec (trench work may be on kuchcha/ pucca land and all type of soil as per site requirement and without protective layer of brick). Surface of trench shall be made good in all respect and satisfaction of site engineer | — | — | — | 2,29,200 | |
| — | 500.00 | — | — | ||
| Drilling of horizontal bore below track/road by pushing method for laying of RCC/HDPE/DWC pipe of various sizes (As per specifications) | — | — | — | 6,68,565 | |
| — | 4000.00 | — | — | ||
| Supply, erection and commissioning of auxiliary cable tray made from angle 35x35x5 mm and MS plate 35x5 mm to be fixed on already grouted MS bolts on the pillar/ platform or washing line of 260 mm vide & (as per technical specification attached.) | — | — | — | 18,41,480 | |
| — | 1000.00 | — | — | ||
| Supply & laying of HDPE pipe, dia 160 mm under road/ground/floor/railway track or as per site requirement in already excavated trench. (As per specification) | — | — | — | 7,41,750 | |
| — | 72.00 | — | — | ||
| J' type cable route marker made of cast iron as per approved Railway drawing. | — | — | — | 14,976.72 | |
| — | 500.00 | — | — | ||
| Digging of pacci (Pakki) trench as per specification | — | — | — | 1,46,375 | |
| — | 12.00 | — | — | ||
| "B" Class 50 mm dia GI pipe earth Station with digging pit & refilling with charcoal & salt as per specification. | — | — | — | 15,607.68 | |
| — | 12.00 | — | — | ||
| Inspection Chamber with cover as per specification | — | — | — | 4,353.12 | |
| — | 120.00 | — | — | ||
| Supply & laying of earth connection from earth electrode with 4 mm GI wire properly fixed on wall with wooden gutties etc. as required. | — | — | — | 1,321.2 | |
| — | 4.00 | — | — | ||
| Supply of material & provision of Strip Earth complete with digging of 15 meter trench/0.45meter width/0.6 meter depth and refilling with salt and charcoal as required. The earth should have masonry enclosure on top with hinged MS cover, as per specification. It should be properly packed and watered so that it may not sink in rainy season. The electrode should be provided with 0.5 meter length GI Pipe for Electrode coming out of ground. The earth value should be tested and displayed near the earth pit. | — | — | — | 19,458.76 | |
| — | 5.00 | — | — | ||
| Supply and providing copper plate earthing 4.0 m deep size 600x600x3mm with 3.5m long G.I. "B" class pipe 38 mm for pouring water with 50 Kg charcoal and 10 Kg salt including RCC/masonry earth enclosure with pull out handle and 25x3 mm copper flat earth strip 4.0 mtrs long from earth pit bottom riveted to earth top . The earth value to be measured and marked on earth pit and as per specification attached. | — | — | — | 41,148.15 | |
| — | 50.00 | — | — | ||
| Supply and fixing copper earth strip 25x3 mm and as per specification attached. | — | — | — | 19,894.5 | |
| — | 4.00 | — | — | ||
| Battery Charging rectifier set complete with all accessories having, earthing connection and masonry works e.t.c. as required. at site. The Rectifier set shall have 2 set of Knife Switches as outgoing as per specifications attached Input- 3 phase 415 Volts A.C. Output -110 volt to 150 volt 200 Amp. D.C. | — | — | — | 8,69,515.2 | |
| — | 40.00 | — | — | ||
| Supply of material, fabrication, installation and commissioning of Rolling in Examination lighting MS box of suitable dimensions as per specifications attached at specified locations | — | — | — | 2,30,088 | |
| — | 80.00 | — | — | ||
| Fabrication, supply, fixing and commissioning of Battery charging board /box emergency terminal box two ways outdoor type as per RDSO Drg. No. SKE-3929 as per specifications attached. | — | — | — | 66,240 | |
| — | 68.00 | — | — | ||
| Supply, erection, testing and commissioning of pre-cooling points having BCH 500 volt 63 A plug switch unit combined set (male-female both) including aluminum four pole bus bar chamber of 250 Amps capacity complete inside MS enclosure having suitable design for incoming and outgoing 3 ½ core 120 sq. mm XLPE cable with earthing of the pre-cooling point as per the detailed technical specification and site requirement this item includes the supply of 63 amp. MCCB 4pole. size of MS box (70 x40x30mm)as per site requirement and drawing. | — | — | — | 11,80,548 | |
| — | 2000.00 | — | — | ||
| Supply of XLPE Cable 120 sq. mm 3.5 Cores for Working Voltages up to and Including 1.1 KV as per IS 7098 (Part 1) (Q2) PVC sheathed armored Aluminum multistrand conductor cable as per specification | — | — | — | 10,32,000 | |
| — | 4000.00 | — | — | ||
| Supply of XLPE insulated, PVC sheathed armored Aluminum multistrand conductor cable 1100V grade, as per specification attached.2 Core 120 sq mm | — | — | — | 11,80,000 | |
| — | 300.00 | — | — | ||
| Supply, installation, testing & commissioning of (150 mm width x 50 mm depth x 1.6 mm thickness) perforated Hot Dipped Galvanized Iron Cable Tray (Galvanization thickness not less than 50 microns) with perforation not more than 17.5%, in convenient sections fixed with MS Angle frame duly painted of 35 mm x 5 mm thick and all hardware complete in all respect | — | — | — | 2,09,997 | |
| — | 200.00 | — | — | ||
| Supply, installation, testing & commissioning of (100 mm width x 50 mm depth x 1.6 mm thickness) perforated Hot Dipped Galvanized Iron Cable Tray (Galvanization thickness not less than 50 microns) with perforation not more than 17.5%, in convenient sections fixed with MS Angle frame duly painted of 35 mm x 5 mm thick and all hardware complete in all respect | — | — | — | 1,29,800 | |
| — | 200.00 | — | — | ||
| Unbranded 2 mtr Cable ducting system, Model- Cable Trunking and Ducting system for Electrical Installations 75x75 | — | — | — | 94,100 | |
| — | 200.00 | — | — | ||
| CABLE DUCT A45(H)X45(W) ALONG WITH DUCT COVER A45 IN LENGTH OF 1 METER STANDARD SLOT GREY OF M/S L&T, PHONEIX, PANDUIT MAKE or similar | — | — | — | 27,600 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .