PROVISION OF VEH PARKING SHED NEAR OFFICE OF AGE I NABAGRAM AT NMS UNDER AGE I NABAGRAM

Excavation in trenches n.exc 1.5m wide and n.exc 1.5m in depth for foundation etc and getting out in hard dense soil.

Material & Labour for PCC (1:4:8) type D-2, using 40mm graded stone aggregate in foundation, filling and mass concrete complete all as specified.

Material & Labour RCC M-25 (Design mix) using 20mm graded stone agg as in foundations, including rafts, footings, foundation beams, plinth beams, bases for columns etc basement slabs, under reamed piles and mass concrete.

Material & Labour RCC M-25 (Design mix) using 20mm graded stone agg as in columns, pillars, piers, posts and struts etc

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25cm thick complete all as specified and directed.

Removing Excavated soils exceeding 50metres but not exceeding 250 metres and depositing where directed at a level not exceeding 1.5metre above the starting point, complete all as specified and directed.

Formwork to side of concrete foundations ,footings,bases of columns raft and raft beams and similar type of work

Formwork to sides of column and similar type of work rough finished rectangular in shape

Material & Labour for Cantilever Tensile structure with sione 850 GSM Opaque Black Out Fabric shed with M.s Tubular Framework Red Oxide Coating (Paint: Alkyd Milky White Paint on Structure) fixing of membrane plottting of structure & HF welding of membrane heat sealing of membrane waterproofing of structure fixing of ms fitting metallic ribs and stainless steel fitting. Note: MS col pipe OD 139mm and 3.6mm th, outer & banding frame pipe arch pipe truss section of 2.5mm thick and OD 89mm pipe, base plate 16mm tks and size 450x300mm, MS purling pipe 2mm tk,aluminium flat bar 1" wide,2mm tk, roof sheet material 850g/sq fabric ms klite 2"x4.5", ms rib etc completer all as drg and specified and as directed by E ngr-in-charge.

TMT mild steel bars10mm dia and above cut to length bend to shape required , including cranking bending spirally for hooping for coumns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips.