1118 Estimate for Installat...for contractor and society etc.

Repairing of open gym equipment: Air Walker, Air Swing, Stair Stepper, Pull Chair, Seated Chest Press, Elliptical Exerciser, Double Cross Walker, Twister, Rowing Machine, Arm Wheel, Exercising Bar, Leg Press, Horse Rider Station and Sit Up station including rubbing , painting and spraying with good finish by painting machine at site complete in all respect to full satisfaction of Engineer-in-chief.

Repairing of old play equipment : Chain Swing , Bridge Ladder , Slide Ladder and Sea Saw including rubbing , painting and spraying with good finish by painting machine at site complete in all respect to full satisfaction of Engineer-in-chief.

Analysis for providing and fixing of CROSS FIT MONKEY BAR CROSS FIT MONKEY BAR 2*24 foot

Analysis for providing and fixing of `MULTlPLAY STATION Height 15 fit, Length 18 fit, Width 17 fit, Use Material -12 gauge Apollo pipe, Main Pillar Pipe 75 OD Handling pipe 25 OD, Stair pipe 48 mm, Plastic (LLDP) thickness 8 to 10mm. With multi color powder coting.

Analysis for providing and fixing of MERRY GO ROUND Height 3 fit, Length 4 fit, Width 4 fit, Use Material -12 gauge Apollo pipe, Pillar pipe 75 OD, Handling pipe 25 OD, With multi color powder coting.

Analysis for providing and fixing of MONKEY BAR Height 8 fit, Length 10 fit, Width 2 fit, Use Material -12 gauge Apollo pipe, Pillar pipe 48 OD, Handling pipe 25 OD, With multi color powder coting.

Analysis for providing and fixing of HORSE RIDER Height 2.5 fit, Length 3 fit, Width 1.5 fit, LLDP plastic.

Analysis for providing and fixing of A B CLIMBER Height 8 fit, Length 12 fit, Width 4 fit, Use Material -12 gauge Apollo pipe, Pillar pipe 48 OD, Handling pipe 25 OD, With multi color powder coting.

Analysis for providing and fixing of `ROCKER SEE SAW Height 3 fit, Length 5 fit, Width 4 fit, Use Material -12 gauge Apollo pipe, Pillar pipe 48 OD, Handling pipe 25 OD, With multi color powder coting.

Analysis for providing and fixing of DOUBLE SWING JHULA Height 7 fit, Length 10 fit, Width 4 fit, Use Material -12 gauge Apollo pipe, Pillar pipe 48 OD, With multi color powder coting.

Analysis for providing and fixing of TUNNEL SLIDE Height 6 fit, Length 6 fit, Width 10 fit, Use Material -12 gauge Apollo pipe, Main Pillar pipe 75 OD, Handling pipe 25 OD, Stair pipe 48 mm, Plastic LLDP thickness 8 to 10mm. With multy color powder cotting.

Analysis for providing and fixing of SINGLE SLIDE Height 7 fit, Length 14 fit, Width 3 fit, Use Material -12 gauge Apollo pipe, Handling pipe 25 OD, Stair pipe 48 mm, Plastic LLDP thickness 8 to 10mm. With multy color powder cotting.

Analysis for providing and fixing of DOUBLE SEE SAW Height 3 fit, Length 6 fit, Width 4 fit, Use Material -12 gauge Apollo pipe, Handling pipe 25 OD, Stair pipe 48 mm, With multi color powder coting.

BoQ_Ver3.0

Name of the Bidder/ Bidding Firm / Company :

PRICE SCHEDULE (This BOQ template must not be modified/replaced by the bidder and the same should be uploaded after filling the relevent columns, else the bidder is liable to be rejected for this tender. Bidders are allowed to enter the Bidder Name and Values only )

NUMBER #

[13.29.2]Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. 2. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works [Through Rate]

[6.1.8]Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work below plinth level and up to Floor IV level: 8. 1:5:10 (1 cement : 5 fine sand : 10 graded stone aggregate 40 mm nominal size) [Through Rate]

[6.14.1]Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level : 1. 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III): 3 graded stone aggregate 20 mm nominal size) [Through Rate]

[6.15.1]Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts etc. above plinth level up to floor four level, excluding cost of centering, shuttering, finishing and reinforcement : 1. 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 graded stone aggregate 20 mm nominal size) [Through Rate]

[6.16]Reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor four level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-III) : 3 graded stone aggregate 20 mm nominal size). [Through Rate]

[6.30.6]Centering and shuttering including strutting, propping etc. and removal of form for 6. Columns, Pillars, Piers, Abutments, Posts and Struts [Through Rate]

[6.34.3]Steel reinforcement for R.C.C. work, where not included in the complete rate of RCC, including straightening, cutting, bending, placing in position, binding, wastage, overlaps, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire etc. complete in all respect above plinth level Note:- Reinforcement shall be measured in length including hooks, if any, separately for different diameters as actually used in work , excluding overlaps. Wastage, overlaps, couplings, welded joints, spacer bars, chairs, stays, hangers and annealed steel wire or other methods of binding & placing shall not be measured and cost of these items shall be deemed to be included in the rates for reinforcement. 3. Cold twisted bars [Through Rate]

[7.21.1]Brick work with common burnt clay non-modular bricks of class designation 10.5 in foundation and plinth in: 1. Cement mortar 1:4 (1 cement : 4 coarse sand) [Through Rate]

[7.22.1]Brick work with common burnt clay non-modular bricks of class designation 10.5 in superstructure above plinth level up to floor IV level in all shapes and sizes in : 1. Cement mortar 1:4 (1 cement : 4 coarse sand) [Through Rate]