Providing and fitting of Heating Convectors and inverter for Snow clearance Control Room at Gulmarg.

Amount

Providing and fitting of 16 sqmm PVC insulate copper wire as a main service line for providing electric supply to the Heat Convectors/Blowers.

Providing/Fitting of heating points in 4 sq.mm PVC insulated copper wire of havells make through PVC channel/conduit as per requirement. The job includes P/F of 16 Amp.SS combine on Bakelite sheet..

Providing and Fitting Wall Mounted Heat Convectors/Hot Air Blowers of 2000W of reputed/registered make with digital Display and remote controlling along with 10AMCB for on/off

Providing, fitting, Testing and Commissioning of 100 AMP Electric Panel with following specifications. P/F of 100A ,4-Pole 415V,50 Hz MCCB having 36 KA breaking capacity and shall conform to IS/IEC 60947-2 standards. The MCCB shall be of L&T/Schienhieder make. The MCCB shall be of thermal magnetic release type having thermal release range of 80-100A.The job includes providing and fitting of MCCB in MS sheet enclosure. The job also includes provides of 04 nos Aluminum bus bar strip of suitable size dully tinned air insulated mounted on suitable size bakelite insulators with proper colour code. The bus bar strips should also be provide inside same MS sheet enclosure but having separate cabin. The MS Sheet enclosure should be installed on a suitable M.S Stand.. Providing and fitting of change over switch of following specifications:- Rating – 100 Ampere Type- Manual operated, 4 pole, 400 + 15% volts, 50 + 3%Hz. Make – Havells/SSK P/F of 08 no 16A Dp swithes for outgoing circuit. The change over switch shall be fitted on same MS sheet but having separate cabin. The Change over switch is required as an alternate for the electric supply from the DG set. All sorts of tools and tackles, nuts/bolts etc that shall be used for installation /fixing of the Electric panel shall be arranged by the firm. The job includes testing of the Panel on no load and then on full lo. The test certificate of the manufacturer has to be provided with the Material.

Providing/Fitting of 50W LED flood lights inside premises of Inspection Hut. The flood lights shall be of following specifications:- • Input voltage 140-320V,50Hz • High efficiency. • CRI(colour rendering index)>80. • 5500 Lumens. • LED type-COB. • Protection-IP65. • Make –Ledure/Havells. The job includes providing and fitting nuts, bolts and washers for fitting of LED. Providing Laying and Connection of 2Cx2.5 mm² flat, PVC sheathed copper Cable for providing connection to all the LED flood lights of Snow control room to distribution board. The job includes underground laying/overhanging through PVC conduit as per requirement and directions of the site incharge. Make: Havells/Gloster/Finolex. All the tools and tackles with ladder and technically sound person well versed with the job shall be arranged by the firm The job also includes providing/fitting of 10A MCB for operation of light. The LED lights shall be tested on full load.

Providing and fitting 1650W/24v UPS/Inverter with 200Ah 02 Nos Batteries of reputed make complete Job.

NARINDER SINGH

S. D. Electrical and Mechanical Contractor

NEW AHANGER ENGINEERING WORKS