Providing and Erecting Street light poles et Randheja, Rupal, Sardhav, Dhamasana road Dist. Gandhinagar

NAME OF WORK :- Providing and erecting Street light poles at Randheja-Rupal-Sardhav-Dhamasana Road,Dist.Gandhinagar

FUND HEAD :- Deposited Work

ITEM ISSUE AMOUN

QTY PARTICULARS

SIGNATURE OF THE CONTRACTOR DEPUTY EXECUTIVE ENGINEER

CAPITAL PROJECT ELECTRICAL SUB DN NO.22

Name of Work: Providing and erecting Street light poles at Randheja-Rupal-Sardhav-Dhamasana Road,Dist.Gandhinagar

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Mains with ISI marked, 1.5KV grade electrolyte multi stranded, annealed

copper conductor with heat resistant PVC insulated conforms to IS 694, IEC - 227 erected in

existing pipe of following size (Specifically for control panel, relays, power switchgears, motor

starters & control wiring) with required size of copper lugs, nuts and bolts if required.

225 Mtrs. (f) One wire 10.00 sq. mm 91.91 One And Paise Mtr.

Ninety One Only

150 Mtrs. (h) One wire 25.00 sq. mm 236.34 Mtr.

Thirty Four Only

Supplying and erecting Flexible PVC insulated multi strand multi core 1.1 kv grade ISI marked Rupees Forty Six

2 4800 Mtrs. copper wires of following size to be erected as directed. 46.46 And Paise Forty Mtr.

e) 1.50 Sq.mm 3 core round PVC sheathed Six Only

Providing & Erecting following Shockproof tissino type accessories erected on 3 mm thick PC Rupees Twenty

3 20 Nos. (Polycarbonate) sheet in PVC/ Metal/Wooden Box. erected on wall/ ceiling. 22.22 Two And Paise Each

(8) Bakelite lamp holder Twenty Two Only

Supplying and erecting led lamps with following wattage capacity of 220 to 240 voltage, minimum

15000 burning hours life, 500 V in built-surge protection,Polycarbonate diffuser, mounting suitable

4 20 Nos. for E14 / E27 / B22 lamp holders, pf >= 0.5 112.11 Each

And Paise Eleven

(A) LED Lamps integral type, with PC diffuser suitable LAMP holder

(ii) 5 to 8 watts Cat-III

Supplying and erecting LED street light / Flood light fittings with High power White LEDs wattage of

3 Watt and above assembled on single MCPCB, efficiency more than 130 lm/w and corrosion free

High pressure die cast aluminum housing with smooth finish powder coated and heat sink extruded

aluminium with diffuser and Polycarbonate optics/ lenses, with toughened glass with company

mark/name engraved or embossed 160 to 270 V,Power Factor more than 0.95, THD < 10 %, CCT

3000 K to 5700K,Uniformity ratio >0.45, Luminaire efficacy> 100 lumens/watt . LED driver efficiency

5 600 Nos. 6566.01 Hundred Sixty Six Each

> 85 %.( fittings required LM-79 & LM-80 certificates)(NOTE: Below description have shown ranges

of Wattage capacity of LED fittings.The Engineer incharge may select any wattage capacity

between the ranges shown.)

(A) Street Light (IP-65), Surge protection -4KV integral and ,Light must have 440VAC line supply

with over-voltage protection.

(iv) above 90 to 120 watts Cat-lll

Providing and erecting Approved make Four pole moulded case circuit breaker having breaking Rupees Six

capacity ICU of 25 KA. at 415 V,having normal current rating up to 25 A to 100A. with Fixed thermal Thousand One

6 10 Nos. & magnetic release suitable to work on A.C. supply 50 c/s. with all internal connections, spreader 6173.12 Hundred Seventy Each

tinned copper & complete erected in existing 16 G.M.S. housing. Three And Paise

ICS=100% of ICU only Cat III Twelve Only

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Supplying and erecting triple pole & neutral 440V / 500V panel mounting Copper Busbars with four

equal Nos. of electrolyte bus having current density not more than 1.6 Amp. / sq.mm (Rated current

Rn. / cross section area) duly wrapped with colour insulating tape for phase sequence of following Rn.

7 5 1961.42 Hundred Sixty

Mtr. current carrying capacity, erected with necessary bus bar supports /insulators, main cable socket to Mtr.

each bar, erected in existing cubical panel with necessary connections.

(A) Suitable for 100 Amp. Capacity

Supplying and erecting KITKAT pattern porcelain cut-out fuse with base of following current capacity

erected on existing block board.

Hundred Forty Six

90 Nos. (iv) 63 A 500 V 146.45 Each

And Paise Forty

Hundred Seventy

Eight And Paise

Seventy Six Only

Providing and erecting Miniature circuit breaker single pole 0.5A to 2A system and having breaking Hundred Seventy

9 600 Nos. 270.68 Each

capacity 10 KA to be erected in existing box. confirming to IS 8828/1996 with ISI Mark And Paise Sixty

Providing and erecting Miniature circuit breaker single pole 6A to 25A suitable to operate on 240 V

10 90 Nos. A.C. system and having breaking capacity 10 KA to be erected in existing box. confirming to IS 112.11 Each

And Paise Eleven

8828/1996 with ISI Mark Cat.III

Providing and erecting Approved make RCCBs conforming to IS: 12640 and having sensitivity of 30 Rupees Two

mA and Short Circuit withstand capacity of 10 KA and suitable for operation on 3 phase and neutral Thousand Six

11 30 Nos. 415V,50Hz. having characteristic of quick action & tripping with all advance feature & do not 2637.11 Hundred Thirty Each

incorporate any electronic component for following Max. rating erected as directed. Seven And Paise

(ii) 40Amps. FP Cat. III Eleven Only

Providing , erecting , fabricating the M.S. structure as per requirement on site incorporating proper Rupees Seventy

size of M.S. angles,square,round, flats, bars, channels, sections complete with cutting, welding, Seven And Paise

grinding & finishing duly painted with one coat of red oxide with erection on site as per direction of Seventy Seven

engineer in charge with necessary grouting, cementing, plastering & finishing complete. Only

Providing and erecting Pipe type earthing having 150 cms.long and 2.5 cms. dia. galvanised iron

13 520 Nos. pipe with coupling and buch buried in specially prepared earth pit complete with necessary 8 SWG 368.65 Each

Eight And Paise

Sixty Five Only

Hundred Seventy

14 520 Nos. For using salt and charcoal / coke as required for pipe type earthing. 171.70 Each

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting XLPE (IS:7098)(I)-88 ISI armoured cable multistrand Aluminium conductor Rupees One

for 1.1 KV. to be laid on wall with necessary clamps or in existing trench / pipe of following size of Hundred Fifty

cables Three And Paise

(A) 4 core 16 Sq. mm Fifty Two Only

Rupees Fifty Five

Making trench in soft soil of suitable width of 90 cm deep for laying cable or locating the fault all

16 15,000 Mtrs. 55.55 And Paise Fifty Mtr.

over the run and back filling the same and making the surface as normal ground.

Making trench in Hard Murrum / Tar Road of suitable width of 90 cm or required depth for laying Rupees Four

any size of cable or locating the fault all over the run and back filling the same and making the Hundred Thirty

surface as normal ground. Two And Paise

(B) If additional machinery like hammer driller or JCB use [Add] Twenty Eight Only

Drilling the road without breaking the road surface (Asphalt) for laying of cable for feeding power

18 560 Mtrs. supply by making up to following size of holes at both ends complete. 492.88 Mtr.

(A) Up to 100 mm bore dia

Eighty Eight Only

Providing & laying approved make Double walled corrugated pipes (DWC) of

polyethylene(conforming to IS 14930 II )with necessary connecting accessories of same material at Rupees Sixty Two

19 15,500 Mtrs. required depth in existing trench for laying of cable. below ground / road surface for enclosing 62.62 And Paise Sixty Mtr.

(A)50 mm outer dia

Providing and erecting Solder less crimping type Aluminium lugs conforming to IS suitable for cable

of following size evenly crimped with high pressure tool & connected to switchgear terminals with

20 4160 Nos. 15.15 And Paise Fifteen Each

brass/cadmium plated nut bolts in an approved manner.

Supplying and erecting approved make Octagonal pole made from HR sheet steel. The pole should

be made as per IS. and shall be coated with hot dip galvanizing as per IS 2629/2633/4759, suitable

suspend local wind speed with integral Junction box consist of terminal plate of min 6mm Hylam

sheet, standard profile 35mmX7.5mm Din-Rail for MCB Mounting, stud type terminal and

21 520 Nos. 11411.99 Hundred Eleven Each

arrangement for cable termination to be erected With Suitable foundation (Included) as per

And Paise Ninety

details given by manufacturer considering site requirement.

(E) 7 Mtr. Long 70 mm Top X 135 mm bottom dia, 3 mm thickness with 225mmX225mmX16mm

base plate, 4-M20 Bolts and 600mm long with necessary G.I. J Bolts .Approx Pole weight 67 kg

Providing and erecting Street Light pole bracket comprising main B Class GI pipe of 4.2 cm/require

outside dia. complete with suitable B Class G.I. sleeve tubing of approx. 45cms.length and suitable

for 76.5 mm /80mm / required size of pole top having sufficient fasteners for fixing the brackets and

22 440 Nos. 683.77 Three And Paise Each

having spread of 1.5.mtr. length with 110 deg.with vertical plane & suitable welded stays, reducer

and with check nuts complete painted with one coat of Red oxide / PU base primer and two coats of

Aluminium / PU paint. paint with following nos of arms. [A] Single Arm Bracket 1.5 Mtr

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Providing and erecting Street Light pole bracket comprising main B Class GI pipe of 4.2 cm/require

outside dia. complete with suitable B Class G.I. sleeve tubing of approx. 45cms.length and suitable Rupees One

for 76.5 mm /80mm / required size of pole top having sufficient fasteners for fixing the brackets and Thousand Two

23 80 Nos. 1002.93 Each

having spread of 1.5.mtr. length with 110 deg.with vertical plane & suitable welded stays, reducer And Paise Ninety

and with check nuts complete painted with one coat of Red oxide / PU base primer and two coats of Three Only

Aluminium / PU paint. paint with following nos of arms. [B] Double Arm Bracket 1.5 Mtr

Supplying & erecting IP 55 grade following size section pillar fabricated from joint less M.S. Sheet

with angle iron legs made from jointless M.S. Angle with cable clamps to be buried in ground to

have appropriate erection to work uniform until erected with cement concrete foundation and 45 cm

high bricks work finishing with plaster etc. hinged double door internally supported on both side, with

internal and outside looking arrangement with look and keys in duplicate 35 x 35 x 5 mm M.S. Angle

23 10 Nos. 16691.26 Hundred Ninety Each

of Two Nos. one is welded and other with nut and bolt for erecting Bakelite sheet. Painting the

Section Pillar inside and out side with three tank powder coated paint. section pillar roof should be

Twenty Six Only

without joint with water leakage proof & tested as per IP 55 test & followed by IS 2147 of

(A) 150 X 90 X 75 cm section pillar fabricated from 14 Gauge MS Sheet with angle iron legs 95 cm

long made from 40 X 40 X 6 mm thick MS angle.

24 12 sq.mtr Supplying and erecting HYLAM sheet on existing angle iron frame.for following thickness. (E) 10mm 1927.08 Hundred Twenty Sq.mtr

Seven And Paise

Supplying & erecting approved make Digital time switch having lithium cell 6 years operative and

operate battery backup 1 channel day clock with 14 memory programme, suitable to operate on

240V + 5%, 16A with, floating contacts Minimum switching setup time 1 minimum & LCD display.

25 10 Nos. 3168.37 Hundred Sixty Each

Also comprised permanent ON/OFF switching. Programming switches & housed in fire proof

Eight And Paise

thermoplastic enclosure & transparent cover erected as required with necessary connection erected

Thirty Seven Only

Providing and erecting AC-3 duty 3 pole power contactor with 2 NO & 2 NC aux contacts complete Thousand Two

26 10 Nos. with 415V/220V operating coil suitable for (L&T, BCH,T.C., Siemens, C&S make).(E) for 110 A 12297.76 Hundred Ninety Each

rating Seven And Paise

Seventy Six Only

Total Amount Rs.

Total Amount Rs.

In Words:- Rupees One Crore Sixty Four Lakh(s) Thirty Nine Thousand One Hundred Forty Four And Paise Eighty One Only

I/We am/are willing to carry out the work at(No above rates allowed) ____________% Below ____________________________________________________________

__________________Percent (Should be written in figures and words) below the tendered rates mentioned above.

Amount of my/our tender works out as under :

Sr.No. Qty. Item Per Amount In Rs.

In Figure In Words

Put to Tender Rs. 16439144.81 Put to Tender Rs.