Thanthoni Block - Construction Community Hall at Pallapalayam in Pallapalayam Panchayat under MLACDS-2022-23

Amount

Name of the Work : Construction Community Hall at Pallapalayam in Pallapalayam Panchayat

Earth work excavation for foundation in all clauses of soils and sub soils to full depth as may be directed except in hard rock requiring blasting but inclusive of shoring strutting and boiling out water whenever necessary et complete complying with stand

Supplying and filling in foundation and basement with filling excavated earth in larges of not more than 15 cm thick well rammed watered and compacted including & conveyance and all labour charges etc.,

Supplying and filling in basement with filling River sand in layer of not more than 15 cm thick well rammed etc., complete.

Cement concrete 1:4:8 mix ( one cement four sand and eight aggregate)using 40mm gauge hand broken granite tone jelly for foundation including dewatering if found ecessary and laid in layers of not more than 15 cm thick and compacted,etc., complete

Brick work in cm 1:5 mix(one cement and five sand )using country bricks ground maded of size 23 x 11 x 7 cm including curing,finishing and cost & Conveyance of all materials etc., complete.

Supplying and erecting centering for sides Centering for soffits of RCC slabs of plane surface like lintels, beams etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X

Supplying fabricating and placing in position of ribbed steel rods for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors etc., complete

RCC 1: 1/2 :3 mix using 20 mm ISS HBG metal for RCC items of work excluding items of works excluding centering,shuttering, and ost of reinforcement grill ,out including curing etc complete and also including fixing fan clamps and ixtures in rcc works wh

Plastering with cm 1:5 mix( one cement and five sand ) to 12 mm thick including cost and conveyance of all materials in all floors etc.,as directed by departmental officers etc, complete complying with standard specifications.

Plastering surfaces of RCC items such as slabs,beams,sunshades with cement mortar 1:3 -10mm thick including packing, providing cement mortar beading for sunshades staircase ,steps, lands slabs etc.,as directed by departmental officers etc,

Paving the floor with Vetrified tiles 0.60mx0.6mx0.008m in all floors over a base layer of cement mortar 1:3 (one cement and three sand ) 20mm thick laid in-situ and pointed with same coloured cement as

Providing weathering course with best quality of brick Jelly 20mm gauge in pure slaked lime (no sand to be added) over roof slab,the proportion of brick jelly to lime being '32 to 12.5 well beated with wooden beaters for giving required slope and thicknes

Finishing top roof mix one course machine pressed tiles of size 20 cm x 20 cm x 2 cm approved qty with,CM.1:3 12 mm thick mixed with WPC at 2% by weight of cement used and top pointed with the same mortar etc

Supplying and fixing P.V.C rainwater down fall pipe of 110mm dia with necessary shoes, bends & clamps etc.,

Distembering two coats of oil bound distember using one coat of primer coat including cost & conveyance to size and all labour charges etc., complete.

Painting two coats with ready mixed Exterior Emulsion paint of approved qualityand colour over a priming coat, including through scrapping,clean removel of dirt etc complete .

Painting two coats of new iron work with best quality synthetic enamel paint of approved quality and colour with priming coat including the cost all materials etc.,complete, in all floors.

Fabricating Supply and fixing and position of MS Door with single leave. The door outer frame will be 40x40x6mm MS angle, the shutter frame will be 35x35x6 mm, MS angle intermediate stiffner will be 35x35x6 mm with cross stiffner 25x 25x5 mm flats covere

Fabricating Supply and fixing and position of MS Windows with two leave. The window outer frame will be 35x35x6mm MS angle, the shutter frame will be 25x25x6 mm, MS angle intermediate stiffner will be 25x25x6 mm with cross stiffner 25x 25x5 mm flats cover

Supplying and fixing following electrical arrangement

Wiring with 2 x 1.5 sq.mm(22/0.3) PVC insulated SC. Unsheathed Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A F.T. switch withpainting of suitable colour for open PVC light point / fan point (For electrical regulator).SD 17

Wiring with 2 x 1.5 sq.mm(22/0.3) PVC insulated SC. Unsheathed Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150x100x113mm TW switch box for 5A3 pin non inter locking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWGTC wire for open PVC plug point. (SD 36)

Wiring with 2 x 4 sq.mm(56/0.3) PVC insulated SC. Unsheathed Cu. Conductor Cable of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150x100x113mm TW switch box in flush with wall with 3mm thick hylem sheet cover for 15 A 3 pin flush type non inter locking CS plug with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC power plug point. (SD 39)

Supply and run of 2x1.5 sqmm (22x0.3) PVC insulated SC unsheathed Cu.Conductor of 1100Vgrade on 7/20 GI Bearer Wire of service connection Mains (SD 64)

Supply and fixing of WT BULK HEAD Fitting With Guard (Philips/Bajaj/Crompton/K.Lite) suitable for 11W CFL Lamp With CFL (SD 83)

Supply and fixing of 4' 36Watts Flu Fitting complete with Electronic Ballast With TW round Block On Wall or Ceilling With Flu Tube With PVC unsheathed Copper Leads from Terminal to the Tube Light Fiittings (SD 87)

Supply and fixing Of 1200mm (48") Sweep AC Ceiling Fan complete with stepped Electronic 300 W Regulator , with 1m down rod with Fan clamp with side plates and cross arm of size 450mm (18") (SD106)

Supply and fixing Of 16Amps DP Main Switch with metal clad of 500w with fuse and Neutral (Side handle ) on suitable TW Box PWD Earthing

Supply and fixing of 4'40Watts Single Street Light Flu Fitting complete withCopper chok and Condesor With 20 mm GI Pipe( CLASS "B") With One number 20 mm GI bend complete on the existing post/ wall with 16 A Aerial Fuse unit on M.S Plate With PVC unsheathed Cu .Leads , With MS clambs With Aluminium painting with Flu Tubes Street Light Fiittings (SD 94)

GST Amount for providing Service to Government Contract Works for the above ConstructionWorks. GST Amount is the Total GST Amount for overall quoted amount above this row in column "BB" for all works in this package} (Refer Clause 13.2 & 13.3 of Section 2 of Instruction to Bidders (ITB) of SBD)

S.Velusamy