ADDITION and ALTERATION TO SECURITY WALL FENCE CERTAIN IMPROVEMENT WORKS AT RUSHIKONDA VISAKHAPATNAM UNDER AGE I CG VIZAG

Amount

Dismantling of fencing post or struts (wood, steel, RCC) any section, post embedded in concrete , brick work, masonry etc , including taking out embedded portion and making good distrubed ground complete all as specified and as directed.

M&L for cement concrete 1:2:4 type B2 (40 mm graded aggregate) in column pitter boundary pillars and post and as as specified and as directed.

S&F for Mild steel angles , bars , flats, etc as in posts and struts in fencing including cutting tops to shape as supports for stiffening of fencing , wall ties, hold fasts, clamps plain angle cleats for securing purlins as directed, drilling holes, notching for wire, etc, flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc and similar work conforming to Fe-290 Gde E-165 complete all as specified and as directed.

S&F in repairs Galvanised, 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) complete all as specified and as directed.

S&F in repairs 1050mm dia razor wire CONCERTINA coil of standard specification, i.e. 51 spirals per coil, average weight not less than 15 Kgs per coil. ( Each coil will be stretched to 06 m (approximately) including anti rust coating of PX2 compound and fixing to any type of standard rails straining bolts including securing or tying at crossings with necessary clips/pins etc including with three lines for RBT supporting wire to same material as cocertina col having standard specification along the entire length of wall complete all as specified and as directed.

M&L for two coats synthetic enamel paint over coat of red oxide primer on new steel surfaces including necessary preparation, width or girth exc 10 cm complete all as specified and as directed.

M&L for painting to new steel surfaces of any description over 10 cm in with or girth, not otherwise described and applying two coats of black Japan paint articles in contact with concrete or masonry complete all as specified and as directed.

Demolition of brick work or stone / boulder masonry, built in cement mortar including all quoins, pillars etc complete all as specified and as directed.

M&L for brickwork with fly ash old size bricks, straright or corved on plan exc 6m mean radius built in cement mortar 1:6 complete all as specified and as directed.

All as per item No 9 but except bricks.

Taking down cement plaster any description including racking out joints hacking for key scrubbing down with water etc complete all as specified and as directed

M&L rendering 15 mm thick in cement mortar 1:4 on fair faces of brick work or concrete surfaces , finished even and smooth without using extra cement including mixing with liquid WPC all as per manufacturers instructions complete all as specified and as directed. (Note :- Liquid WPC will be measured and paid separately)

Supply only integral liquid water proofing compound.

Preparing newly plastered surfaces of wall and applying two coats of cement based paint over a coat of primer complete all as specified and as directed

Demolition of cement concrete (un-reinforced) of any description in ground floors and pavings not exc 15 cm thickness (below or above ground level) complete all as specified and as directed.

M&L for cement concrete (1:3:6) type C-2 (using 40mm graded stone aggregate) in surface channels and drains complete all as specified and as directed.

Surface excavation in soft/loose soil n exc 30 cm deep and averaging 15 cm deep and getting out complete all as specified and as directed.

M&L for hard core of gauge n exc 63 mm, deposited, spread and levelled in layers n exc 15cm thick, watered and rammed to a true surface complete all as specified and as directed.

M&L for 100 mm thick Cement concrete type D-2, 1:4:8 (using 40 mm graded granite stone aggregate) in sub base of flooring/ hard standing complete all as specified and as directed.

Sand filling under floors or in foundations including watering and consolidation complete all as specified and as directed.

S&F machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 80 mm thick, M-40 Grade finished with grey cement complete all as specified and as directed.

M&L for Providing cement concrete 1:2:4 type B-1 (using 20 mm graded aggregate) in copings/benching complete all as specified and as directed.

Removing Excavated soils to a distance n.exc 250m and deposition where directed at a level not exc 1.5m above the starting point complete all as specified and as directed.

SRI SRK ENGINEERS

JAHNAVI ASSOCIATES

Ruchira Associates

M/s Saptagiri constructions