Providing calcium silicate board and toughened glass partition for making faculty cabin at CSB 4206 in IISER campus, Vithura

Amount

Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/ appropriate Z sections and other sections, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing / paneling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge. (Glazing, paneling and dash fasteners to be paid for separately)

Fixed Portion Anodised aluminium (Aluminium sections alone will be supplied by IISER at free of cost all other materials like aluminium angles, screws, fischer, rivets, beadings, etc shall be provided by the contractor)

Providing and fixing in wall lining using 12 mm thick Calcium Silicate Boards with necessary fixing arrangements and screws etc. All joints shall be provided with adhesive dry wall joint tap, etc complete all as directed by EIC

GLASS PARTITION :Providing and fixing of ±12mm Thk Toughened glass partition of approved make finished as per the design . The ±12mm Thk Toughened will be fixed with "U" Channels/patch fittings of approved brand with necessary supports and finishes etc as instructed by the engineer -in -charge .

TOUGHENED GLASS DOOR : Providing & fixing ±12mm Thk Toughened door of approved dimension as per the design .The door works id inclusive of necessary hardware's such as floor spring, concealed dead lock ±12"S.S Handles , Top and Bottom patch etc all as required hardware complete as directed. The rate is inclusive of all related civil works such as floor cuttings ,filling etc as required (A) 900x 2100 mm Thk Toughened Single Leaf door (Approx dimenion )

Supply and applying of approved shade of frosted film as per the design in the designated areas. The surface preparation should be made before the installation in order to attain a smooth finish. The films should be installed towards the clean surface with the help of recommended patch tools etc., as required. The films should be fixed towards the glass in the designated area as per the design and comments from the engineer-in-charge. Total glass area covered without deduction of cut patches/design will be considered for payment

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface Water thinnable cement primer

Wall painting with premium acrylic emulsion paint of interior grade, having VOC (Volatile Organic Compound ) content less than 50 grams/ litre of approved brand and manufacture, including applying additional coats wherever required to achieve even shade and colour

Two coats or more coats

One coat or more coats