Loading…
Loading…
Tender Value
₹2.1 Cr
EMD Value
₹4.1 L
Closing Date
7 Aug 2026, 3:30 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
M TENDERS
17 conditions · 4 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet
The tenderer shall possess a valid Electrical Contractor License, issued by any State Government or Union Territory Administration, authorizing execution of electrical works up to 650 V. The contractor shall have in his employment or shall engage a person holding a valid certificate of competency issued by any State Government or Union Territory Administration for supervision of electrical works up to 650 V. Offers not accompanied by a valid Electrical Contractor License and requisite Supervisor competency for works up to 650 V shall be summarily rejected. (Authority HQrs Letter No. No.E.29/P/Similar nature of works dated 07.05.2026)
Definition of Similar Work :- Works of wiring / cabling or installation and commissioning of electrical items (Other than on coaches) such as lights, fans, pumps, charging arrangements, earthing etc (with or without supply of items / equipments) for 230V, 1 Phase or 415 V, 3 Phase system or higher voltages
32 conditions · 3 needing a document upload
The Successful Bidder shall submit (1) Performance Guarantee (PG) amounting to 5% of Original Contract Value and (2) Additional Performance Guarantee of 5% of Original Contract Value for Bid quoted below 5% of Advertised cost.
The Railway Unit Price(s) are inclusive of applicable GST. Offer(s) submitted by the tenderer(s) will be treated as inclusive of applicable GST. Hence, GST will not separately reimbursed by railways. Tenderers are advised to quote their offered rates duly including GST
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
(a)In case of any information submitted by tenderer is found to be false, forged or incorrect at any time during process for evaluation of tenders, it shall lead to forfeiture of the tender Bid Security besides banning of business for a period of up to five years. (b) In case of any information submitted by tenderer is found to be false, forged or incorrect after the award of contract, the contract shall be terminated. Bid Security, Performance Guarantee and Security Deposit available with the railway shall be forfeited. In addition, other dues of the contractor, if any, under this contract shall be forfeited and agency shall be banned for doing business for a period of up to five years.
All terms and conditions in the tender documents are binding on the Tenderers.
Railways reserves the right to accept or reject any or all the tenders and to award the work in whole or in part without assigning the reason for any such action.
The Tenderers are advised to visit the site of work in their own interest and acquaint themselves with the site conditions and expected quantum of work and assess all the site specific difficulties to be experienced while executing the same and the rate shall be arrived duly considering all the facts above and quoted in the tender. Any representation at a later date specifying the site difficulties shall not be consider.
The e-tenders will be opened online using the IREPS portal. No representative is required to be present for opening of tender and taking notes of rates quoted and ranking as the complete details of rates etc. of all the bidders shall be available to the bidders in the website after the opening of the tender.
In case the date of closing mentioned in the Notice Inviting Tender is declared a holiday/bandh/strike etc. on any account, the date of closing tender online will not be changed as the application in the website of IREPS does not permit submission of any offer after closing date and time of the tender. However, opening of tenders online will be on any convenient day after the closing date/time of tenders.
The tenderer shall thoroughly go through the entire tender documents and strictly adhere the instructions and directions given at different pages.
The quantities shown above are approximate and to give a General guideline Railway reserves the right to increase or decrease or to delete any of the item
Tenderer must note that his offer shall invariably accompany all scanned copies of documents required for fulfilling the minimum eligibility criteria. After opening of tender no document will be accepted. Only clarification / verification of credentials will be done.
All requisite documents are to be properly submitted online only and the bidders should ensure that the content of the documents uploaded is distinctly legible/readable.
CORRIGENDUM NOTICE ON IREPS: [I]Railway may modify the tender document by issuing online corrigendum through "www.ireps.gov.in" 15 days prior to the tender closing date. For the purpose of CORRIGENDUM in the tender, NIT period is split as under: (a) ADVERTISEMENT PERIOD: The time during which all information pertaining to tender shall be available but offers cannot be submitted (b) OFFER SUBMISSION PERIOD: 15 days prior to closing of tender, during which tenderers can submit their offer.
Consortium Agreement, Joint Venture and MOU's shall be considered only for works costing more than 10 (Ten) Crore Rupees.
The schedule items in NIT/price schedule shall be read in conjunction with scope of work and explanatory notes along with specification for the respective items for carrying out the work under the respective schedule item adhering to the conditions & special conditions of contract.
Segregation of Electrical cables at various stations, FOBs by provision of SS cable trays in Guntur Division
GNT-10-26-27
GNT-10-26-27
Open
Works - General
6 Months
Guntur, Andhra Pradesh
₹0
₹4.1 L
7 Aug 2026
15 Jul 2026
24 Jul 2026
13 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 2,07,03,756.75 | ||
| — | 21010.31 | — | — | ||
| Design, fabrication,welding, bending supply installation testing and commissioning of required products such as cable trays & tray accessories such as bends, tees, cross, fencing arrangements etc., as per the requirement at site made up of SS-304 grade stain less steel sheets/rods/angles/bolts/nuts. Note: (1) The Design, Scheme, Dimensions & BOM needs to be submitted to Competent Authority for approval before fabrication & supply of desired (2) The payment will be made for the actual weight of SS-304 grade stainless steel | — | — | — | 1,01,90,000.35 | |
| — | Breakup | for details. | — | ||
| Re-Laying and re-connecting of existing cables of sizes 4 core 25/35/50/70/95/120 Sq.mm, LTUG cables in cable trays. | — | — | — | 12,84,754.5 | |
| — | Breakup | for details. | — | ||
| Removal and disconnection of XLPE cables from their position for relaying in the tray of sizes 4 core 25/35/50/70/95/120 Sq.mm, LTUG cables in cable trays. | — | — | — | 4,38,753.5 | |
| — | Breakup | for details. | — | ||
| Supply of 1.1 kV grade, XLPE insulated, Cores laidup, extruded PVC type ST-2 inner sheath, galvanised steel flat strip armoured & overall extruded FRLSH PVC type ST-2 outer sheathed cables with stranded aluminium conductor generally confirming to IS:7098(part-I) 1988. | — | — | — | 84,08,210 | |
| — | Breakup | for details. | — | ||
| Supply of Cable end termination aluminium lugs & Brass Compression Glands | — | — | — | 1,32,313.4 | |
| — | Breakup | for details. | — | ||
| Laying of cables of sizes | — | — | — | 2,49,725 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
TenderScheduleofCableTray.pdf Tender Booklet
ATTACHMENT
TenderScheduleofCableTray.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .