01-AEO/SMP/Repairing of bituminous road from Major Arjun Rai house to Paramananda Nepali High School

Clearing and grubbing road land including uprooting rank vegetation, bushes,shrubs,sapling sand trees girth upto 300mm, removal of stumps of trees cut earlier and disposal of unserviceable material sand stacking of serviceable material to be used or auctioned,uptoalead of 1000 metres including removal and disposal of top organic soil not exceeding 150mmin thickness. (Reference to MoRT&H's specification clause 201)

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 (Reference to MoRT&H's specification clause 305).(With River Bed Materials)

Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with 3 wheeled steel/ vibratory roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate, watering and compacting to the required density (Reference to MoRT&H's specification 404). (9A By Manual Means)

Providing and applying primer coat with cationic bitumen emulsion SS1 grade conforming to IS:8887 on prepared porous granular surface including Clearing of road surface and spraying primer using mechanical means (Reference to MORT&H's specification clause 502).

Providing, laying and rolling of open-graded premix surfacing of 20mm thickness composed of 13.2 mm to 5.6mm aggregates either using viscosity grade bitumen of approved grade to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a smooth wheeled tandem or other approved type roller 8-10 tonne capacity, finished to required level and grades (Reference to MORT&H's specification clause 510). 10(i) Case-I:Mechanical method using approved grade Bitumen and HMP of appropriate capacity not less than 75 tonnes/hour .

Providing and applying tack coat with Cationic bitumen emulsion (RS1) complying with IS:8887 using emulsion pressure distributor on the prepared bituminous/granular /cement concrete pavement surface cleaned with mechanical broom and high pressure air jet (Reference to MORT&H's specification clause 503).

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using. Type A and B seal coats (Reference to MORT&H's specification clause 511) 12(ii)Case - II : Type B Providing and laying of premixs and seal coat with HMP using approved crushed stone chipping and viscosity grade paving bitumen of suitable approved grade.

Display Board (3' x2')

Material Testing

Add CGST 9%