Replacement of Weasel Conductor by Aerial Bunch Cable in different areas of Badowala feeder under EDSD, Ganeshpur under EDD, Mohanpur.

Total amount of the "Rate Schedule" sheet

SCHEDULE OF QUANTITY AND RATE FOR REPLACEMENT OF WEASEL CONDUCTOR BY AERIAL BUNCH CABLE IN DIFFERENT AREAS OF BADOWALA FEEDER UNDER EDSD, GANESHPUR UNDER EDD, MOHANPUR AGAINST E-TENDER SPECIFICATION NO.77/EDCRDDUN/2025-26

Name of The Bidder's Firm:

Part [A] (Supply Portion)

Holding Clamp J-Hook for AB cable

Nut & Bolt

Holding clamp for ST Pole SP-21 With N&B

Universal I Hook

Suspension Clamp With J Hook

Dead End Clamp With I Hook

Mid Span Insulator J Sleeve for LT AB cable

Al. to Al. Connector AB cable 95 to 16mm

Piercing Connector for 95 sqmm -70 sqmm

Piercing Connector for 120-95 mm2

LT Distribution Box 3 Phase 4 Wire

LT DB holding clamp with N&B

Stay Clamp with N&B

Piercing Connector 120 to 35 sqmm

Connector 95-35 sqmm

Head Shrink type end caps for LT AB Cable

LT XLPE Cable 1x16mm2 insulated for DB

Al. Crimping type Lugs 35 sqmm

Total - Part [A]

Part [B] (Labour Portion)

Cartage of ST pole from store centre to construction site with loading, unloading at both points and oroper stacking. (21-50 Km.)

Cartage of other material (other than poles) by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends. (21-50 Km.)

Rs.Per Qtl.

Head load cartage of following Poles from road to site

Upto 0 to 1 Km.

Head load cartage of Small material. Rates are per Km/Quintal including loading and Unloading.

Upto 0 to 1 Km.

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories, like top channel, X-bracing & clamps as per RESPO construction Manual.

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement: 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement, sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO construction Manual.

Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6 (1 cement: 3 coarse sand : 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc.

Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESPO sehedule and local approved drawing.

Dismantling of single PCC Pole

Dismantling of LT line 2 Phase 3 Wire (Weasel)

Dismantling of LT Line 3 Phase 4 Wire (Weasel)

Painting of Sp-21/23 Pole

Excavation of earth for Stay pit of size 0.6x0.6x1.2mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Fixing , tightening and nozzaling of Stay with pole and stay rod on required tension as per drawing / RESSPO manual.

11 KV line

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cernent,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO Manual.

Earthing of support with M.S. Earth rod of 2.5 meter long by hammaring of M.S. Rod to proper depth and connecting the earth electrode with the helpof G.I. wire as per construction manual.

Making of section pole for existing LT/HT/33KV line complete in all respect.

Errection of Bracket in LT Line

Laying of AB cable of Size 120 sqmm

Disconnection & Reconnection of Consumer

Laying of LT XLPE AB Cable 3x95+1x70sqmm

Laying of LT XLPE AB Cable 3x25+25 Sqmm

Providing and fixing of Danger Board complete by providing clamps of MS. Flat 50x5 mm and Nuts & Bolts, danger Boards of M.S. Sheet 2 mm Thick 11"x7" size Including cost of all material)

Sagging/Resagging of ACSR/AB Cable LT line

Laying of LT XLPE Cable

Dismentaling of Section Pole

Realignment of Tilted pole

Opening & Making of Jumper of Section Pole

Renozzling of Existing Stay Set

Back cartage of Petty Material 0-20 Km.

Back Head Load Cartage of Petty material 0-1 Km.

Total - Part [B]

TOTAL [Part-(A) + Part (B)]

Place

Please Enable Macros to View BoQ information