Const. of multipurpose community shed with room at Ondra Reyalla in Pyt. Dub khalsa Block Pouni and District Reasi Under Capex P.R.I (1st Call)

Amount

Earth work in bulk excavation by mechanical means (hydraulic excavator) over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 m2 on plan) including disposal of excavated earth lead upto 50 meters and lift upto 1.5 m, as directed by Engineer-in-Charge.All kinds of soil : including all leads, lift and carriage complete

Earth work in excavation by mechanical means (hydraulic excavator) in trenches for foundations, drains, pipes, cables etc. (not exceeding 1.5 m in width) and for shafts, wells, cesspits and the like not exceeding 10 sqm on plan, including dressing of sides and ramming of bottoms lift upto 1.5 m, including getting out excavated earth and disposal of surplus excavated earth as directed, within a lead of 50 metres: All kinds of soil including all leads, lift and carriage complete

Providing and laying in position cement concrete 1 Cement: 5 fine sand: 10 graded stone aggregate 40 mm nominal sizeexcluding the cost of centering and shuttering - All work up to plinth level including all leads, lift and carriage complete

Providing and laying in position cement concrete of specified grade including curing but excluding the cost of centring and shuttering. All work upto plinth level with:1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size) including all leads, lift and carriage complete

Dupming of Stone including the cost of stones, all leads, lift and carriage complete

Structural steel work in built up sections, trusses and framed work,including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.(welded) including all leads, lift and carriage complete

Providing corrugated G. S. sheet roofing including vertical/curved surface fixed with polymer coated J or L hooks, bolts and nuts 8mm diameter with bitumen and G.I limpet washers or with G.I. limpet washers filled with white lead, including a coat of approved steel primer and two coats of approved paint on overlapping of sheets complete (upto any pitch in horizontal/vertical or curved surface)excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. 0.63 mm thick with zinc coating not less than 275 gram/m2 including all leads, lift and carriage complete

Providing ridges or hips of width 60cm overall width plain G.S. sheets fixed with polymer coated J. or L hooks, bolts and nuts 8mm dia G.I. limpet and bitumen washers complete 0.63 mm thick with zinc coating not less than 275 gram/m2 including all leads, lift and carriage complete

Providing and laying in position specified grade of reinforced cement concrete including curing but excluding the cost of centering, shuttering, finishing and reinforcement. All works upto plinth level 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) including all leads, lift and carriage complete

Reinforced cement concrete work in walls (any thickness) including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts upto floor five level including curing but excluding cost of centering shuttering, finishing and reinforcement. 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) including all leads, lift and carriage complete

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete . Including all leads, lift and carriage complete

Brick work with common burnt clay F.P.S (non modualar) bricks of class designation 7.5 in foundation and plinth in Cement mortar 1:6 (1 cement: 6 coarse sand) Including all leads, lift and carriage complete

Extra for brick work in superstructure above plinth level upto floor V level. (By manual means)

Half brick masonry with common burnt clay (non-modular) bricks of class designation 7.5 in foundations and plinth including curing in : Cement mortar 1:4 ( 1 cement : 4 coarse sand) including all leads, lift and carriage complete

Extra for half Brick masonry in superstructure above plinth level upto floor V level. including all leads, lift and carriage complete

15 mm cement plaster of mix : 1:6 ( 1 cement : 6 fine sand ) Including all leads, lift and carriage complete

12 mm cement plaster of mix : 1:6 ( 1 cement : 6 fine sand ) Including all leads, lift and carriage complete

6 mm cement plaster to ceiling of mix 1 : 3 (1 cement : 3 fine sand)

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead upto 50 m and lift upto 1.5 m. including all leads, lift and carriage complete

Dry stone pitching 22.5 cm thick including supply of stones and preparing surface complete.

Making plinth protection 50mm thick of cement concrete 1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size) over 75mm bed of dry brick ballast 40mm nominal size well rammed and consolidated and grouted with fine sand including finishing the top smooth and curing complete

Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate including all leads, lift and carriage complete

Providing and applying Plaster of Paris putty of 2mm thickness over plastered surface to prepare the surface even and smooth complete

Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works including all leads, lift and carriage complete

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture. including all leads, lift and carriage complete

Centering and shuttering including strutting, propping etc. and removal of form work for: Foundations, footings, bases for columns

Centering and shuttering including strutting, propping etc. and removal of form work for: Lintel, beams, plinth beams, girders, bressumers and cantilevers.

Centering and shuttering including strutting, propping etc. and removal of form work for ; Suspended floors, roofs, landings, balconies and access platforms.

Edges of slab under 20 cm

RAVI KUMAR CONTRACTOR

ASHWANI KUMAR