PROPOSED DEVELOPMENT WORK AT PADAM TIRTH AT SEA SHORE IN BET DWARKA IN WARD 05 FOR OKHA NAGARPALIKA UNDER SJMMSVY UDP-88 YEAR 2025-2026 STREET LIGHT WITH POLE WORK

S. No. DESCRIPTION UNIT QTY RATE LABOUR AMOUNT

Market Rate Supplying and erecting Decorative Street

1 Light Pole with Arm Bracket As Per No 20.00 14650.00 146.50 14796.50

Attached Design

Supplying and erecting LED street light /

Flood light fittings with High power White

LEDs wattage of 3 Watt and above

assembled on single MCPCB, efficiency

more than 130 lm/w and corrosion free

High pressure die cast aluminum housing

with smooth finish powder coated and heat

sink extruded aluminium with diffuser and

Polycarbonate optics/ lenses, with

toughened glass with company mark/name

(Ele. SOR engraved or embossed 160 to

2 I.No. 2.16.2A) V,Power Factor more than 0.95, THD < 10 No 20.00 4948.00 49.48 4997.48

%, CCT 3000 K to 5700K,Uniformity ratio

>0.45, Luminaire efficacy>

lumens/watt . LED driver efficiency >

%.( fittings required LM-79 & LM-80

certificates) (NOTE: Below description

have shown ranges of Wattage capacity of

LED fittings.The Engineer incharge may

select any wattage capacity between the

ranges shown.) (A) Street Light (IP-65),

Surge protection -4KV integral and ,Light

must have 440VAC line supply with over-

voltage protection. Cat-lll (ii) above 48 to

Providing & erecting approved make

street light / wall mounting junction box

compression moulded from SMC

(thermoset plastic) vertical sliding cover

having locking with square head stud No 20.00 353.00 3.53 356.53

loop in / loop out in built terminal

suitable for four core cable, waterproof

of I.P. 54 protected with clamp or bolt

nut & earth bolt of following size.

[A] 200mm x 127mm x 83 mm Size

providing and erecting Miniature circuit

(ELE. breaker single pole 6A to 25A suitable

S.O.R., I. to operate on 240 V A.C. system and

No. 3-10-1B) having breaking capacity 10 KA to be

erected in existing box. confirming to IS

8828/1996 with ISI Mark Cat.-III

Supplying & erecting XLPE(IS:7098)(I)-

88 ISI unarmoured copper cable

1.1 KV grade to be erected as directed Mt 150.00 99.00 0.99 99.99

of following size. (A) 2 core 2.5 Sq.mm

S. No. DESCRIPTION UNIT QTY RATE LABOUR AMOUNT

Providing and erecting

XLPE(IS:7098)(I)-88 ISI armoured

cable multistrand / Solid Copper

6 I.NO conductor for 1.1 KV. to be laid on wall Mt 565.00 359.00 3.59 362.59

- 4-4-4B) with necessary clamps or in existing

trench / pipe at road crossing or floor of

following size of cables. (A-1) 4 core

Supplying and erecting B class

Galvanized iron pipe having smooth

finished bore of the pipe on both ends

7 erected nuts and bolts along the pole / Mt 40.00 247.00 2.47 249.47

wall shaping the pipe as per site

requirement. Pipe dia as following.

Providing & laying approved make

Double walled corrugated pipes (DWC)

of polyethylene(conforming to IS

II )with necessary connecting

I.No. 4.5.8A) accessories of same material at

required depth in existing trench for

laying of cable. below ground / road

surface for enclosing cable (A) 50 mm

Supplying & erecting IP 55 grade

following size section pillar fabricated

from joint less M.S. Sheet with angle

iron legs made from joint less M.S.

Angle with cable clamps to be buried in

ground to have appropriate erection to

work uniform until erected with cement

concrete foundation and 45 cm high

bricks work finishing with plaster etc.

hinged double door internally supported

on both side, with internal and outside

(Electric looking arrangement with look and

9 SOR, I.No. 6- keys in duplicate 35 x 35 x 5 mm M.S. No 2.00 1866.00 18.66 1884.66

6-1) Angle of Two Nos. one is welded and

other with nut and bolt for erecting

Bakelite sheet. Painting the Section

Pillar inside and out side with three

tank powder coated paint. section pillar

roof should be without joint with water

leakage proof & tested as per IP

test & followed by IS 2147 of 1962 (C)

60 X 30 X 45 cm section pillar

fabricated from 16 Gauge MS Sheet

with angle iron legs 45 cm long made

from 35 X 35 X 5 mm thick MS angle.

S. No. DESCRIPTION UNIT QTY RATE LABOUR AMOUNT

Supplying & erecting approved make

Digital time switch having lithium cell

years operative and operate battery

backup 1 channel day clock with

memory programme, suitable to

operate on 240V + 5%, 16A with,

(Electric floating contacts Minimum switching

setup time 1 minimum & LCD display.

Also comprised permanent ON/OFF

switching. Programming switches &

housed in fire proof thermoplastic

enclosure & transparent cover erected

as required with necessary connection

erected as directed. (Electric SOR,

Providing and erecting Approved make

Four pole moulded case circuit breaker

having breaking capacity ICU of 25 KA.

at 415 V,having normal current rating

SOR, I.No. 3- up to 25 A to 100A. with Fixed thermal

11 & magnetic release suitable to work on No 2.00 6112.00 61.12 6173.12

A.C. supply 50 c/s. with all internal

connections, spreader tinned copper &

complete erected in existing 16 G.M.S.

Supplying and erecting approved make

.(Electric suitable panel indicator LED type lamp,

12 SOR, I.No. 9- lens cover, complete erected with No 2.00 43.00 0.43 43.43

2-9) necessary connections

Providing & erecting electronic

.(Electric overload relay with single phasing

13 SOR, I.No. 9- preventer [ (L&T, Alstom, BCH,T.C., No 1.00 5696.00 56.96 5752.96

1-11) Siemens, C&S make).[a] for 30 to

Providing and erecting AC-3 duty

pole A.C. Coil with 2 NO & 2 NC aux

14 SOR, I.No. 9- contacts complete with 415V/220V No 1.00 1421.00 14.21 1435.21

1-10A) operating coil suitable for (L&T,

BCH,T.C., Siemens, C&S make) (a) for

25 / 32 A rating

Providing 1:2:4 cement concrete

foundation & 70 % PCC from bottom

including excavation for the pole of size

(ELECTRIC 60 x 60 x 120 cm. Deep in below

15 S.O.R., I.No. ground level with plinth of 45 cm x 45 No 20.00 1280.00 12.80 1292.80

cm(or 45 cm dia x 45 cm) high upper

ground level with necessary curing and

finishing in approved manner. ( for

& 8/8.5 mtr pole)

S. No. DESCRIPTION UNIT QTY RATE LABOUR AMOUNT

Making trench in Hard Murrum / Tar

Road of suitable width of 90 cm or

(ELECTRIC required depth for laying any size of

16 S.O.R., I.No. cable or locating the fault all over the Mt 565.00 62.00 0.62 62.62

run and back filling the same and

making the surface as normal

Add 18 % GST Charges