Repairing of road and drainage system near Gate No. 1 out side perimeter wall at OFK.

Amount

Rough excavation, in soft/loose soil; n exc 1.5 m deep and n exc 1.5 m in depth and getting out.

Excavating in trenches, in soft/loose soil; n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out.

M & L, Hardcore (Broken stone or boulders) of gauge n exc. 63mm, deposited, spread and levelled in layers n exc. 15cm thick, watered and rammed to a true surface.

M & L, Cement concrete Type C2 1:3:6 (40 mm graded aggregate) in foundations, filling and mass concrete.

M & L, providing reinforced cement concrete (design mix) M-25 (20mm graded aggregate) in Foundations, including rafts, footings, foundation beams, plinth beams, bases for columns, etc.; basement slabs, under-reamed piles and mass concrete.

M & L, Providing reinforced cement concrete (design mix) M-25 (20mm graded aggregate) in Walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilaster and buttresses.

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter, rough finished surfaces of concrete flat.

Formwork to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc.; vertical or to batter, rough finished surfaces of concrete flat.

M & L, Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips.

M&L, Mild steel TMT bars 6 to 8mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips.

M & L, Mild steel TMT bars 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips.

M & L Rendering 10mm thick cement plaster 1:4 on fair faces of brick work or concrete surfaces and rendreing is to be finished even and smooth without using extra cement.

Preparation of new wall surface including cracks filling up to 3mm plastered or unplastered brooming down etc and apply two coat of cement paint . ( Make and colour as approved by Engg In Charge).

dinesh mishra

APM CONSTRUCTION COMPANY

C L BHATIA

C S RAJ SHEKHAR MUDLIAR

SINGH TRADING COMPANY

B.D. TRADERS

R K SETHI