E-TENDER Annual Plan-UKM GP 2025-26 KARUMALA SUBCENTER BUILDING CONSTRUCTION PHASE 2 IN WARD 2

BUILDING

10.25.2:Item Shifted to Sub head 14 as item 14.73 Item Shifted to head 14 as item 14.74 Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works

50.6.1.1:Solid block masonry using pre cast solid blocks ( factory made) of size 40x20x20cm or nearest available size confirming to IS 2185 part 1 of 1979 for foundation and plinth with thickness 20 cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete

13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)

10.1:Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

11.49.2:Providing and laying Vitrified tiles in floor with different sizes (thickness to be specified by the manufacturer), with water absorption less than 0.08% and conforming to IS : 15622, of approved brand & manufacturer, in all colours and shade, laid with cement based high polymer modified quick set tile adhesive (water based) conforming to IS : 15477, in average 6 mm thickness, including grouting of joints (Payment for grouting of joints to be made separately).Size of Tiles 600x600 mm

13.43.1:Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface:Water thinnable cement primer

13.60.1:Wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade:Two or more coats on new work

13.61.1:Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work

OD423504/2025-2026:Providing and fixing galvanised iron profile sheets (size,shape and pitchof corrugation as approved by Engineer incharge) .35 mm(+.05%) .total coated thickness with zinc coating 120 grams per sqm as per IS277,240mpa steel grade ,5-7 microns epoxy primer on both sides of sheet and polyester top coat 15-18 Microns.sheet should have protective guard film of25 microns minimum to avoid scratches during trasportation and should supplied in single length up to 12 metre or as desired by Engineer -in-charge .The sheet shall fixed using self drilling /selftapping screws of size (5.5*55mm) with EDPM seal,complete up to any pitch in horizontal/vertical or curved surface,excluding the cost of purlins,rafters and trusses and including cutting to size and shape wherever required. Detailsof cost for216.14sqm (External diamensions of plinth . Area of roof =20.20*107m =216.14sqm. sheet used =20nos*10.70m*1.06m=226.84sqm and 3%wastage=6.81 Total 233.65sqm.

Please Enable Macros to View BoQ information