Passenger Shed at Plassi Hill Bus Adda W. No. 03

Amount

Earthwork in excavation by manual means in trenches for foundation ,over areas (exceeding 30cm up to 1.50m) in depth as well as 10m on plan including disposal of excavated earth up to 1 mtr. Form cutting edges and disposal of earth and level neatly dressing in 90% AKS and 10% ordinary rock.

Providing and laying in position cement conc. Of specified grade excluding the cost of centering and shuttering all work up to plinth level (1:5:10) (1: cement:5coarse sand:10graded stone agg. 20 mm nominal size)

Providing and laying in position cement conc. Of specified grade excluding the cost of centering and shuttering all work up to plinth level (1:3:6) (1: cement:3 coarse sand:6 graded stone agg. 20 mm nominal size)

Providing /laying R.C.C in (1:1.5:3) mix with 20mm nominal size crushed stones aggregates excluding centering and Shuttering.

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete above plinth level.

Centering and shuttering including strutting, propping etc. and removal of form for:Foundations, footings, bases of columns etc. for mass concrete

Centering and shuttering including strutting, propping etc. and removal of form for:Suspended floors, roofs, landings, balconies and access platforms.

Centering and shuttering including strutting, propping etc. and removal of form for: Edges of slab under 20cm wide

Brickwork with bricks of class designation 75 above plinth level up to floor level in cement mortar (1:6)mix

12mm Cement plaster on brick wall of mix 1cement:6 coarse sand

Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate.

Supply and pacing of stones in Plumb Conc

Providing and laying dry dtone crushed aggrate

Providing and fixing 1mm thick M.S. sheet door with frame of 40x40x6mm angle iron and 3mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer.

MOHD MIAN

AKASH DUTTA

contractor

GOPAL KRISHAN