PROVN OF BOUNDARY WALL AROUND P-76 AT INS DRONACHARYA

Amount

S&F for framed work as in doors or gates of angle or other section with gusset plates, rails,roller, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete, confirming to Fe 410-W(Gde-250)Quality B, complete all as specified and directed

Cutting chases, pinning in,on stone concrete block or slab wall/columns making good to facings where required and pointing in cement mortar 1:3 to ends or edges of landing, steps, cills, sun shades, shelves, lintels, etc; and making good, cutting exceeding 20 cm girth complete all as specified and directed .

M&L for PCC 1:2:4 type B1 (using 20mm graded aggregate) as in bed blocks for fixing hold fasts including use of form work (straight or curved) complete all as specified & directed by Engineer-in-charge.

S&F 1.6 mm thick mild steel plain black sheet in wall cladding ,steel gates and similar work ,cut to size,holes punched etc,fixing to frame work with riveted or welded seams including bending/turning up ,mitered angles etc as required complete all as specified and directed.

M&L for preparation of new or steel surfaces over 10cm width or girth and applying two coats of VX-polymer based anti corrosive paint over a coat of anti corrosive primer complete all as specified.

Material and labour for precast cement concrete (1:2:4) type B0 (using 12.5mm graded broken stone aggregate) louvers and jallies, 50 mm thick (measured solid) and all mould set in cement mortar (1:4) complete all as specified and as directed.

Excavating in trenches not exceeding 1.5m wide and not exceeding 1.5m in depth for foundation etc or for shaft, wells, cesspits, manholes, pier holes etc not exceeding 10 sqm on plan and getting out in soft and loose soil all as specified & directed by Engineer-in-Charge.

Excavating in trenches not exceeding 1.5m wide and exc 1.5 m but n exc 3m in depth for foundation etc or for shaft, wells, cesspits, manholes, pier holes etc not exceeding 10 sqm on plan and getting out in soft and loose soil all as specified & directed by Engineer-in-Charge.

Material and labour for plain cement concrete 1:4:8, nominal mix, type D-2 using 40 mm graded stone aggregate as in foundation, filling and mass concrete, all as specified & directed.

Material and labour for RCC (M-30 design mix, using crushed stone aggregate) as in foundations including rafts, footings, foundation beams, plinth beams, bases for columns etc., basement slabs, under-reamed piles and mass concrete and the like complete all as specified and directed (reinforcement shall be measured and paid for separately).

Material and labour for reinforced cement concrete (M-30 design mix, using crushed stone aggregate) as in columns, pillars etc complete all as specified and directed (reinforcement shall be measured and paid for separately).

Material and labour for reinforced cement concrete (M-30 design mix, using crushed stone aggregate) as in beams, lintels over 1.5 metre span and the like complete all as specified and directed (reinforcement shall be measured and paid for separately).

Material and labour for form work to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundations and plinth beams and similar work, vertical or to batter to give rough finish to flat surfaces complete all as specified and directed.

Material and labour for form work to sides of pillars, columns and similar items (square, rectangular or polygonal) including edges rough finished surface of concrete flat complete all as specified and directed.

Material and labour for form work to sides and soffits of floor or roof beams, beam haunchings, girders, bressummers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. for roughly finished flat surfaces of concrete, all as specified.

Material and labour for mild steel TMT bars 10mm dia & over cut to length, bend to shape required, including cranking, bending spirally for hooping for columns hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified & directed by Engineer-in-Charge.

Material and labour for mild steel TMT bars 5mm and over upto and including 10mm dia in stirrups, spacers and binders, cut to length, bent to shape required including cranking, bending spirally for hoping for columns and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, all as specified.

Material and labour for plain cement concrete 1:2:4 type B-1 using 20mm graded stone aggregate cast in situ in copings, bed plates, water through and the like including weathering, slightly rounded or chamfered angles and throating including use of form work (straight or curved) complete all as specified & directed by Engineer-in-charge. - (i) The unit rate include for use of form work (straight or curved). (ii) Reinforcement if any shall be measured and paid separately.

Material and labour for pre-cast cement concrete block masonry with solid blocks, type B1(1:2:4) using 20mm graded aggregate, exc. 10 cm in width and setting in mortar 1:6, complete all as specified and directed.

M&L for rendering plaster in CM 1:4, 15 mm thick on fair faces of brick work or concrete surfaces finished even and smooth with out using extra cement complete all as specified and directed.

Returning filling in including spreading, levelling, watering and well ramming in layers not exc.25cm thick each layer of soil all as specified.

M&L for two coats of Antifungal paint (Apex ultima Protek of Asian paint or Equivalent in approved Makes) over a coat of Exterior primer (Proffesional pack of Asian paints) over a coat of external wall care putty n.exc 2 mm thick on new or old prepared plastered external surfaces and including scaffoldings and cradles including hoisting and lowering as required with bracing , support complete all as specified.

Removing excavated soil to a distance not exceeding 50 m and depositing where directed at a level not exceeding 1.5 m above the starting point complete all as specified & directed by Engineer-in-Charge.

Supplying laying and testing weather proof flat twin core cable of size 2.5 Sq.mm Size of cable with aluminium conductor including taking down existing cable complete all as specified and as directed

Supply, laying & fixing along the poles/walls or passing through pipes or laid in trenches under floor or through walls etc jointing and testing LT Cross Linked Polythene Insulated (XLPE insulated) galvanized steel strip armoured electric cable, 1100 volt grade heavy duty with aluminium conductor overall served with an outer sheath of PVC complete of size 10 Sqmm 2 Core all as specified & directed by Engineer-in-charge. (Note:- Excavation, earthwork, Sand Cushioning, Cable covers, Pipe for cable protection to be measured and paid for separately).

-Ditto- all as per item No 25 here-in-before but cable of size 16 Sqmm 4 Core

Supply , fill and spread riddle sand, compacting for sand cushioning of under ground cable all as specified . Note: Punned thickness shall only be measured for payment.

Supply and laying common burnt old size sub class B bricks locally available as in cable protection, laid length of brick perpendicular to length of cable complete all as specified and directed.

Supply and fixing for LED Post top with decorative circular design complient to dark sky norms with polycarbonate opal diffuser 45 watt, with IP 65 protection,symmetrical light distribution ,spun aluminium landscape with high power LED as light source,all accessories and pre-wired including fixing arrangement complete all as directed. Make:-Bajaj Cat Part No BGCPNP 45 W LED WW or equivalent in Appendix 'C'

Supply and fixing SMC junction box size of 240x130x95 mm fixed on pole including provn of MCB SP 10 Amps fixed on rail inside box with proper hinges locking arrangements with provn of clamping accessories complete including taking down old unsv item all as specified

M&L for Galvanised Steel Tubing Pipe 50mm bore (dia), light grade with Bend, laid in Trenches or under Roads/ Flooring/ Culverts and/or fixing to Electric Poles with suitable size Mild Steel Flat Iron Clamps, Bolts, Nuts, Washers, etc., complete all as specified and as directed.

M&L for earthing complete with galvanized steel earth plate electrode 600x600x6mm thick buried directly in ground /earth pit not less than 2.25m deep below the ground level with top edge of the plate not less than 1.5 m below the normal ground level connected to GI strip of 32x6 mm by means of nut, bolts, check nuts and washers of galvanized iron or steel as shown in electrical plate No. 3, including necessary earth work and excavation , charcoal dust, common salt, PCC chamber, RCC cover 40mm thick 1:2:4 using 20mm graded stone aggregate reinforced with 6mm dia round bars 75mm C/C both ways, test point and watering pipe complete, including connecting to earthing test point or to DB / Panel complete as directed by Engr in charge and testing resistance etc complete, including taking down old earthing complete all as specified and as directed. Note: (i)The rate quoted shall be deemed to be included for main earth lead from earth electrode to test point up to 7.5 m only. (ii) On testing after completion if the desired earth resistance not obtained as per IE rules the earthing will be redone by the contractor as directed by Engnr in charge with out any extra cost to Govt.

Supply and fixing MCCB, 32 Amps, 3 pole,16KA, 415 volt with adjustable thermal and magnetic release complete all as specified and directed by Engineer-in- Charge. (Make:- Cat Part No IHLGNT0032 of Havell's or equivalent makes mentioned in Appx 'C' as approved by GE).

S & F of 20 mm size non metallic PVC conduit including all fittings and fixing accessories complete all as specified and as directed.

WELTRONENGINEERINGSERVICES

K R JOSEPH AND SONS

SOORYA ASSOCIATES

M/s S & S Enterprises/ Suresh Shivasankarapillai