Periodical Electrical Maintenance work at Vattiyoorkavu Shooting Range, Thiruvananthapuram

Amount

General Electrical Maintenance Works

1.17.3 : Supplying and drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface / recessed steel/ PVC conduit as required. 3 X 1.5 sq.mm

1.17.11 : Supplying and drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface / recessed steel/ PVC conduit as required.2 x 2.5 sq. mm

od37115/2024_2025 : Service of exciting ceiling mounted fans of the following sizes including replacing of the capacitor unit and replacing the canopies, shackles and blades wherever required as Instructed by Engineer-in- Charge

od37116/2024_2025 : Servicing of existing 10KVA online UPS with replace the Power board and charging section including all connections and standard preventive maintenance procedures as specified by Engineer in charge<br>

od37117/2024_2025 : Supply and installation of pre-wired 20W LED batten fitting complete with all accessories and tube etc directly on ceiling/wall, including connection with 1.5sqmm FRLS PVC insulated,copper conductor single core cable and earthing etc as required

od37902/2024_2025 : Supply and fixing of 9W LED Bulb in the existing holder as required

od44680/2024_2025 : Supply and fixing of 20W bulb in the existing holder as required

od37118/2024_2025 : Refilling of Fire Extinguisher 4.0 Kg capacity ABC type by Using Monoammonium phosphate powder ISI,MAP 90

od37120/2024_2025 : Engaging electrician as required

od37122/2024_2025 : Servicing of 1Ton AC units including the compressor, fan motor, evaporator unit and checking the filter units and filling R22 gas required with all accessories

od199520/2024_2025 : Supply of LED recess mounted down light made of die cast aluminium with proper diffusers, along with driver,max system wattage of 18 Watts,lumen output of lamp greater than 1800 lumens, power factor > 0.9, rated life of L70 @ 50,000 hours, system efficacy greater than 100lumen/watt and including all necessary accessories as required complete. (Make:Wipro Mollis LED 18W LD06-221-XXX-57-XX)

90.15.4.5 : Supply Conveyance, installation, testing and commissioning of 40W LED Flood light output greater than 105lumen/W 4000-6000 K with IP 66 protection LED Chip make Cree/Lumilled/Nichea with power factor greater than 0.95 at full load, internal surge protection up to 8 KV,and Aluminium pressure die-cast Powder coated housing, acrylic cover complete with THD less than10%, power factor greater than 0.98, RoHS compliant, duly wired up for use on 230 V AC supply. Driver compartment should be seperatly accessible for maintenance (LM 79&80 certificates from NABL accredited Third party lab to be produced mentioning chip manufacturer)

Lift and AC Maintenance Works

od37109/2024_2025 : Servicing of 3Ton Split AC units including the compressor, fan motor, evaporator unit, PC board checking and cleaning the air filter units and air duct diffuser and filling R22 gas required with all accessories

od37111/2024_2025 : Servicing of 8 passenger lift with clearing/polishing the lift cabin and shaft. Clearing the damaged LED cabin lights with new ones and removing debris accumulated on the top of the cabin. Check all electrical components of failure, wear and tear, or overheating and all component connected to it as per the direction of Engineer in charge

od37114/2024_2025 : Servicing of 8.5 Ton Ductable AC units including the compressor, fan motor, evaporator unit, PC board checking and cleaning the air filter units and air duct diffuser and filling R22 gas required with all accessories

HT Maintenance Works

od37110/2024_2025 : Servicing of MSB panel and SSB, Metering panel checking of proper closing of all pole, contacts and checking IR between phase and earth in an open and closed condition with all accessories complete as required

od37112/2024_2025 : Servicing of 315 kVA Dry-type 1100/433V indoor Transformer including checking the contacts and bushing of the LT/HT Side. Removing dust and carbon particles, greasing/lubrication of parts, and testing of the transformer with all accessories complete as required

od37113/2024_2025 : Servicing of existing LT panels switches and rectifying the internal faults of the switches , Visual inspection of CT’s & PT’s removing the moistures content, Clean and lubricate operating mechanisms and Termination tightness of HV and LV cables connected

POZITIVE POWER INDIA PVT LTD (BID ID -2246523)

Ajayakumar.D (BID ID -2246670)

Bidder Name

Ajayakumar.D

POZITIVE POWER INDIA PVT LTD

SREEJITH S G