SITC of 6 Passenger Lift at office Building of the SDLLRO, Kakdwip

Amount

SITC of Automatic Lift ( as per manufacturer design & as per detailed specification below conforming to IS ) and putting into operation after final testing in the existing lift shaft complete with all accessories and repairing the damage wall / floor if any etc to complete as reqd.

Make : OTIS / KONE / SCHINDLER

Type: 6 Passanger Lift .

Load : 10 Passenger / 408 Kg

Control: Microprocessor based with AC variable voltage & variable frequency (VVVF)

Machine:- Energy efficient machine, Gearless, without Machine Room

Position of Machine Room: NA

Speed: 1 Mtrs./ Sec

Floor served: G + 4

Landing: 5 Stop/5 Opening,, all on same side

Travel : About 15.5 Mtrs (Gr. Floor to 4th Floor)

Operation: Microprocessor based simplex full collective with or without attendant.

Signals: Digital car position indicator,car travels direction indicator in car & at all landing with call registration indicator.

Leveling accuracy:± 5 mm(Micro levelling arrangement )

Car inside : As per design of awardee agency

Car Entrance:Clear Opening 800 mm protected with car door

Car Enclosure: Stainless Steel sheet (20 SWG) with Hairline finish with hand rail.

Car Ceiling & Lighting: Stainless Steel with hairline finish with LED lighting and Fan

Car Ventilation: Pressure fan with anodised aluminium grill.

Car Flooring : Car flooring : Black granite flooring (As per direcion of EIC and according to this Department's Order).

Car Door: Stainless Steel centre opening automatic door provided with V3F controlled door drive system

Landing Door: Stainless steel centre opening automatic door provided with V3F controlled door drive system

Door Opening: Automatic power oprated door with full length Photocell assembly light curtain sensor

PROTECTIVE DEVICES & OTHER ACESSORIES

ARD: Automatic rescue device complete with dry maintenance free batteries as required.for automatic evacuation to the nearest floor in case of power failure / single phasing/others.

Overload Protection:Fully loaded with overload protection.On overloading the lift car will not start with door remaining open and give audio display indication

Emergency lighting in car: Battery operated emergency lighting in the lift car.

Intercom system: Battery operated intercom system in Lift Car, Machine Room & Control Room

Emergency Alarm: Battery operated alarm bell system in lift car and control room

Fireman switch: Fireman switch at main landing terminal.

Voice Synthesizer: Voice announcement system (Voice Synthesizer) in the car to announce the position of the elevator in the hoist way as the car passes or stops at a floor served by the elevator.

Main steel rope /Belt - As per manufacturer's standard conforming to IS

DIMENSION OF SHAFT & POWER SUPPLY

Available Shaft Dimension: 1850mm(W) x 1975mm(D)

Pit Depth :1300 mm

Overhead : 4600 mm

Electric power supply: AC 415 Volt 3phase, 50 Hz, terminated at top@floor as per IS

N.B. 1) Rates should be quoted with minor civil works, wall cutting and mending good the damages to the original finish. 2) Rate should be quoted inclusive of the all taxes & duties, Labour welfare cess, and incl cost of maintenance, servicing, supply & replacement of spares for 3 (three) years from the date of commissioning. 2) Total is rounded off to the nearest rupee and inclusive of Labour Welfare Cess @1% on total amount of above items as applicable.

KONE ELEVATOR INDIA PRIVATE LIMITED