D/o and M/O Village (Providing and Laying Of C.C. On Damage Roads and Repair Of Drains at Different Location in Village Nalgarah), Noida

Earth work in rough excavation, banking excavated earth in layers not exceeding 20cm in depth, breaking clods, watering, rolling each layer with ½ tonne roller or wooden or steel rammers, and rolling every 3rd and top-most layer with power roller of minimum 8 tonnes and dressing up in embankments for roads, flood banks, marginal banks and guide banks or filling up ground depressions, lead upto 50 m and lift upto 1.5 m :

Preparation and consolidation of sub grade with power road roller of 8 to 12 tonne capacity after excavating earth to an average of 22.5cm depth, dressing to camber and consolidating with road roller including making good the undulations etc. and re-rolling the sub grade and disposal of surplus earthwith lead upto 50 metres.

Construction of granular sub-base by providing close graded Material, mixing in a mechanical mix plant at OMC, carriage of mixed Material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per clause 401

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. The contractor has to detect different utilities like sewer line, water supply line, electric cable, telephone cable, gas pipe line etc. using utility detecting machine before start of excavation and shall start excavation only after getting permission of Engineer-in-Charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :1:4:8 (1 cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 20 mm nominal size)

Providing and laying C.C. pavement of mix M-25 with ready mixed concrete from batching plant. The ready mixed concrete shall be laid and finished with screed board vibrator , vacuum dewatering process and finally finished by floating, brooming with wire brush etc. complete as per cifications and directions of Engineer-incharge. (The panel shuttering work shall be paid for separately). (Note:- Cement content considered in this item is @ 330 kg/cum. Excess/less cement used as per design mix is payable/ ecoverable separately).

Sepration Membrane of Impermeable Plastic Sheeting 125 Micron Thick Rate as Per Dsr-2018

Extra for providing richer mixes at all floor levels. Note:- Excess/less cement over the specified cement content used is payable /recoverable separately. Providing M-30 grade concrete instead of M-25 grade BMC/ RMC. (Note:- Cement content considered in M-30 is @ 340 kg/cum)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 10.0 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand)

12 mm cement plaster :1:4 (1 cement : 4 coarse sand)

Neat cement punning

Providing and placing in position 100 mm thick factory made machine batched & machine mixed Precast RCC Rectangular Covers on drains of footpath of various sizes, of M-25 grade cement concrete for RCC work, including cost of centering, shuttering, reinforcement of 8 mm dia TMT bars of Fe 500 grade @ maximum 100mm c/c on both ways , neat cement punning on finished surface, properly encased on all edges with 1.6 mm thick , 100 mm wide MS sheet duly painted over priming coat , reinforcement to be welded at edges with MS sheet and providing 2 Nos. 12 mm dia bar for hooks etc i/c cost of cartage, all leads & lift, handling at site etc. all complete as per direction of Engineer-in-Charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size)

Steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works

Disposal of building rubbish / malba / similar unserviceable, dismantled or waste materials by mechanical means, including loading, transporting, unloading to approved municipal dumping ground or as approved by Engineer-in-charge, beyond 50 m initial lead, for all leads including all lifts involved.

Please Enable Macros to View BoQ information

CAPABILITY STATEMENT

* It is compulsory for the bidder to fill this statement and the bidder must upload only those document that support this statement

Tender Reference No : 30/GM/SM-WC-10/ET/2025-26

Tender :

Name of Tenderer

TOTAL BOQ COST OF PROJECT (In Rs.)

Minimum Value

SOLVENCY (Issued within a period of minimum six months).

EXPERIENCE (WITH GOVERNMENT/SEMI- GOVERNEMTN/ PSUs ONLY) completed works during the last 7 years ending last day of the month previous to the one in which applications are invited

NOT QUALIFIED

NOT QUALIFIED

Two similar completed works each costing not less than the amount equal to 60% of estimated cost put to tender

NOT QUALIFIED

One similar completed works costing not less than the amount equal to 80% of estimated cost put to tender

dsoy lM+d fuekZ.k@Hkou fuekZ.k@ukyh@pkjnhokjh@QqVikFk@ bUVjykWfdax VkbZy@lM+d lqn`<hdj.k@lSUVªy otZ@lh0lh0 jksM@ ckWDl dYoVZ ds dk;Z ds vuqHko izek.k i= ekU; gksxsA tykiwfrZ ,oa lhoj ds vuqHko izek.k i= ekU; ugha gksaxsA

RESULT OF EXPERIENCE

TURNOVER (During the immediate LAST 3 consecutive financial years)

Average annual financial turnover on construction works should be atleast 30% of the estimate cost during the immediate last 3 consecutive fiancial years.

Required Technical Staff

Required Machinary

Character Certificate of Indivisual /partners /directors issued from District Megistrate

Affidavit of not blacklisted

Address Proof/Id. Proof of indivisual /partners/directors.

Registration Certificate of GST

Filled in form Capability Statement.

Certified Copies of relevant pages of following documents:

Affidavit for No Blood Relation in Noida Authority

RESULT