E Tender No 22/EDC(K)/2024-25

Supply Item

Supply of M.S. Holding Clamps (As per Specification of RESPO & UPCL)

Supply of Holding Clamp SP33 with N&B (As per Specification of RESPO & UPCL)

Supply of HOLDING CLAMP FOR PCC POLE (As per Specification of RESPO & UPCL)

Supply of SUSPENSION CLAMP WITH EYE HOOK (As per Specification of RESPO & UPCL)

Supply of Bracing Clamp For ST SP33 Top With N&B (As per Specification of RESPO & UPCL)

Supply of Bracing Clamp With N&B for Pcc Pole (As per Specification of RESPO & UPCL)

Supply of MS CLAMP FOR DEAD END CLAMP WITH N&B

Supply of Dead End Clamp with I Hook (As per Specification of RESPO & UPCL)

Supply of STAY INSULATOR (As per Specification of RESPO & UPCL)

Supply of DIST. BOX WITH N&B ABCABLE 3PH-4WAY (As per Specification of RESPO & UPCL)

Supply of Shear Head IPC L-L 120 -25 sq.mm (As per Specification of RESPO & UPCL)

Supply of Shear Head IPC L-L 120 -120 sq.mm (As per Specification of RESPO & UPCL)

Supply of DANGER BOARD (As per Specification of RESPO & UPCL)

Supply of LT BARE N. CONNECTOR PG CLAMP 95-25mm² (As per Specification of RESPO & UPCL)

Supply of Bolt & Nuts off Size

Supply of MS Clamp with N&B for Suspension Clamp (As per Specification of RESPO & UPCL)

Supply of LT DB Holding Clamp With N&B (As per Specification of RESPO & UPCL)

Supply of LT Bare N Con.PG Clamp For L-L 95-95sqmm (As per Specification of RESPO & UPCL)

Supply of Stay Clamp With N&B (As per Specification of RESPO & UPCL)

Supply of Special Clamp With both Side Hook (As per Specification of RESPO & UPCL)

Supply of Steel Strip

Supply of LT XLPE Cable 1x25 sqmm (As per Specification of RESPO & UPCL)

Supply of Polycarbonate Seal Double Lock (As per Specification of RESPO & UPCL)

Supply of Aluminium Lugs 0 type 25 mm (4x25) (As per Specification of RESPO & UPCL)

Supply of PVC TAPE

Meter Shifting Work

Cartage of the following material by private truck from store centre to work site dump store approx. distance 0 to 20 Km. including loading into truck and unloading at work site. Dump store and carriage from dump store to pit site.

PCC Pole

STP SP-33 Pole

Cartage of other material (other than poles) by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends.

Head Load Cartage of following material road to work site approx. distance 0 to 1 Km. including loading and unloading.

PCC Pole

STP SP-33 Pole

Head load cartage of Small material from road to site

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of Single PCC pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Erection of Single SP-33 pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO construction Manual.

Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6 (1 cement : 3 coarse sand : 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc.

Painting of poles with angle and channel and all steel part by one coat of Rod Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level.

Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESSPO sehedule and local approved drawing.

Excavation of earth for Stay pit of size 0.6x0.6x1.2mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Fixing , tightening and nozzaling of LT Stay with pole and stay rod on required tension as per drawing / RESSPO manual.

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO Manual.

Laying of LT PVC Cable (upto 150 sqmm)

Laying of AB Cable of size 120 sqmm

Installation of Single Phase Meter

Dismantaling of Meter from consumer premises (including opening the meter box seal, TP seal, cable etc.)

Resealing the meter with replacement of existing incoming cable (unarmoured cable) by armoured cable & Replacement of outgoing cable unarmoured wherever required alongwith installation of single phase meter on pole at a height not more than 6 feet ensuring that all arrangements of cable (Incoming & Outgoing) remain visible at all times in all conditions.

Disconnection & Reconnection of Consumer Connection .

Laying of 1x25 XLPE Cable

KUMAUN ELECTRICALS (BID ID -354007)

M/S GOVERDHAN TRADERS (BID ID -354076)