Improvement of LWSS Bhairoon Churtha Yol in Tehsil Shahpur Distt. Kangra HP

Excavation in foundation trenches etc. in earth work in all kinds of soil such as pick work, jumper work, blasting work soft /hard rock, chiesling soft /hard rock where blasting is prohibited, slushy, daldal and saturated soil I/c pumping or bailling out water with in all heights stacking the excavated soil with 15cm layer when required into plinth ,sides of foundations etc. consolidating each deposited layerby ramming and watering and then disposing of all surplus earth as per direction of Engineer-in-Charge Pck and Jumper work with in all leads and lifts .

Providing and laying cement concrete 1:6:12 (1 cement:6 sand: 12 graded stone aggregate 40 mm nominal size) and curing complete excluding cost of centering and shuttering in foundation and plinth.

Random rubble masnory /polygonal rubble (uncoursed/brought to courses) with hard stone of approved quantity in foundation and plinth including levelling up with cement concrete 1:6:12 (1cement: 6sand:12graded stone aggregate 20mm nominal size)in cement mortor 1:6 (1cement:6sand)in breast wall and retaining walls within all leads and lifts.

Brick work using common clay building bricks in foundation and plinth in cement mortar 1:6(1 cement: 6sand) complete within all leads and lifts.

15 mm thick cement plaster in single coat on rough side of concrete walls for interior plastering upto floor level two level including arrisis. Internal rounded angels not exceeding 80mm in girth and finished smooth, cement mortar 1:6 (1cement:6sand).

1.20 mtrs.heigh fencing(as per approved design)1.80 mtrs.RCC posts 3 mtrs.centre to centre and RCC struts with 7 horizontal lines and two diagonals of galvanised steel barbed wire IS-278-1962 type-I) weighing 9.38 kgs/100 mtrs.(minimum)strained and 6mm galvanised steel barbed wire/clips with G.I.binding wire(cost of RCC struts and straining bolts and embended in cement concrete 1:4:8 (1cement:4 sand: 8 graded stone aggregate 40 mm nominal size) and curing complete in all respect and to the entire satisfaction of the Engineer-in-charge.

Steel work welded in built up sections,trusses and framed work, including cutting ,hoisting ,fixing in position and applying a priming coat of red lead paint:- In grating framed guards brass ladeers, railing, brackets and similar works etc. within all leads and lifts.

Providing and fixing 1.80 mtrs High RCC fencing post with 6mm bar ribv as per aproved design (earth work to be measured and paid separately).

Providing form work with steel plates 3.15mm thick welded with angles iron in frame 30x30x5mm so as to give a fair finish i/c centring,shuttering,propping etc.height of propping and centring below supporting floor to ceiling not exceeding 4 mtrs.height of propping and centring below supporting removal of the same for insitu work in: - Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters,buttresses,plinth and string courses and the like within all leads and lifts.

Providing and laying cement concrete 1:5:10 (1 cement:5 sand:10 graded stone aggregate 40mm nominal size)with 15 % plum excluding the cost of form work in retaining wall/brest walls the size of plums shall usually be 150mm to 300mm as per HPPWD specification.