Providing & Fixing Street light on New Valsad Railway Over Bridge LC-98 (Tier-2, Phase-1) Atul wing.Ta.Valsad, Dist.Valsad.

Name of work : Providing & Fixing Street light on New Valsad Railway Over Bridge LC-98 (Tier-2,

Phase-1) Atul wing.Ta.Valsad, Dist.Valsad.

Qty. Item Description with 1% Rs In Words Amount

1 288 Supplying and erecting Flexible PVC insulated multi 58.58 Rupees Fifty

strand multi core 1.1 kv grade ISI marked copper wires Eight And

of following size to be erected as directed. (e) 1.50 Paise Fifty

Sq.mm 3 core round PVC sheathed Eight Only

2 36 Supplying and erecting LED street light / Flood light 5581.26 Rupees Five

fittings with High power White LEDs wattage of 3 Watt Thousand Five

and above assembled on single MCPCB, efficiency more Hundred

than 130 lm/w and corrosion free High pressure die cast Eighty One

aluminum housing with smooth finish powder coated

and heat sink extruded aluminium with diffuser and

Polycarbonate optics/ lenses, with toughened glass with

company mark/name engraved or embossed 160 to

V,Power Factor more than 0.95, THD < 10 %, CCT

K to 5700K,Uniformity ratio >0.45, Luminaire efficacy>

100 lumens/watt . LED driver efficiency > 85 %.(

fittings required LM-79 & LM-80 certificates)(NOTE:

Below description have shown ranges of Wattage

capacity of LED fittings.The Engineer incharge may

select any wattage capacity between the ranges shown.)

(A) Street Light (IP-65), Surge protection -4KV integral

and ,Light must have 440VAC line supply with over-

voltage protection. (iv) 90 - 119 watts watts Cat-lll

3 1 Providing and erecting Approved make Four pole 7469.25 Rupees Seven

moulded case circuit breaker having breaking capacity Thousand Four

ICU of 25 KA. at 415 V,having normal current rating up Hundred Sixty

to 25 A to 100A. with Fixed thermal & magnetic release Nine And Paise

suitable to work on A.C. supply 50 c/s. with all internal

connections, spreader tinned copper & complete erected

in existing 16 G.M.S. housing. ICS=100% of ICU only

Cat III ( Add 10 % extra for Housing)

4 36 providing and erecting Miniature circuit breaker single 297.95 Rupees Two

pole 0.5A to 2A system and having breaking capacity 10 Hundred

KA to be erected in existing box. confirming to IS Ninety Seven

8828/1996 with ISI Mark And Paise

5 1 Providing & erecting 415 V MCB Four Pole for Motor & 811.03 Rupees Eight

Inductive Load (C Curve) having 10KA breaking Hundred

capacity & confirms to IS :8828 in existing box having Eleven And

following capacity (c)63 Amp. Paise Three

6 100 Providing and erecting HOT deep Galvanised iron strip 77.77 Rupees

wire 8 to 16 SWG. Seventy Seven

7 18 Providing and erecting Pipe type earthing having 150 540.35 Rupees Five

cms.long and 2.5 cms. dia. galvanised iron pipe with Hundred Forty

coupling and buch buried in specially prepared earth pit And Paise

complete with necessary 8 SWG earth wire. For using Thirty Five

salt and charcoal / coke as required for pipe type

8 1 Supplying & erecting earth pit of minimum bore 4591.46 Rupees Four

dia.150mm size approved make Earthing Electrode Thousand Five

consisting Pipe-in-Pipe Technology as per IS 3043-1987 Hundred

made of corrosion free hot dipped G.I.Pipes having Ninety One

Outer pipe dia of 50mm having 80-200 Micron

galvanising, Inner pipe dia of 25 mm having 200-250

Micron galvanising, connection terminal dia of 12mm

with constant ohmic value surrounded by highly

conductive compound with high charge dissipation

suitable for following type of applications with chamber

and heavy duty cover. (A)(approved make OEM has to

submit test certificate including value of earth resistance

of installation duly stamped and signed by agency and

officer Incharge has to ensure the value of earthing

resistane mentioned in test Certificate) & having back

filling compound of (B) Inner chemical (CCM

Compound)- Resistivity:- 0.2 ohm / meter testing as per

IEC 62561-2017, Voltage drop:- < 1 volt at no load & dry

form, Sulphar content:- <2%(C) Back fill Compound :-

Earthing compound should be capable to retain

moisture for long time Necessary test report must be

9 ### Providing , erecting , fabricating the M.S. structure as per 77.77 Rupees

requirement on site incorporating proper size of M.S. Seventy Seven

angles,square,round, flats, bars, channels, sections And Paise

complete with cutting, welding, grinding & finishing duly Seventy Seven

painted with one coat of red oxide with erection on site

as per direction of engineer in charge with necessary

grouting, cementing, plastering & finishing complete.

10 60 Providing and erecting XLPE(IS:7098)(I)-88 ISI 220.18 Rupees Two

armoured cable multistrand Aluminium conductor for Hundred

1.1 KV. to be laid on wall with necessary clamps or in Twenty And

existing trench / pipe of following size of cables (A) 3 Paise Eighteen

1/2 core 25 Sq. mm ( 16 Sq. mm 1/2 core)

11 ### Providing and erecting XLPE (IS:7098)(I)-88 ISI 168.67 Rupees One

armoured cable multistrand / Solid Aluminium Hundred Sixty

conductor for 1.1 KV. to be laid on wall with necessary Eight And

clamps or in existing trench / pipe of following size of Paise Sixty

cables (B) 4 core 10 Sq. mm

12 40 Making trench in soft soil of suitable width of 90 cm 55.55 Rupees Fifty

deep for laying cable or locating the fault all over the Five And Paise

run and back filling the same and making the surface as Fifty Five Only

13 20 Making trench in Hard Murrum / Tar Road of suitable 357.54 Rupees Three

width of 90 cm or required depth for laying any size of Hundred Fifty

cable or locating the fault all over the run and back Seven And

filling the same and making the surface as normal Paise Fifty

ground.(B) If additional machinery like hammer driller

14 5 Providing and erecting iron clad cable route marker duly 240.38 Rupees Two

marked with ELE.CABLE of size 23 cm.X 12 cm. Flushed Hundred Forty

with ground in cement foundation as directed by And Paise

Engineer in charge. Thirty Eight

15 20 Supplying following size of Light duty “A” Class G.I . 300.98 Rupees Three

Pipe & erecting as directed by Engineer-in-charge. (B) Hundred And

50 mm dia & laying approved make ISI marked Rigid Paise Ninety

16 ### Providing 69.69 Rupees Sixty

PVC pipe having 6Kg / cm2 (Class-3) to be erected at Nine And Paise

road crossing on or floor as directed for laying of cable. Sixty Nine Only

The pipes as following size of dia & weight per 6 mtr. (B)

50 mm inner Dia. (2.5Kg/6RMT)

17 40 Providing & laying approved make Double walled 73.73 Rupees

corrugated pipes (DWC) of polyethylene(conforming to Seventy Three

IS 14930 II )with necessary connecting accessories of And Paise

same material at required depth in existing trench for Seventy Three

laying of cable. below ground / road surface for

enclosing cable (B)63mm outer dia

18 2 Providing and, fixing heavy duty flange type brass cable 38.38 Rupees Thirty

gland with rubber ring for PVC insulated armoured cable Eight And

complete with out going tails, insulating tape etc for Paise Thirty

following size of cables. (C) 2 to 4 core 10 Sq. mm Eight Only

19 2 Providing and, fixing heavy duty flange type brass 66.66 Rupees Sixty

double compression type cable gland with rubber ring Six And Paise

for PVC insulated armoured cable complete with out Sixty Six Only

going tails, insulating tape etc for following size of

cables. (A) 3 & 1/2 / 4 core 25 Sq. mm

20 144 Solder less crimping type Aluminium lugs conforming to 13.13 Rupees

IS suitable for cable of following size evenly crimped Thirteen And

with high pressure tool & connected to switchgear Paise Thirteen

terminals with brass/cadmium plated nut bolts in an Only

approved manner. (B) 10 Sq.mm

21 8 (C) 16/25 Sq.mm. 15.15 Rupees Fifteen

22 36 Supplying and erecting approved make Octagonal pole 12553.29 Rupees Twelve

made from HR sheet steel. The pole should be made as Thousand Five

per IS. and shall be coated with hot dip galvanizing as Hundred Fifty

per IS 2629/2633/4759, suitable suspend local wind Three And

speed with integral Junction box consist of terminal

plate of min 6mm Hylam sheet, standard profile

35mmX7.5mm Din-Rail for MCB Mounting, stud type

terminal and arrangement for cable termination to be

erected With Suitable foundation (Included) as per

details given by manufacturer considering site

requirement. (E) 7 Mtr. Long 70 mm Top X 135 mm

bottom dia, 3 mm thickness with

225mmX225mmX16mm base plate, 4-M20 Bolts and

600mm long with necessary G.I. J Bolts .Approx Pole

23 36 Providing and erecting street light pole bracket 614.08 Rupees Six

comprising main B Class GI pipe of 4.2 cm/require Hundred

outside dia. complete with suitable B Class G.I

sleeve tubing of approx. 45cms.length and suitable Only

for 76.5 mm / 80mm. / require size pole top having

sufficient fasteners for fixing the brackets and

having spread of 1 mtr. length with suitable rise as

per site condition & suitable welded stiffener

reducer and nipple with check nut complete painted

with one coat of Red oxide / PU base primer and

two coats of Aluminium / PU paint. paint with

24 1 following nos

Supplying of arms.[A]

& erecting Single Arm

approved makebracket

Mtr 17059.91 Rupees

Company fabricated Timer Panel of following capacity Seventeen

for switch On-Off street lights on time scheduling basis Thousand Fifty

made from 16G CRCA sheet duly epoxy power painted Nine And Paise

inside and outside with hinged doors and locking

arrangement consisting of suitable size of 4 Pole MCB

and 4 pole contactor (cat-III)with analog time switch,

auto manual switch of same make and suitable input

and output Bakelite terminals and with door earthing

approved by Engineer in charge. (C) 63 Amp

25 36 carry out RCC Core cutting- up to 100 mm dia./300mm 1549.34 Rupees One

thick Wall/beam/slab with providing PVC pipe of 3 mm Thousand Five

thick inside and necessary finishing on both ends of wall . Hundred Forty

Deputy Executive Engineer, Executive Engineer,

Valsad Elect. R&B Sub-Div. Valsad Elect. R & B Division,