PROVISION OF SOLAR LED PERIMETER LIGHT AND 02 IN NO OF 11 KV RMU

Amount

Supply, installation, testing and commissioning integrated all in one solar LED Based Street Light 40W fittings with High Efficiency Mono Crystalline Solar PV Module, Lithium Ferro Phosphate battery with Inbuilt BMS technology, High Efficacy LED, MPPT Solar Charge Controller & Aluminium Extruded body, All-in-One SSL is specially designed by Progressive Intelligent Dimming which automatically control the dimming and brightness of liht, which increase the backup time Solar PV Module 12V 60W Mono-crystalline, Battery (LiFeP04) wih BMS 12.8 V 24 Ah, Backup 2 days with Dimming, Solar Charge Controller MPPT Solar CHarge Controller Capacity 12V, 6A Efficiency > 125 lumen / watt, Lumen Output > 5000 lumen, Life Span > 50000 hours, Driver In Built DC- DC type, Body Alumminium Extruded Body, Dust and Water Protection IP 65 Standards Low-Voltage indication Red LED, Charging indication Green LED, Other protections. (a) Over-Cgare protection (b) deep-discharge protection (c) Over current protection (d) Short circuit protection (e) Over voltage protection, DUsk to dawn operation provided mounting height 5M, Humidity range 0 to 95 % (non-condensing) Temperature rane -10 to +55 C, Dimensions 1230x382x55 mm, gross weight 18k complete all as specified and directed. Make : Havells cat part No. SSSSLX0131 or equivalent model of Crompton / Bajaj. Note : Warrenty of 02 years for panel, light and battery included in above quoted rates.

Excavation in trenches in hard /dense soil not exceeding 1.5 mtr deep and not exceeding 1.5 mtr wide for laying of cables, RCC poles/stays and struts etc and getting out including trimming sides and forming bottom surface all as specified and directed at site.

Returning, filling in including spreading, leveling, watering and well ramming excavated soil in layers not exceeding 25 cm thick each, back in trenches after cables have been laid and tested, poles, stays , struts have been erected and tested , all as specified and directed at site

Removing excavated surplus soil (Soft/hard soil) obtained from excavation to a distance not exceeding 50 mtr and depositing where directed at a level not exceeding 1.5m above the starting point all as specified and directed.

M&L for PCC type D2, 1:4:8 (40 mm graded aggregate) as in foundations of poles complete all as directed by Engr-in-Charge.

Supply and install steel tubular MS Swaged tubular poles complete with MS base plate, 300x300x6mm, nuts and taper plug, bolts, nuts and screws as specified type (6.0m long) (114.3x88.9x76.1 mm OD 3.65x3.25x3.25 mm thick) (3.00+1.5+1.5 mtrs Section) lenth with single arm bracket of 48mm OD x 1 mtr Lon for LED Street light fixture complete all as specified and directed.

Supply , Installation , Testing and commissioning 11kV, 630A, 21kA/3sec, 4Way Outdoor, Extensible motorized SCADA compatible RMU consisting of 2Nos. feeder with Load Break Switch and 2Nos. feeder with VCB. | <2LBS + 2VCB+M> Make : C&S (C sec technologies pvt ltd) or equivalent in ABB / Areva / Crompton Greaves / L&T Each Incomer feeder with Switch consists of: 1. Motorised 630A load breaker switch with built-in earth switch with full making capacity. 1 No. 2. Mechanical position indicator. Switch ON/OFF/EARTHED. 1 No. 3. Live Cable Indication. 1 No. 4. Cable compartment cover interlocked with earth switch. 1 No. 5. Cable termination bushings suitable for 3 no. 1CX300mm2 XLPE cable. 3 No. 6. Cable compartment cover interlocked with earth switch. 1 No. 7. Cable termination bushings suitable for 1no. 3CX300mm2 XLPE cable. 3 Nos. 8. Cable termination cover boots (Push on type) NO/NC contact for: • Isolator ON/OFF • Earth Switch ON/OFF • Fault Indicator Operated Command Output for: • Isolator Close • Isolator Open • FPI reset 1 Set.

Each Outgoing VCB feeder consists of: 1. Motorised 630A Vacuum Circuit Breaker with manual spring charging arrangement and manual close & open push buttons, ON / OFF indication and series trip coil for self powered relay & shunt trip coil for external tripping. 2. Self powered Numerical O/C & E/F relay with CTs. 3. Manually operated 630A load breaker switch with built-in earth switch with full making capacity. 4. Mechanical position indicator. Switch ON/OFF/EARTHED. 5. Live Cable Indication. 6. Cable compartment cover interlocked with earth switch. 7. Cable termination bushings suitable for 1no. 3CX300mm2 XLPE cable. 8. Cable termination cover boots (Push on type) NO/NC contact for: • Breaker ON/OFF • Relay operated.

Supply, laying & testing cable XLPE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty)with stranded aluminium conductor, 11000 volts grade, of size 3 core 95 sqmm complete all as specified and directed.

S& F in replacement of laying of Double Walled Corrugated (DWC) HDPE pipe 90/75 mm outer/inner dia size of conforming to IS 16205 Part -24 including necessary bends, coupling, tees, reducers, spacers, end caps, rubber rings etc having pressure rating not less than 450 N through trenches/wall/floor/on pole in any type of soil for protection of electric cable complete all as directed by Engr-In Charge.

Earthing complete with galvanised mild steel earth plate electrode 60cmx60cmx6mm thick buried directly in ground vertically (earth pit not less than 2.25mtr deep below ground level) with top edge of the plate not less than 1.5mtr below normal ground level Galvanised earth plate connected with GI earth strip 32x6mm by means of lug, bolts, nuts, check nuts, washers of galvanised iron GI protection pipe 40mm bore light grade all as shown in elect plate No 3 of SSR part I - 2009 and connecting to main switch board / Main DB’s including excavation, earth work in any type of strata, salt and charcoal dust mixed and packed 150mm thick around GI earth plate, GI pipe medium grade 20mm nominal bore as watering pipe GI sheet funnel wire mesh, concrete pit, RCC cover 40mm thick in PCC 1:2:4 type B1 duly reinforced with CRS Bars 8mm dia at the rate of 100mm centre to centre both way with 12mm dia lifting handle and pit / chamber constructed 50 cm away from the edge in PCC 1:3:6 type C1, Angle iron 40x40x3mm frame for pit cover including testing on completion complete all as specified and directed.

Rama Electricals

RAJ ENTERPRISE

RAVINDRA BROTHERS

SANVI ASSOCIATES

ALBA AC AND REF SERVICES

SURESH ELECTRICALS

vijay infraprojects pvt ltd

Abhishek Enterprises

Nitesh Enterprise