PROVISION OF GRILLED GATE AT THE ENTRANCE OF STAIRCASE IN GROUND FLOOR OF CERTAIN BUILDINGS AT SMA RAMESWARAM AND PROVISION OF CHAIN LINK FENCING AROUND TRANSFORMER LOCATED NEAR P-10/11 BUILDING AT PAMPA VIHAR ANNEX UNDER GE FORT KOCHI

Amount

Cutting holes into or through brick walls built in cement mortar and making good in cement mortar 1:3 or cement concrete 1:2:4 type B-1 as required superficial area exc 150 sqcm but not exc 400 sqcm complete all as specified and directed.

Supply and fix framed work such as grill grating etc, with ends of bars shouldered and/or riveted or forged into spikes framed guard bars: barred iron door hung as gates including pintle hinges stops handmade sliding bolt etc. ladders framed balusters walk ways railing framework of water tank and similar work conforming to FE-290 Gde-E-165 complete all as specified and as directed.

Material and labour for preparation of new steel surfaces of any descriptions over 10cm in width or girth not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed.

Material and labour for preparing newly plastered surfaces of wall & applying two coats of distemper with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gms/litre, of approved manufacturer, of required shade and colour complete, as per manufacturer's specification over a coat of alkali resistant primer over one coat of wall care putty (minimum thickness 1mm) each and complete all as specified and as directed.

Excavation in trenches, not exceeding 1.5 m wide and not exc 1.5 m in depth for foundation, laying of pipes etc. and not exceeding 10 sqm on plan for manholes etc. and getting out in soft/ loose soil, complete all as specified and as directed.

Surface excavation not exc 30 cm deep and averaging 15 cm deep and getting out in soft/loose soil complete all as specified and as directed.

Material and labour for hard core of gauge not exc 63mm deposited, spread and levelled in layers not exc 15cm thick watered and rammed to a true surface complete all as specified and as directed.

Material and labour for cement concrete in foundations using type C2 1:3:6 (40 mm graded stone aggregates) complete all as specified and as directed.

Material and labour for 75mm thick PCC 1:4:8 type D-2 (using 40mm graded crushed stone aggregate) as in sub base of floor etc. finish the surface even and smooth without using extra cement, complete all as specified and as directed.

Material and labour for sand as in cushioning, for floors, under paver blocks etc. including watering and consolidation, complete all as specified and as directed.

Material and labour for machine pressed precast concrete interlocking paver block of approved shape and size with grey cement no pigment conformed to IS 15658-2006 of 60 mm thickness M-35 grade complete all as specified and as directed.

Material and labour for cement concrete, 1:2:4, type B1 using 20mm graded aggregate as in lintel up to 1.50 m span, cills, steps, seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings up to 60 cm in height, copings, kneelers, apex stones, bed plates, kerbs not provided for in item 04028, water thoughs and the like including weathering, slightly rounded or chamfered angles and throating, all as specified and as directed.

Material and labour for Precast cement concrete 1:2:4 type using (16mm graded aggregate) hollow block masonry exc. 10 cm in width and setting in cement mortar 1:4 complete all as specified and as directed.

Material and labour for rendering 15 mm thick on fair faces of brickwork or concrete surfaces in cement mortar (1:4) with WPC and finished even and smooth without using extra cement complete all as specified and directed .

Material and labour for applying two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10sqm over new surfaces over 1mm thick wall care putty on wall to get a smooth and tint free surface, up to 4 storey height complete all as specified and as directed. Note: Painting work on wall including preparation of surfaces shall be carried out using hand held mechanical sanding machines only. The work shall be executed through paint manufacturer/ authorized applicator of manufacturer’s only.

Supply and fix for angle iron fencing posts including cutting tops to shape as directed, drilling holes, notching for wire etc. (for securing wire mesh etc) including all necessary drilling, bolting or riveting, flat iron for fixing of chain link fencing etc. and similar work conforming to Fe 410-0 or Fe 310-0 complete all as specified and as directed.

Supply and fix Galvanized chain link fencing of size 50x50x3mm PVC coated, weight not less than 2.18 Kg/Sqm, fixed tightly to angle iron fencing post and securing etc. complete all as specified and as directed.

Supply and fix Mild steel screw bolts (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, of dia 11 to 15 mm and length of bolt exc 5cm and not exc 10cm long complete all as specified and as directed.

Material and labour for applying two coats of epoxy paint over a coat of epoxy primer on new steel surfaces of any description over 10 cm width or girth etc. complete all as specified and as directed.

Supply and fix 10 mm dia round bars and over as in reinforcement, cut to length, bent to shape required including cranking, bending spirally or hooping for columns, hooking ends and binding with MS wire (annealed not less than 0.9mm dia), complete all as specified and as directed.

Returning, filling in excavated soil including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick, complete all as specified and as directed.

Removing surplus excavated soil to a distance not exc 50 m and depositing where directed at a level not exceeding 1.5 m above the starting point, complete all as specified and as directed.

Material and labour for cement concrete using type C-1 1:3:6 (using 20mm graded stone aggregate) as in surface channel and drains, all as specified and as directed.

M/s.Rejoy Constructions (BID ID -3514401)