Construction of Temporary Barrack in Cachar District with providing Electrification with CCTV Camera at Digarkhal Check Gate

Amount

Clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared.

Earth work in excavation by mechanical means (Hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-incharge. 2.7.1 Ordinary rock

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: 6.1.1 Cement mortar 1:4 (1 cement : 4 coarse sand)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : (4.1.8 )1:4:8 (1 Cement : 4 coarse sand (zone-III) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)

Dry brick pitching half brick thick in drains including supply of bricks and preparing the surface complete : 16.12.1 With common burnt clay F.P.S. (non modular) bricks of class designation 7.5

Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete. 11.3.1 40 mm thick with 20 mm nominal size stone aggregate

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete.

Earth work in excavation by mechanical means (Hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-incharge. 2.7.1 Ordinary rock

Providing and fixing 35 mm thick factory made laminated veneer lumber door shutter conforming to IS : 14616 and TADS 15:2001 (Part B), fixing with butt hinges of required size with necessary screws, all complete as per directions of Engineer- in-charge and panelling with panels of : (Note:- Butt hinges and necessary screws shall be paid separately)9.6.1 12 mm thick plain grade -1, medium density flat pressed three layer particle board FPT - I or graded wood particle board FPT- I, IS : 3087 marked, bonded with BWP type synthetic resin adhesive as per IS : 848 :

13.50.1 With ready mixed pink or Grey primer of approved brand and manufacture on wood work (hard and soft wood)

13.50.2 With ready mixed aluminium primer of approved brand and manufacture on resinous wood and plywood

10.31 Providing and fixing angle iron frames for doors, windows and ventilators of mild steel Angle sections of size 35x35x5 mm, joints mitred and welded by angle iron 35x35x5 mm or 35x 5 mm flat pieces to the existing T-iron frame or to the wall with dash fastener, including fixing of necessary butt hinges and screws and applying a priming coat of approved steel primer, all complete as per the direction of Engineer-In-charge.

Construction of Barrack of wodden structure, GCI Sheet wall and roofing with wooden post, Post Plate , Tie , King & Quuen post fixing with nails and fixing GCI Sheet over timber purlins with screws etc complete. The GCI Sheet wall should be fixed by nails with the wodden structure with post, bracing and ties etc complete as specifified and directed.

Wiring for light point/ fan point/ exhaust fan point/ call bell point with 1.5 sq.mm FRLS PVC insulated copper conductor single core cable in surface/ recessed medium class PVC conduit, with piano type switch, phenolic laminated sheet, suitable size M.S. box and earthing the point with 1.5 sq.mm. FRLS PVC insulated copper conductor single core cable etc as required. Group B

Wiring for circuit/ submain wiring along with earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required. 2 X 1.5 sq. mm + 1 X 1.5 sq. mm earth wire

Wiring for circuit/ submain wiring along with earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required. 2 X 2.5 sq. mm + 1 X 2.5 sq. mm earth wire

Wiring for circuit/ submain wiring along with earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed medium class PVC conduit as required. 2 X 4 sq. mm + 1 X 4 sq. mm earth wire

Supplying and fixing following piano type switch/ socket on the existing switch box/ cover including connections etc. as required. 5/6 amps switch

Supplying and fixing following piano type switch/ socket on the existing switch box/ cover including connections etc. as required. 3 pin 5/6 amp socket outlet

Supplying and fixing metal box of 180mm X 100mm X 60mm deep (nominal size) on surface or in recess with suitable size of phenolic laminated sheet cover in front including providing and fixing 6 pin 5/6 & 15/16 amps socket outlet and 15/16 amps piano type switch, connection, painting etc. as required.

Supplying and fixing metal box of following sizes (nominal size) on surface or in recess with suitable size of phenolic laminated sheet cover in front including painting etc as required. 180 mm X 100 mm X 60 mm deep

Installation, testing and commissioning of pre-wired, fluorescent fitting / compact fluorescent fitting of all types, complete with all accessories and tube etc. directly on ceiling/ wall, including connection with 1.5 sq. mm FRLS PVC insulated, copper conductor, single core cable and earthing etc. as required.

Installation, testing and commissioning of ceiling fan, including wiring the down rods of standard length (upto 30 cm) with 1.5 sq. mm FRLS PVC insulated, copper conductor, single core cable etc. as required.

Supplying and fixing PVC batten/ angle holder including connections etc. as required.

Supplying and fixing following way, single pole and neutral, sheet steel, MCB distribution board, 240 volts, on surface/ recess, complete with tinned copper bus bar, neutral bus bar, earth bar, din bar, interconnections, powder painted including earthing etc. as required. (But without MCB/RCCB/Isolator) 2 + 4 way/6 way, Double door

Supplying and fixing 5 amps to 32 amps rating, 240/415 volts, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required. Single pole

Supplying and fixing 5 amps to 32 amps rating, 240/415 volts, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required. Double pole

Earthing with G.I. earth pipe 4.5 metre long, 40 mm dia including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe etc. with charcoal/ coke and salt as required.

Supplying and laying 6 SWG G.I. wire at 0.50 metre below ground level for conductor earth electrode, including connection/ termination with GI thimble etc. as required.

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground including excavation, sand cushioning, protective covering and refilling the trench etc as required. Upto 35 sq. mm

Supplying and fixing of 32 mm dia X 2.00 metres long G.I. pipe (medium class) bracket for mounting of fluorescent / HPMV / HPSV street light fitting on pole including bending the pipe to the required shape, 2 nos 40 mm X 3 mm flat iron clamps with nuts, bolts and washer, painting the flat iron with primer and finish paint etc. as required.

Erection of steel tubular or rail pole strut in cement concrete 1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 40 mm nominal size ) foundation including excavation and refilling and secured with holding clamps, bolts, nuts, etc. as required.

Supplying with fitting & fixing of LED batten tube light-20watt 4th length including connection etc. (Anchor, Panasonic or equivalent make).

Supplying of A/C Ceiling fan of the following sweep model etc. without regulator.Eco Ceiling fan 1200mm W/O Reg. white (Orient make).

Supplying with fitting fixing of 7watt LED bulb.(ANCHOR/PANASONIC).(as per CO’s price)

Supplying with fitting & fixing of LED Street light in aluminum Pressure dia cast housing with toughened glass cover IP-66 rating (Jaguar make) item code-LSRT01S060Xc, 60Watt.

Supply of following size PVC/XLPE insulated and PVC sheathed 1.1KV grade solid Aluminum conductor up to 10sq mm balance slandered conductor XLPE insulated cores laid up PVC tape inner sheathed Armour (galvanized wire for cable up to 2x10 sqmm galvanized steel strip.) extruded PVC type ST2 sheathed 650/1100 volts grade as per IS.7098(Part-I) 1988. (R.R. Kable or equivalent make).10sqmm 2-core.

Payment to be made to APDCL for load security and fixed charge as per APDCL norms.

MS Steel Tubular Pole SP-30 (As per APDCL Schedule of rate. No-383)

CI Earth pipe 1.8m Inner dia 100mm, Outer dia 110mm (As per APDCL Schedule of rate. No-203)

Supplying, including installation, Testing & Commissioning of – 2 MP IP Dome Camera (SAMSUNG HONEYWELL/PANASONIC make)as per direction and specified by the Deptt.

Supplying, including installation, Testing & Commissioning of – 2 MP IP Bullet Camera (SAMSUNG HONEYWELL/PANASONIC make) as per direction and specified by the Deptt.

Supplying, including installation, Testing & Commissioning of - 16 Chanel CIF Real Time NVR (SAMSUNG HONEYWELL/PANASONIC make)as per direction and specified by the Dept.

Supplying, installation of BNC connection , rj45 D lInk as per direction and specified by the Deptt

Supplying, including installation, Testing & Commissioning of Hard Disk For NVR 2 TB NVR (SEAGATE/WD make) as per direction and specified by the Deptt

Supplying, including installation, Testing & Commissioning of 32 " Monitor (SAMSUNG /PANASONIC or equivalent make) as per direction and specified by the Deptt.

Supplying, including installation, Testing & Commissioning of 8 port L2 PoE Switch as per direction and specified by the Deptt.

Supplying, including installation, Testing & Commissioning of HDMI Cable 5 Mtr as per direction and specified by the Deptt.

Supplying including installation of Inverter (Exide/Su-Kam/ Microtech/ V-Guard/ Luminous as per direction and specified by the Deptt. Sine wave Inverter 800 VA/12 V

Supplying including installation of Inverter Battery(Exide/Su-Kam/Microtech/V-Guard/ Luminous as per direction and specified by the Deptt. 150 Ah, 36 Months warranty

Supplying, of LAN System Rack works accessories as directed and specified by the Deptt.

Supplying, including installation, Testing & Commissioning of LAN networks equipment’s Solid Copper Cable Cat 6, LEGRAND or equivalent make as approved by the Deptt.

Installation Charge

Supplying and fixing following piano type switch/ socket on the existing switch box/ cover including connections etc. as required. (1.23.3) 15/16 A switch

Wiring for circuit/ sub main wiring along with earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed steel conduit as required. (1.7.1) 2 X 1.5 sq. mm + 1 X 1.5 sq. mm earth wire

Supplying and fixing of following sizes of medium class PVC conduit along with accessories in surface/recess including cutting the wall and making good the same in case of recessed conduit as required. (1.21.2) 25 mm

BIPROJIT CHAKRABORTY (BID ID -262823)