SPECIAL REPAIRS TO OVERHEAD LINES ON NANDA ROAD RAJOURI MARG AND GF ROAD AT BEG AND CENTRE UNDER GE (CENTRAL) KHADKI

Amount

Taking down ACSR conductor from HT/LT Pole with any type of insulator all as specified and as directed by Engr-in-Charge

Excavation in trenches nexc 1.5 mtr wide and n exc 1.5 mtr in depth and getting out in hard/dense soil for laying cables, erection of poles complete all as specified and directed by Engr-in-Charge

Returning, filling including spreading, levelling, watering and ramming in layers not exc 25 cm in soft/loose soil complete all as specified and directed by Engr-in-Charge

Removing surplus excavated soil nexc 50 mtr and depositing where directed at a level n-exc 1.5 mtr above the starting point complete all as specified and directed by Engr-in-Charge

Supply, laying and testing in trenches or passing through pipe or duct , XLPE PVC insulated (heavy duty) galvanised steel strip or wire armoured electric cable 11000Volt (E) Grade with stranded aluminium conductor for cross sectional area 95 sqmm 3 core complete all as specified and directed by Engr-in-Charge.

S&F Cable joining kit for 11 KV (Earthed) grade cable for outdoor termination heat shrink type joint complete with joining material and accessories suitable for 3 core XLPE armoured aluminium conductor cable suitable for 95 sqmm.

S&F Cable joining kit for 11 KV (Earthed) grade cable for indoor termination heat shrink type joint complete with joining material and accessories suitable for 3 core XLPE armoured aluminium conductor cable suitable for 95 sqmm.

S&F Cable joining kit for 11 KV (Earthed) grade cable for straight through heat shrink type joint complete with jointing material and accessories suitable for 3 core XLPE armoured aluminium conductor cable of size 95 sqmm.

PCC (1:3:6) type C-2 using 40mm graded aggregate as in foundation for filling in, mass concrete for foundation of Pole, Transformer, Panel board, stay, post top lantern, repairs to road cutting, drain, path etc complete all as specified and directed.

M &L for fixing or passing through pipe, laid in trenches or fixed to pole/wall or fixed to LT panel board, 1100 volts grade heavy duty cable with PVC insulated stranded aluminium conductor served with inner sheathing of PVC tape, armoured with galvanised steel wire or tape and overall PVC sheathed 10 sqmm 4 core with required aluminium cable lugs, heat shrink joints, Colour code heat shrink sleeves at both cable ends all as specified and directed.

All as per item No. 10 above but 35sqmm 3,5 core complete all as specified

All as per item No. 10 above but 70sqmm 3.5 core complete all as specified

All as per item No. 10 above but 120sqmm 3.5 core complete all as specified

All as per item No. 10 above but 240 sqmm 3.5 core complete all as specified

S& F for HDPE Double wall corrugated pipe (DWC) conforming to IS-14930(Part-II) of size-120 mm including snap fit coupler as required, for cable protection

All as per Sr No 15 above, but size 90 mm complete

All as per Sr No 15 above, but size 63 mm complete

All as per Sr No 15 above, but size 40 mm complete

M&L for GI pipe light grade laying in trenches/ under floor/on walls for protection of UG cables all as specified and directed of size 100mm dia.

All as per Sr No 19 above , but size 40 mm complete

All as per Sr No 19 above , but size 50 mm complete

M & L for Earthing complete with galvanised steel pipe electrode, 40mm bore, medium grade, 3 mtr long buried directly and vertically in ground with top edge at ground level after making bore hole of size not less than 300 mm dia and 3.0 Mtr long using suitable mechanical drilling rig (for drilling near the specified location), connected with galvanised steel earthing lead of 25x6 mm all as shown in Plate No-2, connected to the earthing test point, concrete pit in PCC 1:3:6 type C-2 with pit cover, funnel, wiremesh, 32 mm dia light grade GI tubing for protection of GI strip 25x4mm, charcoal and salt in alternate 150mm thick layers around GI earth pipe, including necessary returning filling in & removal all as specified or indicated in SSR Part-I, including testing to achieve earth resistance value as per IS specification on completion.

M & L for three core PVC insulated unsheathed 1100 volt grade multi stranded FRLSH Copper conductor cable of size 1.5 sqmm (Nominal area) drawn through PVC Conduit and OH line/ street light to pole box all as specified and directed.

S & F Fstreet light pole box (SMC) type suitable for fixing on LT pole size 30cmx25 cmx15cm with side hinged door and locking arrangment and suitable for terminal single phase including MCB 6-10A SP and fixing in position with nut, bolt, clamp, disconnection and reconnection of service wire/UG cabel in box all as specified and directed.

S & F for Heat shrink straight through joint LT 1100 volts grade 25-50 sqmm, 4 core, make-Raychem, Cat No-EPKJ0130 or equivalent of M-Seal/MS Seal/3M

Supply, install, testing and commissioning of factory made outdoor type sheet metal enclosure cable jointing box CPRI approved and IP-56 of 3 way suitable for HT 11 KV grade 3 phase 3 wire system with 09 Nos epoxy insulators and 03 Nos copper bus bar suitable for one incoming and two outgoing of size 1200x1200x 750 mm and made out of 3.15mm powder coated CRCA sheet having gasketed front hinged split doors with bottom detachable gland plate for upto 3 cable entry/exit of size upto 95 sqmm with suitable size of cadmium plated and nuts, bolts and washers and incl vermin, dust & weather proof, bottom hole, outdoor triple key weather proof pad lockings. The panel shall be powder coated, colour red and iron angle base of panel size of 50x50x06 mm embedded 300 mm below ground level in PCC 1:3:6 type B-2 using 20 mm grade stone aggregate, 500 mm above ground level with complete all as specified and directed. Note : PCC will be measured separately in this schedule.

Supply, install, testing and commissioning outdoor feeder pillar box fabricated from factory of suitable size as per MCCB cabinet & misc items made with 3 mm thick CRCA sheet with hinged door front and rear locking arragements for each cabinet, 2 mm thickness of partion sheet including painting with super enmaled paint of two coat over a coat of red oxide primer and black at bottom after antirust treatment of CRCA sheet top cabinet with incoming 3 phase & neutral and bus bar rating current 1.5 times with IP 56 protection. The feeder pillar shall be provided with two Nos of earth terminal hinged door, front and rear door with locking arrgagement suitable for 1100 Volts grade, 3 Phase, 415 Volts, 50 Cycles, AC suppply, LT danger notice plate front and rear, The panel shall be embedded 300 mm below ground level in PCC 1:2:4 Type B-1 using 20 mm grade stone aggregate, 500 mm above ground level including dismentling old unserviceable panel by disconnecting of cabe and reconnection of cable in panel complete all as directed by Engr-in- Charge with follwoings :-

Incomer

MCCB FP 36 KA 320 Amp -01

Outgoing

(a) MCCB TP 36 KA 250 Amp -01

(b MCCB TP 36 KA 125 Amp -02

(c) MCCB TP 25 KA 63 Amp -01

d) MCB TP 32 Amp, 10 KA - 02 No

(e) MCB DP 32 Amp, 10 KA - 2No

(f) LED type indicator lamp - 03 Nos

(g) Internal wiring with suitable size

(j) Ameter 0-500 Amps -01 No

(k) Voltmeter 0-500 Volts - 01 No

(l) Timer switch 440 V, 50 Hz three phase 40 Amps for automatic ON/OFF operatiion as well as bypass arrangement of street lights feeder complete with 01 No contactor (01 Set)

All as per item No 27 but for Feeder Pillar box with folliowing :-

Incomer MCCB TP 36 KA 250 Amp -01

Outgoing (a) MCCB TP 25 KA 200 Amp - 01

b) MCCB TP 25 KA 63 Amp -02

(c) MCB TP 32 Amp, 10 KA - 02No

(d) MCB DP 32 Amp, 10 KA - 01 No

(e) LED type indicator lamp - 03 Nos

(f) Internal wiring with suitable size

(h) Ameter 0-500 Amps -01 No

(j) Voltmeter 0-500 Volts - 01 No

Priyanka Power line (BID ID -3061175)

MANGAL ELECTRICAL STORES (BID ID -3061956)

Om Construction (BID ID -3061640)

ONKAR ELECTRIC AND GENERAL STORE (BID ID -3062568)

Shri Sai Electricals (BID ID -3056864)

M/S. Niksun Electro-Infra Private Limited (BID ID -3062190)

Horizon Construction (BID ID -3061903)