PROVN OF PARKING SHED NEAR CSD COMPLEX BLDG NO T264 AT SRC AND PROVN OF OVER HEAD SHED ON MAIN STN GATE FOR GUARD VEH TRANSIT CHECKING AT STN HQ RAMGARH CANTT

Amount

Surface excavation not exceeding 30 cm deep and averaging 15cm deep and getting out in soft/ loose soil complete all as specified and directed.

Excavation in post holes (or similar holes) not exceeding 0.5 cum, getting out & removing surplus soil material to a distance not exceeding 50 mtr & making good surface complete all as specified & directed.

M&L for 100 mm thick plain cement concrete 1:4:8, type D-2 (using 40 mm graded crushed stone aggregate) as in sub base of flooring & mass concrete etc complete all as specified and directed.

M&L for plain cement concrete 1:4:8 ,type D-2 (using 40 mm graded crushed stone aggregate) as in foundations,filling & mass concrete for fencing posts, foundation of pole ,struts & stay assembly etc complete all as specified and directed.

M&L for plain cement concrete 1:3:6 ,type C-1 (using 20 mm graded crushed stone aggregate) as in foundations,filling & mass concrete for fencing posts, foundation of pole ,struts & stay assembly etc complete all as specified and directed.

M&L for 75 mm thick plain cement concrete 1:2:4, type B-2 (using 40 mm graded crushed stone aggregate) as in sub base of flooring & mass concrete etc complete all as specified and directed.

M&L for plain cement concrete 1:2:4, type B-1 (using 20 mm graded crushed stone aggregates) as in kerb /benching /copings /levelling course/window cill etc. including weathering,slightly rounded or chamfered angle and throating including use & waste of necessary form work etc complete all as specified and directed

M&L for fly ash Brick work with using sub class "B' bricks, straight or curved on plan exceeding 6m mean radius, built in cement mortar 1:4 etc complete all as specified & directed.

M&L for 15mm thick rendering on stone masonry surfaces or brick work or concrete surface in cement mortar 1:6, finishing surface even and smooth without using extra cement complete all as specified and directed.

M&L for preparation of newly plaster surface wall and applying two coats of cement base paint over a coat of alkali primer including necessary scaffolding complete all as specified & as directed.

Excavation in trenches in hard dense soil not exceeding 1.5 metre deep and not exceeding 1.5 mtr width and getting out soil including forming bottom surface to required slope /gradient for laying cables /pipes ,foundations, laying of cable,shafts, well,cesspits, manholes etc. complete all as specified and directed.

Returning, filling in including spreading, leveling, watering and well ramming in layers of not exceeding 25 cm thick after the cables & pipes etc. are laid, jointed & tested and foundations complete all as specified and directed by Engineer-in-Charge.

Removal of surplus excavated soil exceeding 250 Mtr but not exceeding 500 Mtr distance and depositing where directed by Engineer-in-Charge at a level not exceeding 1.5 m above the starting point complete all as specified.

S&F roof trusses (framed), post,trussed, purlins, crane gantries ,rail,rafter, heavy bracket framing (beam, tee, angle, channel or flat sections) distance pieces, cleats,fastening including fabrication and fixing conforming to Fe-410-W(Gde E-250) quality-A complete all as specified & directed. Note: Drawing & design shall be approved by GE.

M&L for prepartion of new or previously untreated steel surface of any description , not otherwise described over 10 cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified & directed.

S&F for pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/ cladding to wall, fixed with self tapping screws as specified and directed.

Demolition of plain cement concrete(un-reinforced ) in ground floors, terrazo tiles floor & paving not exceeding 15cm thickness (below or above ground level) and removal of rubbish off from site complete all as directed by Engr-in-Charge.

Demolition of brick work of any description and in any position built in cement or cement lime mortar including all quoins, arches, pillars including segregation of serviceable bricks for reuse & removal of rubbish out off from site etc complete all as specified and directed.

M&L for mild steel work as in wind tie for roof including securing bolts or weld, clamp, hold fasts, wall ties, plate washer & similar articles confirming to Fe-290 Gde-E-165 complete all as specified & directed

M&L for 80 mm thick factory made chamfered edge machine pressed pre-cast concrete coloured interlocking paver block of approved shade, laid in design & pattern as in footpath, light traffic parking etc, made by table vibratory method using PU mould of any shape and size conforming to IS-15658-2006 of M-35 grade laid over & including 50mm thick compacted bed over fine sand, compacting and proper embedding/ laying by vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.

S & F for 0.80 mm thick plain, galvanised, mild steel sheeting, in ridges,hips, valley gutters, drip and straight flashings (length and girth as fixed) with grade of zinc coating 275complete all as specified and directed.

S & F for 0.63 mm thick plain,black, mild steel sheeting, in ridges,hips, valley gutters, drip and straight flashings (length and girth as fixed) complete all as specified and directed.

S & F fo Pre-painted galvalume aluminum zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in ridge , fixed with self tapping screws complete all as specified & directed..

S & F 110 mm bore PVC(SWR) pipes single socketed, in any length with rubber ring joints, fixed on wall including PVC clamp properly with PCC 1:2:4 complete all as specified and directed

S & F PVC (SWR) bends for 110mm dia PVC pipes with rubber ring joints complete all as specified and directed.

M/s Kundu Enterprises (BID ID -3095133)

M/S SHAMBHU SHARAN SINGH (BID ID -3095629)

Modernage Constructions Pvt. Ltd. (BID ID -3095865)

upadhyay engineers and consultant (BID ID -3095835)

simplex infra project (BID ID -3095871)

M/s Ramgarh Raj Construction Pvt Ltd (BID ID -3095850)