Loading…
Loading…
Tender Value
₹71.1 L
EMD Value
₹72,000
Closing Date
1 Aug 2026, 4:00 pm7d left
Executive Engineer, High Court Electrical Division
Replacing old and unserviceable 04 nos. Lifts in category A Type Class- IV judicial Quarters (Block A & B) at Bodakdev, Ahmedabad.
325180
E-TENDER NOTICE NO : 3 OF 2026 -2027
Open
Electrical
Works
Ahmedabad
8 documents required · 8 mandatory
₹2,400
Executive Engineer, Highcourt Electrical (R AND B) Division, Ahmedabad
₹72,000
18 Jul 2026
18 Jul 2026
18 Jul 2026
1 Aug 2026
18 Jul 2026
Name of work:- Replacing old and unserviceable 04 nos. Lifts in Category A type Class-IV Judicial Quarters (Block A & B) at
Bodakdev, Ahmedabad.
Particular Approximately Qty Rate at which the materials will be Place of Delivery
charged in the contractor
Deputy Executive Engineer, Executive Engineer,
Signature of Contractor High Court Electrical Sub Dn No-1, High Court Electrical Division
Ahmedabad. Ahmedabad.
Name of work:-Replacing old and unserviceable 04 nos. Lifts in Category A type Class-IV Judicial Quarters (Block A & B) at Bodakdev, Ahmedabad.
Sr No Qty estimated but Item of work Tendered rates in word & figure Unit Total Amount
Sr No Qty estimated but Item of work Tendered rates in word & figure Unit Total Amount
may be more or less according to
1 4.00 Nos. Replacing old and unserviceable lifts by supplying, Erecting, Testing & Commissioning the 1716617.21 Rupees Seventeen Ea
passenger / stretcher lift having following main features: (A) GENERAL DESCRIPTION OF Lakh(s) Sixteen
LIFTS. [1] GEAR LESS LIFT DRIVE (MRL) comprising of High Starting torque Lift 3 phase Thousand Six
440 V A. C. Permanent Magnet Synchronous motor of proper rating with high efficiency shall be Hundred Seventeen
used. [2] Micro processor based / PLC, ACVVVF, vector control drive with encoder feedback And Paise Twenty
closed loop system shall be used for lift car and door operation which shall be full collective One Only
selective operation hall call demand response, UP/DOWN hall stops, Main, Up/ Down Contactor
with overload and phase reversal relay and safety controls. [3] Car with M S platform with
bracings of adequate size and to sustain the impact load cabin + passenger with safety factor of
fire for steel and side panels of Stainless steel of sheet of grade 304 duty. Car ceiling will be S.S.
finishes with aesthetic appearance with LED ceiling lights. Car flooring shall be of s/s 304 chaker
plate design sugeested of engineer in charge. of engineer in charge. Car doors shall be of stainless
steel grade 304, hairline finish with centre opening automatic doors. Car panel will also be S.S.
304 finished with emergency stop device, mechanical door safety device, facility of auto/ attended
All car panel buttons and all floor switches must be with brail language as per lift act.
[4] All landing doors must be fire rated for 2 hour shall be fully automatic centre opening made of
hairline finish steel grade of 304 with key holes and infrared curtains with Unlocking facility from
[5] Appropriate battery operated emergency light in the car along with alarm switch shall be
provided. Also, Emergency Light & Fan should start immediately without any Time Delay as soon
as power fails.
[6] Digital scrolling indicator system for up-down arrow along with floor position indicator shall
be provided inside the car and at all floors.
[7] Full height infra red curtain with multiple cross / crossing light beams shall be provided.
[8] Automatic Rescue Device (ARD) shall be provided accordingly of passenger capacity with
Manual Rescue Operation ( Manual Cranking Facility).
[9] Audio visual indication in the lift car showing over loading shall be provided such that doors
kept open till excess load is removed. [10] Spring buffers/PU Buffers shall be provided.
[11] Car fan as per passenger capacity with automatic sleep timer shall be provided.[12] Voice
annunciator with suitable music shall be provided in lift car.
[13] Self diagnostics system for operational and safety parameters shall be provided in control
[14] Mechanical over speed governor with governor calibration as per actual site parameters and
submission of calibration certificate submission, door key holes in the floor doors, fireman switch
shall be provided.
[15] Lift machine hoisting arrangement in the lift machine room and monkey ladder for lift pit
should be provided by the lift agency, along with the other steel structure works, foundations for
the machine etc…
[16] In the hoist way fascia plate shall be provided without any extra cost, where ever required as
/ if directed by engineer in charge.
[17] Permanent wiring with necessary safety devices like RCCB in all circuit, Over Voltage
Under Voltage protection and THD eliminator in circuit for lift machine room and lift well with
proper numbers of light points, with fixtures, exhaust fan and plug points shall be provided by the
agency. Only 3 phase Power Supply shall be made available by department in lift machine room.
Necessary Earthing as per Lift Act/Rules shall be arranged by Lift Agency.
[18] Any civil/ electrical works for additional and alteration in lift shaft and machine room related
to erection of lift shall be made by lift agency without any extra cost. (granite/marble fixing
around all landing door openings are not in lift agency’s scope.)
[19] Agency has to provide all working drawings and documents and liaison services for
obtaining all necessary permission from lift inspector and other authorities. [20] acrylic
transparent licence/display A4 size holder in lift car
[20A] As per statutory requirement of Govt. Of Gujarat lift & escalator act 2000, lift agency has
1. Car top safety barricade
2. Push & talk communication system.
3. Fireman's switch operation at Ground Floor.
4.carrying out third party lift inspection during/after lift erection and provide report by third
party authorized by concern licensing authority 5.agency has to provide third party insurance
upto completion of free maintenance period and submit the document for the same.
[21] Car Panel Operating Buttons with floor position indicator/buttons must be of Auto Glow type
clearly visible when view from inside cabin.
[22] For Physically Handicapped person Full Length Handrails of hairline finish steel grade of
304 should be provided at appropriate height on the Rear & Side Wall Panels in Lift Car. [23]
With Necessary KVA rating voltage controlled Stabilizer suitable for your controller, drive and all
equipments of lift.
[24] Necessary rating of DP Elcb and FP Elcb required for lift is in scope of work which rating is
sugested by CEICED Department (electrical Inspector) (B) SPECIAL FEATURES
DESCRIPTION OF LIFTS for PREMIUM category
1. Advanced control system dual 64 bit embedded microprocessor with CANBUS Serial
Communication mode including Regenerative power efficient operation,on site programming
facility, Anti nuisance, Pte-opening, BMS/RMS with necessary online real time monitoring
system having necessary connectivity for remote monitoring & other suitable supporting
hardware & software devices to fulfil the purpose.
2. Floor Indication LCD Display with call registration & brail mark with arrival gong and hall
lantern & TFT Screen in the car with MP3 Voice Announcer.
3. CAR Panel should be Scratch resistive SS Moonrock finish / Hair Line for car and all Doors,
All landing doors must have fire rating up to 2 hours and car door must have multi-level crisscross
beam door protection.
4. To & fro communication system & wiring (i.e. car , control room & guard room ) and Each
elevator are equipped with remote monitoring system.agency has to provide mobile app and user
id and password for monitoring
4/5/6 Passengers, Ground plus 9 upper floors with Rated Speed of 1.0 / 1.5 m/sec.,
(C) With General PLUS ADDITIONAL SPECIAL FEATURES attached herewith. Prem. Cat.
(Note :- As per SOR, Rs. 1,50,000.00 is decducted for machine room lift as and Rs.
80,000.00 is added for the Duplex control system.)
2 4.00 Nos. Replacing old, u/s SFU by providing and erecting Approved make Four pole moulded case circuit 6790.43 Rupees Six Thousand Ea.
breaker having breaking capacity ICU of 25 KA. at 415 V,having normal current rating up to 25 Seven Hundred
A to 100A. with Fixed thermal & magnetic release suitable to work on A.C. supply 50 c/s. with all Ninety And Paise
internal connections, spreader tinned copper & complete erected in 16 G.M.S. housing. Forty Three Only
ICS=100% of ICU only Cat III
3 232.00 Mtrs. Replacing old, u/s cable by providing and erecting XLPE(IS:7098)(I)-88 ISI armoured cable 676.70 Rupees Six Hundred Mtr.
multistrand Copper conductor for 1.1 KV. to be laid on wall with necessary clamps or in Seventy Six And
existing trench / pipe at road crossing or floor of following size of cables. (A) 4 core 10 Sq. mm Paise Seventy Only
4 8.00 Nos. Replacing old, u/s cable glands by providing and, fixing heavy duty flange type brass cable gland 38.38 Rupees Thirty Eight Ea.
with rubber ring for PVC insulated armoured cable complete with out going tails, insulating tape And Paise Thirty
etc for following size of cables. (C) 2 to 4 core 10 Sq. mm Eight Only
5 8 Nos. Supplying & erecting earth pit of minimum bore dia.150mm size approved make Earthing 4591.46 Rupees Thirty Eight Ea.
Electrode consisting Pipe-in-Pipe Technology as per IS 3043-1987 made of corrosion free hot And Paise Thirty
dipped G.I.Pipes having Outer pipe dia of 50mm having 80-200 Micron galvanising, Inner pipe Eight Only
dia of 25 mm having 200-250 Micron galvanising, connection terminal dia of 12mm with
constant ohmic value surrounded by highly conductive compound with high charge dissipation
suitable for following type of applications with chamber and heavy duty cover. (A)(approved
make OEM has to submit test certificate including value of earth resistance of installation duly
stamped and signed by agency and officer Incharge has to ensure the value of earthing resistane
mentioned in test Certificate) & having back filling compound of (B) Inner chemical (CCM
Compound)- Resistivity:- 0.2 ohm / meter testing as per IEC 62561-2017, Voltage drop:- < 1 volt
at no load & dry form, Sulphar content:- <2%(C) Back fill Compound :- Earthing compound
should be capable to retain moisture for long time Necessary test report must be submitted by
Agency. (a) For Electrical Installation up to 440V in normal soil
Length of pipe - 1 Mtr
Back filling compound - 1 Nos Bag of 15 Kg.
6 19.00 Kgs. Replacing old, rusted copper wire by providing and erecting Annealed bare Copper wire 8 to 12 794.87 Rupees Seven Kg.
SWG. Hundred Ninety Four
And Paise Eighty
7 80.00 Mtrs. Providing and erecting ISI mark Medium class RIGID PVC PIPES of following size complete to 33.33 Rupees Thirty Three Mtrs.
be erected on/in wall or ceiling erected with necessary PVC fittings & Junction boxes fixed with And Paise Thirty
adhesive solution & Clamps with following dia of pipes, in approved manner as directed (b) 25 Three Only
Rupees Seventy One Lakh(s) Five Thousand Four Hundred Thirty Two And Paise Sixty Two Only
A. Total Tender Amount Rs…………………
B. Rebate or above tendred amount (if any)_____ %
(In Figure) Rs…………………
C. Total (A - B) Rs…………………
D. Less Dismental (C - D) Rs…………………
E. Total (C - D) Rs…………………
1) All work shall be carried out as per Public Works Department Handbook and other specification of Division or as directed.
2) Rates quoted include clearance of site (prior commencement of work and at its close) in all respects and hold good for work under all conditions, site, moisture, weather etc.
3) I/We hereby declare that, I/ We have visited the site and fully acquainted myself / ourselves with the local situation regarding materials, & other factors pertaining to the work before submitting this tender.
4) I / We hereby declare that, I / We have carefully studied conditions of contract, specifications & other than tender documents of this work and agree to execute that same accordngly.
5)The rates shoud be inclusive of all taxes & levies.
6) The GST will be paid separately on the bills. Hence, it is the responsibility of the contractor to pay the G.S.T to the concerned Authority.
Deputy Executive Engineer, Executive Engineer,
Signature of Contractor High Court Electrical Sub Dn No-1, High Court Electrical Dn
Ahmedabad. Ahmedabad.
LIST OF D.M. Schedule
Name of work:-Replacing old and unserviceable 04 nos. Lifts in Category A type Class-IV
Judicial Quarters (Block A & B) at Bodakdev, Ahmedabad.
Sr no Item Qty Unit Rate As per T.S.
cost of old & u/s Groubd +9 floor -
6 passenger lift
2 cost of old & u/s 125A SFU 2 No.
cost of old & u/s 100A cu busbar
cost of old, u/s, rusted 4core
16sqmm copper cable
cost of old, u/s, rusted 4core
16sqmm aluminium cable
cost of old, u/s, rusted 2core
4sqmm aluminium cable
cost of old, u/s, rusted 4core
16sqmm copper cable
cost of old, u/s, rusted 4c*16sqm
cost of old, u/s, rusted 2 to 4core
4sqm cable gland
cost of old, u/s, rusted bare copper
Deputy Executive Engineer, Executive Engineer,
Signature of Contractor High Court Electrical Sub Dn No-1, High Court Electrical Dn
Ahmedabad. Ahmedabad.
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
RAW_HTML
G S T LTR.pdf
GR.pdf
Notice no. 3 of 2026-27 (English).pdf
Notice no. 3 of 2026-27 (gujarat).pdf
SBD - 04Lift 72quarter (3) (2).pdf
SCHEDULE A B AND DM.pdf
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at [email protected].