PROVN OF SECURITY LIGHTS TO LKT ROAD AT AF STN BHOWALI

Amount

Excavation in trenches not exceeding 1.5 Mtr wide and not exceeding 1.5 Mtr in depth for pole/stay foundation, laying of cables etc. and getting out in hard rock complete all as specified & directed.

Excavation in trenches not exceeding 1.5 Mtr wide and not exceeding 1.5 Mtr in depth for pole/stay foundation, laying of cables etc. and getting out in hard/dense soil complete all as specified & directed.

Excavation in trenches for each additional 1.5m or part additional 1.5m or part thereof in depth beyond the first 1.5 m for foundation, laying of cables etc . and getting out hard rock soil complete all as specified & directed.

Removing excavated material (soil) n.exc 50 mtr and depositing where directed at a level n. exc 1.5 mtr above the starting point complete all as specified & directed.

Returning, filling in including spreading, leveling, watering and well ramming in layers not exc. 25cm depth in soft/loose soil, complete all as specified and directed

Supply and spreading clean dry sand in trenches 15 cm below cable and 8 cm and punned after laying cable for cushioning complete all as specified & directed. (Note:- Punned thickness 18 cm shall be measured for payment)

M&L for laying of sub class 'B' brick common burnt clay building bricks, designation 75 complete for cable for protection complete all as specified and directed.

M&L for plain cement concrete 1:3:6 type C2 (40mm graded stone aggreagate) for foundation of poles, stay assembly, struts, etc. complete all as specified and as directed.

M&L for plain cement concrete 1:2:4 type B1 (20mm graded stone aggreagate) as in coping of poles including necessary form work complete all as specified and as directed.

M&L for plain cement concrete 1:4:8 type D2 (40mm graded stone aggreagate) as lean concrete,bed,concrete in foundation of pole etc,including form work(as required) complete all as specified and as directed.

M&L for Steel tubular swaged pole as specified 11 metre long type 410 SP-55 complete with cast iron base plate, finial taper plug, bolts, nuts & screws etc, including painting with two coats of aluminium paint over a coat of red oxide primer, marking of pole number 5 cm height with black synthetic enamel paint after Zebra marking from 30 cm above ground level upto 1.50 mtr height with alternate strip 20 cm wide of yellow/white/black paint, complete all as specified and directed.

M&L for Steel tubular swaged poles 9 metre long type 410 SP-31 complete with cast iron base plate, finial taper plug, bolts, nuts & screws etc. including painting with two coats of aluminium paint over a coat of red oxide primer, marking of pole number 5 cm height with black synthetic enamel paint after Zebra marking from 30 cm above ground level upto 1.50 mtr height with alternate strip 20 cm wide of yellow/white/black paint, complete all as specified and directed.

S&F bracket made of 32 mm bore pipe or suitable dia, light grade as required for fixing LED light fittings, bent to shape as in sleeving etc for bracket 1.2 Mtr length including FI 40x4 mm clamps with nut, bolt & washer etc., complete all as specified and directed.

Supply and fixing LED street light fitting 35/45 Watt 230 Volts AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection complete all as directed.

Supply and fixing LED street light fitting 70/75 Watt 230 volts AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection complete all as directed.

Supply and fixing LED street light fitting 90 Watt 230 volts AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection complete all as directed.

Supply and fixing LED street light fitting 100 Watt 230 volts AC outdoor type with high pressure die cast aluminum hosing and heat resistant complete with driver, lamp bracket with impact and corrosion resistant including thermal management in multiple optics complete with IP 65/66 protection complete all as directed.

Supply and fixing FRP juction box pole mounted IP-54 rated of size 350 X 250 X 138 mm depth powder coated with locking arrangement incuding three phase bus bar for RYBN with porcelain fuses 04 nos and 01 nos 6 Amp MCB SP mounted inside complete including clamps with nuts bolts & washers suitable for fixing with steel tubular pole 9/11mtr at manual height, complete all as specified and directed.

Supply and fixing flat twin core cable PVC insulated 1.5 Sqmm, PVC sheathed, multi-stranded, two core, copper cable through pole with all fixing accessories and connection from FRP box to street light connector fixed on steel tubular pole complete all as specified & directed.

Supply, laying and testing cable XLPE Insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty) 1100 Volts grade with stranded aluminium conductor of size 50 sq mm 3½ core, complete all as specified & directed.

M&L for earthing complete with galvanised steel earth plate electrode 600 x 600 x 6mm thick, burried directly in ground (earth pit not less then 2.25m deep bellow ground level) with top edge of the plate not less then 1.5m deep below normal ground level connected to galvanized iron earth wire of 4 mm dia earth lead by means of bolt, nuts, washers of galvanised steel earth strip protected by and including GI pipe 40 mm bore, light grade and conncted to main test point as directed and including concrete pit in PCC(1:3:6) type C-1 precast RCC(1:1.5:3) type A-1 cover slab 54 x 54 cm reinforced with 8 mm dia TMT bars @ 150 mm c/c both ways with one handle for lifting made out of 8mm dia TMT round bar embedded in precast cover slab funnel wire mens 20mm bore GI pipe (medium grade) for watering charcoal and salt in altemate layers, including necessary excavation and earth work in any type of soil complete all as shown on electrical plate No.3 of SSR part-I complete all as specified.

Supply, install, commissioning and testing cubical type LT panel board outdoor , manufactured by a CPRI approved factory, floor mounted, dust & vermin proof,front and rear operated door with necessary locking arrangement made of 50 x 6mm MS angle iron frame work and CRCA sheet of 3.15 mm thick duly painted with two coats of powder coated paint of approved shade after seven tank treatment process both internally and externally. The panel shall be suitable for 415 Volts, 50 HZ, 3 Phase 4 wire system and shall be complete with suitable capacity copper bus bar (1.5 times the incoming switch gear current rating) with suitable size of PVC insulated copper conductor, thimbles glands and complete all as specified and directed with the following accessories :-

Panel Board : 01 Nos

INCOMING: MCCB 3 pole, 415 Volts,63 Amps,16 KA - 01 No.

OUTGOING: (a) MCB 4 pole, 415 Volts, 16 Amps,10 KA -02 Nos (b) MCB 4 pole, 415 Volts, 16 Amps,10 KA -01 No (Spare-01 Nos)

Provision of suitable Space for fixing of automatic street light switch-1 Nos

Digital Multi functional meter (3 phase Ammeter,3 phase Volt Meter, PF and Frequency with CTs etc) ) - 01 Nos.

Indicator lamp (RYB) (set of three) - 01 Set

S&F automatic street light switch three phase maximum load 8-12 KW for automatic switching OFF street light at 30 Lux level and switching ON at 10 Lux of natural light the sensor alongwith suitable power contactors of rating 32 Amps per phase, MCB 40 Amps-03 Nos enclosed in pole/ wall mountable enclosure made of rust proof, electric shock proof, termite proof and FR grade enclosure conforming to IP-54. The contactors, MCBs and circuit wiring shall be suitable enough to take load of 25 KW equially distribution over three phase 415 volts AC supply, complete all as specified and directed. Make- Swadeep Model- 02EC-8 KW 3 Phase dual or equivalent in Legrand/ L&T/Crompton

M&L for earthing complete with galvanised steel earth plate electrode 600 x 600 x 6mm thick, burried directly in ground (earth pit not less then 2.25m deep bellow ground level) with top edge of the plate not less then 1.5m deep below normal ground level connected to galvanized iron earth strip of 32 x 6 mm earth lead by means of bolt, nuts, washers of galvanised steel earth strip protected by and including GI pipe 40mm dia bore (light grade) and conncted to main test point as directed and including concrete pit in PCC(1:3:6)type C-1 precast RCC(1:1.5:3) type A-1 cover slab 54 x 54 cm reinforced with 8 mm dia TMT bars @ 150 mm c/c both ways with one handle for lifting made out of 8mm dia TMT round bar embedded in precast cover slab funnel wire mens 20mm bore GI pipe (medium grade) for watering charcoal and salt in altemate layers, including necessary excavation and earth work in any type of soil complete all as shown on electrical plate No.3 of SSR part-I complete all as specified & directed.

M&L for cross arms, bracings, supports, clamps and back plates fabricated from structural steel sections, including nuts, bolts, washers, welding, bending cold or hot, drilling holes for bolts, in any shape or size as indicated or directed and inclusive of one primer coat (red oxide, zine chrome primer), one under coat and one finishing coat of aluminium paint including preparation of surfaces complete as specified and directed.

S&F 40 mm bore galvanised steel pipe, light grade, with all fittings and fixed complete to walls,parapets and ceiling or laid in floors/ PCC Foundation pillar for protection of LT cable, complete all as specified and directed.

S&F 15 mm bore galvanised steel pipe, light grade, with all fittings and fixed complete to walls, parapets and ceiling or laid in floors/ PCC foundation pillar for protection of LT cable, complete all as specified and directed.

M&L for DWC high density polyethylene pipes (HDPE) of 40 MM bore for protection of electric cable complete in all respect on wall/retaining wall/hills including drilling on retaining wall/hill etc, grouting of nut, bolt clamps and brick work to support pipe line as required at site, complete all as specified and as directed. Notes- :(a) Clamp should be made of MS sheet of size 50X6mm and 32X6 mm to be fitted on required length (not more than 1.5 Mtr) all as directed (b) Clamps, nut bolt & washers, MS angle/channels, brick work, PCC work for pipe line if required shall be measured and paid separately under relevent item .

Trimming of tree branches,cleanance of vegitation,wild grass creepers, etc in the route ( not less than 3 metre) to clear the approach of pipeline as required on site complete and disposed off from site complete all as specified & directed.

Vardhman Airport Solutions Private Limited

M/s J P Traders

kailu construction co

BHARAT ELECTRICAL TRADERS

Prem singh kuwarbi and co

R D Bansal

BD AGARWAL BUILDTECH INDIA PRIVATE LIMITED