MGF

Supplying of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorising glass beads @ 250gms with Reflectorising Glass Beads on Bituminous Surface at 250 gms per sqm area, thickness of2.5mm is exclusive of surface applied glass bead as per MORTH Section 803.4 and IRC: 35-2015, the materialshould satisfy the requirements as per MORTH specifications 803.4 and must comply with the following: a)White index for the product should be in the range of 60-70 when measured against standard reference. Theapplied panel 7/8 number must be submitted for checking up the white index in the department lab. In case thedepartment approves the white index of any vendor, the department engineer may carryout random checking ofthe applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consignment of the said material and willcompell the vendor has to replace the full consignment by the desired material as per approved panel at his owncost and additional demurrages may be claimed due to loss of man days (as per the rules of the department). b)Luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249. c) Crack resistance: The applied panel cured for 7 days under ambient condition and then should be testedas per BS3262, Part-1, 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade D)Adhesion : Strong E) Softening point: 102 degree centigrade F) Dried film finish : Smooth and uniform G) NightVision: High as directed by the Engineer-in-Charge and confirming to IS: 164-1961 (1st revision reaffirmed in1986) and clause conforming to IRC 35-2015 and MORTH Section 803.4.