Lifting and Lowering of Vertical turbine,Submersible Pump Motor assembly of DTW,HDTW installation under Chakdaha(A-I) Sub-Division and Rewinding and repairing of Submersible Motor of different capacities and make with repairing of Submersible Pump Bo

Withdrawal of electro motor submersible pumping set of following capacities from within the tubewell housing pipe of the following length by using all necessary requisites tools andplants and carefully as per direction of Engineer-in-Charge and stacking the same properly at site within the tubewell premises. (a) 100/150/200 cubic metre per hour capacity electro motor pumping set. (ii) Length of pump assembly of any length exceeding 18 metre length.

Installation of submersible electro motor pumping set of following capacities by using necessary requisite, tools and plants by lowering the same within the tubewell housing pipe upto the following depth as per direction by fitting, fixing column pipes and other accessories, fixtures with necessary nuts, bolts and washers and suspending the entire assembly of pump set vertically by fixing the same supported by M.S. clamps over the top of housing pipe, binding the motor cable with each column pipes and drawing cable upto pump controller/starter point including opening out of the top cap of housing pipe of the tubewell and testing of motor both in loading as well as in unloaded condition before and after installation of the same. (The rate is inclusive of hiring charges of tools & plants.) (a)100/150/200 cubic metre per hour capacity electro motor pumping set. (ii) Length of pump assembly of any length exceeding 18 metre.

Jointing water proof cable with the leads of the motor including soldering with requisite water proof insulation and proper jointing compound / Vulcanized rubber tape so that proper water proof insulation is assured.

(A)Transportation of Submersible Electro Motor Pumping set along with all other accessories and equipments including bend, sluice valve column pipes etc. from Sub-Divisional Store to worksite including loading at the lifting point and unloading at the delivery point including necessary head load upto 100 metre at both ends. (A). Carriage by road (a) Distance upto 50 km. (i) 100/150/200 cubic metre per hour (m3/hr) capacity electro motor pumping set with all other accessories etc.

(c) Supplying, fitting and fixing of (1/16)" thickness rubber insertion sheet with 12 nos. drilling hole for water tight arrangement of manhole cover.

Supply of Nut bolt in various size.

(k) Charges for repairing continuity test, insulation test by Megger, no load test as per directioin of Engineer-in-Charge

ADD GST @ 18% except Item no.-5 & 6

ADD LABOUR WELFARE CESS @1%